The vapor pressure of 1-chlorotetradecane at several temperatures are tabulated below.     T (ºC)     P∗ mm Hg       98.5               1    131.8                 5    148.2             10    166.2             20    199.8             60    215.5            100 Use your graph in excel to fit the data using the appropriate curve type. Based on a fit of all the data, what is a better estimate for the value of the vapor pressure at 185ºC?

Q: Given the following information for benzene (CsH6): AHvap AHfus = 9.9 kJ/mol Specific heat (gas) =…

A: The question is based on the concept of Hess's law.   It states that the net enthalpy change during…

Q: Vapor pressure curves for CS2 (carbon disulfide) and CH3 NO2 (nitromethane) are drawn below. What…

A: Given: Temperature = 40oC

Q: Given the thermodynamic information below for ethylene glycol (molar mass = 62.068 g/mol): Normal…

A:

Q: 133 107 ethyl ether ethyl alcohol 80 53 water 27 ethylene glycol 20 40 60 80 100 120 Temperature…

A: Boiling point is the temperature at which vapor pressure of compound become equal to normal…

Q: 900 800 Carbon disulfide 700 600 Methanok 500 400 Ethanol 300 Heptane 200 100 10 20 30 40 50 60 70…

A: The vapor pressure of carbon disulfide is to be estimated from the given graph and the strength of…

Q: Properties Nitric oxide Density (kg/m3)  1.34 Boiling Point  (degree celcius)  -152 Freezing point…

A:

Q: S) Pentane, hexane, heptane and octane are some of the components of the petroleum (oil) that leaked…

A:

Q: The vapor pressures of benzene at different temperatures are as follows: P/mmHg T/Ce 75 118 181 269…

A: Given data:

Q: Substance X is known to exist at 1 atm in the solid, liquid, or vapor phase, depending on the…

A: The sample is below the melting point initially and thus, it is in solid state. Calculate needed to…

Q: 900 800 Carbon disulfide 700 600 Methanol 500 Ethanol 400 Heptane 300 200 100 0. 10 20 30 40 50 60…

A: The curve given is, Given: Vapour pressure of diethyl ether is 400 mm Hg at 18.0 oC.

Q: Given the thermodynamic information below for ethylene glycol (molar mass = 62.068 g/mol): Normal…

A:

Q: Vapor pressure (mm Hg) 900 800 700 600 500 400 300 200 100 0 Carbon disulfide, 10 20 30 Methanol 40…

A: Given,  The vapour pressure of chloroform is 400 mm Hg at 42°C.

Q: 900 800 Carbon disulfide 700 600 Methano 500 Ethanol 400 Heptane 300 200 100 10 20 30 40 50 60 70 80…

A: In this question, first we will see the temperature of carbon disulfide at which the pressure is…

Q: Sketch the phase diagram of the NH3/N2H4 given that these two compounds do not react with each…

A: eutectic melting point is the the point on the phase diagram where both species melts.

Q: 900 800 Carbon disulfide 700 600 Methanol 500 Ethanol 400 Heptane 300 200 100 0. 10 20 30 40 50 60…

A:

Q: For a given species, see the thermodynamic values below. Boiling Point: Melting Point: Heat of…

A: The quantity of heat energy absorbed or released in a chemical reaction can be calculated using the…

Q: Please just indicate if it's True or False. a. When placed in a glass capillary tube, H2O will form…

A: a. When placed in a glass capillary tube, H2O will form a concave meniscus. The given statement is…

Q: Propane has a normal boiling point of -42.04 °C and a heat of vaporization of 24.54 kJ/mole. What is…

A: Given,The normal boiling point of propane = -42°CThe heat of vapourisation, ΔHvap = 19.04…

Q: 900 800- Carbon disulfide 700 600 Methanol 500 Ethanol 400 Heptane 300 200 100 10 20 30 40 50 60 70…

A: We can locate the position of vapor pressure and corresponding temperature on graph to find…

Q: A cylinder containing ethanol is submitted to a certain pressure. At a temperature of 273 K, when…

A: Colligative properties are dependent on the number of moles of solute in the solution. There are…

Q: Substance X is known to exist at 1 atm in the solid, liquid, or vapor phase, depending on the…

A: Answer: During the phase transition of a crystalline substance, temperature remains constant until…

Q: Polymer PXX has a glass transition temperature of 49°C. Describe the viscoelastic behaviour of the…

A: Glass transition temperature(Tg) It is the temperature at which a polymer coverts into its soft form…

Q: vapor pressure of dichloromethane was measured as a tion of temperature, and the following results…

A: Here we have to determine enthalpy of vaporisation of CHCl3 from the following given data.

