volume off the filter flask is total of 35 ml of solution sC as is (250-35) + 215ML. sho extra volume of gas forced ause of your average tempe

Q: Can I get some help doing these? If I can see one example done I could do the rest

A:

Q: How many replicate measurements are needed to decrease the 95 and 99% confidence limits for the…

A:

Q: Q1. A 100 g soil containing 20% smectitie mineral matter was mixed with 150 mL solution containing…

A:

Q: what is the biggest buret size that'll deliver 4.8mL with a relative error less than or equal to…

A: Answer - According to the question - Given  - volume need to be delivered is 4.8 mL with an accuracy…

Q: ghs 68 kg is 45 years old and has severe hypomagnesaemia. m sulfate heptahydrate to be given…

A: According to the question, Jack who weighs 68 kg is 45 years old and has severe hypomagnesaemia. He…

Q: Volumetric pipettes are designed to deliver a very precise amount of liquid, but only if you O a.…

A: Volumetric pipette is used to measure exact amount of a solution. Volumetric pipettes are always…

Q: Give other 5 examples of laboratory task stating its potential hazard and recommended PPE.

A: Five examples of laboratory hazards, 1. Fire/Explosions In a research facility, all synthetic…

Q: الاسبوع القادم Prepare 0.8 N of H2SO4 Specific gravity=(1.84 gm/cm3), assay(40%) in 100 ml D.W. if…

A: Normality of solution = 0.8 N

Q: choade the correct option for (a) and (16) and explain why it's carrect? 2) The Salid impurities…

A: Filtration is a process used to either isolate an organic solid or eliminate solid contaminants from…

Q: A ceric sulfate solution that was standardized using 200 mg of arsenic trioxide (MW = 197.84g/n)…

A:

Q: If V = 125ml at 755 mm Hg, find V (ml) at 780 mm Hg (temp, n = count)

A: At constant temperature T and no . of  moles n , the ideal gas equation becomes:  P1V1 = P2V2

Q: and

A: Given data set; Mass of empty flask = 351.74 g Mass of heated flask = 354.40 g Molar mass of acetone…

Q: The column was packed with 12 g of alumina. A 50:50 mixture of ferrocene and acetylferrocene was…

A: The experiment is about analyzing a mixture of ferrocene and acetylferrocene, quantitatively.

Q: ost suitable non-ferrous metals and allog rtant characteristics required for the said cryogenic…

A: i) The non ferrous metal which is used for storage of cryogenic liquids are silver, copper, gold and…

Q: 1. Standardization of approximately 0.025 M KMNO4 Data Table Experimental Vol of vol of KMNO4 (ml)…

A: The balanced ionic reaction between C2O42- and MnO4- is as follows: According to the balanced…

Q: scribe the preparation of 150 mL of 6.00 M H3PO4 f at is 86% H3PO4 (w/w) and has the specific…

A: Given data set: Volume of H3PO4 = 150 ml Molarity of H3PO4 = 6.00 M Specific gravity= 1.71 W/w% =…

Q: at ass of w

A:

Q: v Show Time Remaining ▼ A 0.45 M KBr solution OA contains 0.45 milliliters of KBr in 1 liter of the…

A: Molarity is defined as the number of moles of solute in 1 Liter of  the solution. Molarity of…

Q: The column was packed with 12 g of alumina. A 50:50 mixture of ferrocene and acetylferrocene was…

A: Total mass of the mixture of (ferrocene + acetylferrocene) = 0.102 g

Q: "A cylindrical tank contains 2 liquids with differeht density. Assuming the container is full and is…

A:

Q: Mass Na CO3 Vi HC1,mL 0.00 0.10 Vf HC1,mL 36.75 Trial VHC) used, ml MHCI 1 0.2135 0.2025 0.2112…

A: Since you have asked a question with multiple sub-parts, as per our company guidelines we are…

Q: 1-m diameter and 1 fluid whose density me of the fluid in ft3. s of the fluid in Ibm:

A: Given diameter of cylinder = 1m  Height = 1.6m  Density = 850kg/m³  We have to find volume in ft³,…

Q: DThree milligrams of Haldol m urit, are ordered for Haldol is available in 2mL ampoules that Corrt…

A: A numerical problem based on solution, which is to be accomplished.

Q: 1-4 ture @ 26.1°C, 24.6g of camphor (LiothG0), a nunvolatile solid, is dissohved in The of benzene…

A:

Q: Standardization of Sodium Thiosulfate Solution Primary Standard used: Potassium Dichromate…

A: The formula of potassium dichromate is K2Cr2O7

Q: d. 200 mL of 5.00% (w/v) aqueous BaCl2 from a 0.300 M BaCl2 solution. e. 2.00 L of 0.500 M HCIO,…

A:

Q: High pressure liquid chromatography (HPLC) is a method used in chemistry and biochemistry to purity…

A:

Q: a stock solu in 1.600 pg/mL. Two possible methods of dilution are stated below. For each method,…

A:

Q: 5) SpectroPhoto meter device for meesuring Sample (2,4,6,81o pPm) at absapant cool,o.020-030.040.05)…

A: The absorbance vs concentration curve is drawn below.

Q: etention volumes are 6ml and 7mL, respectively. The dead volume of the column used is 1n

A:

Q: Q1. A 100 g soil containing 20% smectitie mineral matter was mixed with 150 ml solution containing…

A: Assume that the cation exchange capacity of soil is entirely because of the smectitie mineral…

Q: Part A. Write the balanced equation for the reaction that produced the gas in this reaction Trial 1…

A: Given: Partial pressure of water at 23 oC = 21.1 mmHg = 0.0277 atm

Q: False A volumetric pipet should 'not be "blown out" to eject all liquid at the tip. Volumetric…

A: A volumetric pipet should not be "blown out" to eject all liquid at the tip. Volumetric pipets are…

Q: If the first 1 mL distillate is not removed, there will be a/an. in the purity and. yield. O a.…

A: 2). In the distillation process initial, some drops or some amount of distillate is removed because…

Q: Average AG°= 43,42 AH°= . AS°= (Note: the slope of the best fit line is equal to -AS° rather than…

A: Given data:

Q: Determine the % error of a 25.00ml pipette when dooter provided reports that when used a times, the…

A: % error =( |Actual value - Expected Value| / Expected Value ) * 100

Q: The TD marking on a volumetric pipet stands for temperature dependent O t ime distinct O to deliver…

A: Given that : We have to identify which of the following stands for the TD marking on  a volumetric…

Q: describe two ways for preparing 10 mL of 1 M solution from a 10M stock solution in regards to…

A: The concentration of a solution is measured in molarity, that is, number of moles of solute in per…

Q: Coming homo after the end of the winter semostor, you find that your family's swimming pool has not…

A: Solution - According to the question - Given - take whole swimming pool as a control volume. given…

Q: Volumetric pipettes are designed to deliver a precise amount of liquid, but only if you a. submerge…

A: A multiple choice question based on handling of pipette, which is to be accomplished.

Q: be administered at a rate of 75 gtts/min using a microdrip set that delivers 60 gtt/mL. How long in…

A: Given: Flow rate       = 75 gtts/min Drop factor   = 60 gtts/mL Total volume = 250 mL

Q: Complete the following table: Subst. weighed Subst. sought Grav. Factor 1.AgCI NaCl 2.Baso, SO3…

A: The gravimetric factor is the ratio between the grams of a compound and the grams of a single…

Q: Density of solution: Trial 1: 1.2 g/mL Trial 2: 1.2 g/mL Trial 3: 1.2 g/mL Average density = 1.2…

A: