The reaction 2 NO(8) + Cl2(8) → 2 NOCI(8) was per- formed and the following data were obtained under con- ditions of constant [Cl,]: (under conditions of constant [Cl2]) Time (a) Is the following mechanism consistent with the data? NO(8) + Cl2(8) = NOCI2(8) (fast) NOCI(8) + NO(8) → 2 NOCI(8) (slow) (b) Does the linear plot guarantee that the overall rate law is second order? (ONI/I

The reaction 2 NO(8) + Cl2(8) → 2 NOCI(8) was per- formed and the following data were obtained under con- ditions of constant [Cl,]: (under conditions of constant [Cl2]) Time (a) Is the following mechanism consistent with the data? NO(8) + Cl2(8) = NOCI2(8) (fast) NOCI(8) + NO(8) → 2 NOCI(8) (slow) (b) Does the linear plot guarantee that the overall rate law is second order? (ONI/I

Chemistry by OpenStax (2015-05-04)

1st Edition

ISBN:9781938168390

Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Chapter12: Kinetics

Section: Chapter Questions

Problem 41E: The reaction of compound A to give compounds C and D was found to be second-order in A . The rate...

See similar textbooks

Similar questions

The acid-catalyzed iodination of acetone CH3COCH3(aq) + I2(aq) CH3COCH2I(aq) + HI(aq) is a common laboratory experiment used in general chemistry courses to teach the method of initial rates. The reaction is followed spectrophotometrically by the disappearance of the color of iodine in the solution. The following data (J. P. Birk and D. L Walters, Journal of Chemical Education, Vol. 69, p. 585, 1992) were collected at 23 C for this reaction. Determine the rate law for this reaction.
For the past 10 years, the unsaturated hydrocarbon 1, 3-butadiene (CH2 = CH - CH = CH2) has ranked 38th among the top 50 industrial Chemicals. It is used primarily for the manufacture of synthetic rubber. An isomer exists also as cyclobutene: The isomerization of cyclobutene to butadiene is first-order and the rate constant has been measured as 2.0104s1 at 150 C in a 0.53-L ?ask. Determine the partial pressure of cyclobutene and its concentration after 30.0 minutes if an isomerization reaction is carried out at 150 C with an initial pressure of 55 torr.
Nitroglycerine is an extremely sensitive explosive. In a series of carefully controlled experiments, samples of the explosive were heated to 160 C and their first-order decomposition studied. Determine the average rate constants for each experiment using the following data: Initial [C3H5N3O9] (M) 4.88 3.52 2.29 1.81 5.33 4.05 2.95 1.72 t (s) 300 300 300 300 180 180 180 180 %Decomposed 52.0 52.9 53.2 53.9 34.6 35.9 36.0 35.4
11.48 The following data were collected for the decomposition of NT),-: Time, f (min) [N2Os] (mol L-1) 0 0.200 5 0.171 10 0.146 15 0.125 20 0.106 25 0.0909 30 0.0777 35 0.0664 40 0.0570 Use appropriate graphs to determine the rate constant for this reaction. Find the half-life of the reaction.
The plot below shows the number of collisions with a particular energy for two different temperatures. a. Which is greater, T2 or T1? How can you tell? b. What does this plot tell us about the temperature of the rate of a chemical reaction? Explain your answer.
The hydrolysis of the sugar sucrose to the sugars glucose and fructose, C12H22O11+H2OC6H12O6+C6H12O6 follows a first-order rate equation for the disappearance of sucrose: Rate =k[C12H22O11] (The products of the reaction, glucose and fructose, have the same molecular formulas but differ in the arrangement of the atoms in their molecules.) (a) In neutral solution, k=2.11011s1 at 27 C and 8.51011s1 at 37 C. Determine the activation energy, the frequency factor, and the rate constant for this equation at 47 C (assuming the kinetics remain consistent with the Arrhenius equation at this temperature). (b) When a solution of sucrose with an initial concentration of 0.150 M reaches equilibrium, the concentration of sucrose is 1.65107M . How long will it take the solution to reach equilibrium at 27 C in the absence of a catalyst? Because the concentration of sucrose at equilibrium is so low, assume that the reaction is irreversible. (c) Why does assuming that the reaction is irreversible simplify the calculation in pan (b)?
The reaction of compound A to give compounds C and D was found to be second-order in A . The rate constant for the reaction was determined to be 2.42 L/mol/s. If the initial concentration is 0.500 mol/L, what is the value of t1/2?
Explain why half-lives are not normally used to describe reactions other than first order.
11.64 HBr is oxidized in the following reaction: 4 HBr(g) + O2(g) —• 2 H2O(g) + 2 Br,(g) A proposed mechanism is HBr + O2 -* HOOBr (slow) HOOBr + HBr — 2 HOBr (fast) HOBr + HBr — H2O + Bn (fast) Show that this mechanism can account for the correct stoichiometry. Identify all intermediates in this mechanism. What is the molecularity of each elementary’ step? Write the rate expression for each elementary' step. Identify the rate-determining step.
What is the difference between average rate, initial rate, and instantaneous rate?
When formic acid is heated, it decomposes to hydrogen and carbon dioxide in a first-order decay: HCOOH(g)CO2(g)+H2(g) The rate of reaction is monitored by measuring the total pressure in the reaction container. Time (s) Pressure (torr) 0 220 50 324 100 379 150 408 200 423 250 431 300 435 Calculate the rate constant and half-life in seconds for the reaction. At the start of the reaction (time = 0), only formic acid is present. (HINT: Find the partial pressure of formic acid using Dalton's law of partial pressure and the reaction stoichiometry to find PHCOOH at each time.)
The rate of photodecomposition of the herbicide piclo- ram in aqueous systems was determined by exposure to sunlight for a number of days. One such experiment produced the following results. (Data from R.T. Hedlun and C.R. Youngson, “The Rates of Photodecomposition of Picloram in Aqueous Systems," Fate of Organic Pesticides in tbe Aquatic Environment, Advances in Chemistry Series, #111, American Chemical Society (1972), 159—172.) Exposure Time, t (days) [Pidoram] (mol L_1) 0 4.14 X 10-6 7 3.70 X 10-6 14 3.31 X 10-6 21 2.94 X 10~6 28 2.61 X 10~6 35 2.30 X 10-6 42 2.05 X 10-6 49 1.82 X 10"6 56 1.65 X 10-6 Determine the order of reaction, the rate constant, and the half-life for the photodecomposition of picloram.