Q: Pressure (atm). 73.0 5.11 1 Ferie Solid -78.5 -56.4 Liquid Temperature (°C) 31.1 Supercritical fluid…

A: Triple point of a substance is that particular temperature and pressure in which three…

Q: Look at this data for the Vapor Pressure vs Temperature of octane. What is the heat of vaporization…

A:

Q: Naphthalene melts at 353 K. The vapor pressure of the liquid is 9329.0 Pa at 407 K and 28,638 Pa at…

A: The delta H fussion of the reaction is calculated as,

Q: The following table gives several important points on the pressure-temperature diagram of ammonia: P…

A: The data given is,

Q: Methylhydrazine Chemical Formula CH,N2 Molar Mass 46.07 g/mol Standard boiling point (T°%) AH°vap at…

A:

Q: The temperature dependence of the vapor pressure is given by the equation: ΔΗp Inp = In A – RT…

A: The relation of p with T is given by the above equation. Write the expression of the given equation.…

Q: The following graph was prepared using measured vapor pressures (in torr) above liquid HNO3 at…

A: Given : y = -4636.5x + 19.678

Q: Given the thermodynamic information below for ethylene glycol (molar mass = 62.068 g/mol): Normal…

A: Initially at 25.0°C , ethylene glycol is in liquid state . So first step would be heating of liquid…

Q: The standard enthalpy of vaporization (H°vap) of diethylether ((CH3CH2)2O) is 29.1 kJ/mol. The…

A: This question asks us to find the vapour pressure of diethyl ether at T=19°C when we have the data…

Q: 5. Using the trendline on the graph, calculate the enthalpy of vaporization (AHvap) of water. ( R =…

A: According to the clausius clapeyron equation, => ln(P) = -ΔHvapR1T + C where P = pressure  ΔHvap…

Q: 11. The vapor pressures of solid and liquid chlorine in the vicinity of the triple point are given…

A: Tt is Triple Point

Q: Use the below heating curve for compound ZYX to determine the specific heat capacity of the liquid.…

A:

Q: The following graph was prepared using measured vapor pressures (in torr) above liquid HNO3 at…

A: From the Clausis-Clapeyron equation, the graph of ln P vs 1/T gives a straight line with the slope…

Q: (a) Temperature dependence of the vapor pressure of ethylene log p (mm Hg) = - 834.13 / T + 1.75 log…

A: a)To derive the equation for the temperature dependence of the molar enthalpy of vaporization b) To…

Q: The vapor pressure of 1-chlorotetradecane at several temperatures are tabulated below.     T (ºC)…

A:

Q: The following graph was prepared using measured vapor pressures (in torr) above liquid HNO3 at…

A: The ln(Pvap) v/s 1/T curve given is,

Q: The standard enthalpy of vaporization (AH°vap) of trans-crotononitrile (CH3(CH)2CN) is 38.8 kJ/mol.…

A:

Q: The vapor pressures of solid Cl2 are 352 Pa at -112 C and 35 Pa at -126.5°C. The vapor pressure of…

A: Given data:  Sublimation Pressure P1 = 35 Pa ; Sublimation Pressure P2 = 352 Pa Temperature T1 =…

Q: Strongest IMF type Rank boiling point from highest (1) to lowest (3) Rank melting point from highes-…

A: Since you have posted a question with multiple subparts, we will solve first three subparts for you.…

Q: a part of Cengage Learning (e) the viscosity of isopropyl alcohol and glycerol (CH2OHCHOHCH,OH) (d)…

A: Boiling point is the point at which vapour pressure of liquid is equal to atmospheric pressure.

Q: Vapor pressure data are given here for octane, C8H18 . Use the Clausius–Clapeyron equation to…

A: Given: We have to calculate molar enthalpy of vaporization.

Q: Place the three compounds in order of increasing intermolecular force strength. Pressure (mm Hg)…

A:

Q: Determine the amount of heat, in kJ, required to heat 100.0 g of liquid Ca at 851C to 951C. Melting…

A:

Q: Sam knows that he has one of 3 possible liquid unknowns: tetrahyrofuran (bp 65-67°C), ethyl acetate…

A: First mistake he has done is not to observe the temperature change using thermometer. Instead he was…

Q: Compare the TWO structures represented below: H-S-H 01510 Molecule A Molecule B a. Molecule A has a…

A:

Crystal Structures

Solids are present all around us. They have different properties and applications. Diamond and graphite are two well-known solids. Diamond is the hardest material in the world and is used in making jewelry. Graphite on the other hand is soft. The lead of your pencil is graphite. Why are they so different in appearance and properties despite the fact they are chemically the same? Both are allotropes of carbon. The answer lies in the structure, the way constituent particles are arranged in the solids.