Two generating units are online and have the following characteristics: U;(Gas Fired) F1($/day) = 200 + 20 × P +0.006 × P²100MW < P < 900MW U;(Coal Fired) Q2(tons/day) = 100 + 2 × P2 + 0.001 × P 100MW < P, < 700MW Unit 1 is operating normally while unit 2 is operating under a take-or-pay fuel contract. If the total load is 800 MW for a period of one week (7 days), and for y = 7.5$/ton, , the quantity consumed unit 2 in one week is: Select one: O a. 1471.6 tons O b. 10301.2 tons O c. None of these O d. 8830 tons Clear my choice

Two generating units are online and have the following characteristics: U;(Gas Fired) F1($/day) = 200 + 20 × P +0.006 × P²100MW < P < 900MW U;(Coal Fired) Q2(tons/day) = 100 + 2 × P2 + 0.001 × P 100MW < P, < 700MW Unit 1 is operating normally while unit 2 is operating under a take-or-pay fuel contract. If the total load is 800 MW for a period of one week (7 days), and for y = 7.5$/ton, , the quantity consumed unit 2 in one week is: Select one: O a. 1471.6 tons O b. 10301.2 tons O c. None of these O d. 8830 tons Clear my choice

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10P: For the circuit element of Problem 2.3, calculate (a) the instantaneous power absorbed, (b) the real...

See similar textbooks

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
A generating station has a maximum demand of 30,000 kW. Calculate the cost per unit generated from the following data: Capital cost = P 130M; Annual load factor = 50%; Annual cost of fuel and oil = P7.5M ; Taxes, wages and salaries etc. = P7M and Interest and depreciation = 12%
A generating station has a maximum demand of 25,000 kW. Calculate the cost per unit generatedfrom the following data: Capital cost = P 120M; Annual load factor = 45%; Annual cost of fuel and oil = P6.5M ; Taxes, wagesand salaries etc. = P6M and Interest and depreciation = 13%
A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the following data: Annual load factor = 35% Capital cost = Rs 12,50,000 Annual cost of fuel and oil = Rs 8,00,000 Taxes, wages and salaries = Rs 7,00,000 Interest and depreciation = 10%
The tariff in force is Rs 150 per kVA of maximum demand and 8 paise per unit consumed. If the load factor is 30%, find the overall cost per unit at (i) unity p. f. and (ii) 0.85 p. f.
Consider a Pumped storage micro-hydel plant is to be built as a Peak load-plant on above mentioned Nathiya-Galli Water Fall with available head of 39 m and average discharge of 5640 m³/hour from the upper pound. The hydraulic efficiency and electrical efficiency of the plant to be 0.86 & 0.92 respectively. Analyze the following output from the above Pumped Storage Plant: a. Hydro-Power and Annual Hydro-energy available b. Electrical Power and annual electrical energy units that can be generated from the plant.
Borduria Generation owns three generating units that have the following cost functions: Unit A: 15 + 1.4 PA + 0.04 P2 A $/h Unit B: 25 + 1.6 PB + 0.05 P2 B $/h Unit C: 20 + 1.8 PC + 0.02 P2 C $/h How should these units be dispatched if Borduria Generation must supply a load of 350 MW at minimum cost?
If for example communication power is often normalized by assuming R to be a unity in Ohms, although R may be another value in actual circuit. If the actual value of the power is required, it is worked out by de-normalization of the normalized value. Use the above to determine the instantaneous power, given time interval to be (-4,4) and x = 2 + t2.
. A system consists of two plants connected by a tie and a load is located at plant two. When 100MW are transmitted from plant one a loss of 10MW takes place on the T-line . Determine the generating schedule at both the plant and the power received by the load when λ for the system is GHC 25 per megawatt hour and the incremental fuel cost are given by the equation dF1dP1=0.031P1 + 17 GHC/ MWh ; dF2dP2=0.06P2 + 19 GHC/MWh
The maximum demand of a power station is 110 MW. It generates 105 x 10 units during the day. The station has three units of 40 MW and another unit of 40 MW as spare. The running hours of the unit are as follows. The first unit of 40 MW runs for 24 hours. Another unit of 40 MW runs for 14 hours. A third unit of 40 MW runs for 4 hours. So Find (1) daily load factor (2) plant capacity factor (3) utilization factor and (4) plant use factor.
Which of the following statements about next-generation wind energy is correct? a. They will have a lower capacity factor than current wind energy. b. Offshore wind energy will be much cheaper than onshore. c. Offshore wind has the potential for a higher capacity factor than onshore installations. d. Integrating offshore wind into existing grid infrastructure is easier than for onshore energy
A high-voltage direct-current generating station delivers power to a city. The generator output voltage is V0 = 400 kV, the city is represented by resistance RL = 3918 ohms, and each wire of the transmission line round-trip between the station and city is represented by resistance RTL = 151 ohms. How much power (in mega watt) is lost along the transmission wire?