The progress of the reaction between Iodine ions and potassium iodate(V) can be followed by withstanding samples of the reaction mixture at various times, quenching and then titrating with standard thiosulphate solution. The reaction equation is: I(aq) + IO3(aq) + 6H+(aq) + 4e ➡ I2(aq) + 3H2O(l) In one such experiment the following data were obtained. (see figure

The progress of the reaction between Iodine ions and potassium iodate(V) can be followed by withstanding samples of the reaction mixture at various times, quenching and then titrating with standard thiosulphate solution. The reaction equation is: I(aq) + IO3(aq) + 6H+(aq) + 4e ➡ I2(aq) + 3H2O(l) In one such experiment the following data were obtained. (see figure

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter20: Kinetics

Section: Chapter Questions

Problem 20.38E: List at least four experimentally determined parameters that you, an experimenter, can define when...

See similar textbooks

Similar questions

For the reaction NH2SO2OH + H2O → NH4HSO4 In aqueous solution at 80.35oC, the following constants were observed at the indicated ionic strength μ x103 k (L/mol hr) 5.06 1.07 11.21 1.02 15.85 0.976 22.94 0.886 From these data ascertain: a.) the valence of the reacting ions and b.) the rate constant for the primary salt effect.
The composition of a liquid phase reaction 2A → B was monitored by aspectrophotometric method with the following results: t, s [B], mol/L 0 0 600 0.089 1200 0.153 1800 0.200 2400 0.230 ∞ 0.312 Identify the rate law, integrated rate law, and rate constant for thereaction based on the obtained data.
what is solution homogenous catalysis?
The viscosity of water at 20 oC is 1.0019 mN s m-2 and at 30 oC it is 0. 7982 mN s m-2 What is the activation energy for the motion of water molecules?
Suppose that the typical diffusion coefficient for a reactant in aqueous solution at 25 °C is 5.2 × 10−9 m2 s−1. If the critical reaction distance is 0.4 nm, what value is expected for the second-order rate constant for the diffusion-controlled reaction?
A typical diffusion constant for small molecules in aqueous solution at 25 °C is 6 × 10−9 m2 s−1. If the critical reaction distance is 0.5 nm, what value is expected for the second-order rate constant for a diffusion-controlled reaction?
In an experiment on the adsorption of oxygen on tungsten it was found that the same volume of oxygen was desorbed in 27 min at 1856 K and 2.0 min at 1978 K. What is the activation energy of desorption? How long would it take for the same amount to desorb at (i) 298 K, (ii) 3000 K?
What are the significance of the value of the slope, the value of the y-intercept, and the correlation coefficient to the determination of half-life?
Mention any two industrial applications of homogeneous catalysis
In the fluorination reaction of butadiene, the butadiene is adsorbed onto a catalyst C.To test the efficiency of the adsorption, the adsorption isotherm was determined.The volume of butadiene per gram of C varied as follows at constant temperature:p( kPa)- 13.3; 26.7 ; 40.0 ; 53.3 ; 66.7 ; 80.0V(cm3)-17.9 ; 33.0 ; 47.0 ; 60.8 ;75.3 ; 91.3At the temperature used, p* for butadiene is 200 kPa. Find a suitable isotherm for the data and determine Vmon. please assist.
a. Express the rate in terms of change of concentration of A with respect to time where 2A + B -> products, rate = k[A]-1. b. Give the derived integrated rate law.
Suppose it is known that ozone adsorbs on a certain surface in accord with a Langmuir isotherm. How could you use the pressure dependence of the fractional coverage to distinguish between adsorption (i) without dissociation, (ii) with dissociation into O + O2, (c) with dissociation into O + O + O?