What adsorbents are typically used in TLC? On a TLC, a compound traveled 3.5 cm when the solvent front traveled 10.8 cm. Determine the Rf of the compound. For polar stationary phases, which has the greater eluting power: dichloromethane or ethyl acetate? Explain.

What adsorbents are typically used in TLC? On a TLC, a compound traveled 3.5 cm when the solvent front traveled 10.8 cm. Determine the Rf of the compound. For polar stationary phases, which has the greater eluting power: dichloromethane or ethyl acetate? Explain.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.26QAP

See similar textbooks

Related questions

Q: Why are some of the detectors listed unsuitable for HPLC?

A: HPLC is applicable for the use with solvent that has UV absorbance. A UV detector cannot be used…

Q: 3. The working charge of a four foot adsorption bed is 32.0%. The MTZ and heel were determined to be…

Q: Describe the sample properties that would be suitable for; i) Gas chromatography (GC) analysis ii)…

A: GS and HPLC are the techniques to separate compounds from mixtures .These are nalytical methods of…

Q: 1. List three criteria that is important to consider when choosing a solvent for recrystallization…

A: Since you have asked multiple questions we will answer the first one for you. To get the remaining…

Q: kindly prepare an assignment on Application of HPLC in Drug Analysis: one page show name of the…

A: In high-performance liquid chromatography (HPLC) we inject the sample, which is in solution form,…

Q: What is the difference between absorption and adsorption?

A: Absorption:It is the process by which atoms or molecules or ions enter into a bulk phase such as…

Q: Which statement is true? Statement 1: In a paper chromatography that uses a cellulose-based…

A: Given : Two statements are given To find : True statements Solution : Chromatography is a…

Q: In reversed phase HPLC, how will the retention time of a component of a mixture vary with the…

A: Retention time is a measure of the time that is taken by a solute to pass through a column.In…

Q: When setting up a column, what is the reason for adding a layer of sand on top of the adsorbent…

A: Column chromatography is a technique that separates substances based on differential adsorption of…

Q: In TLC, why does the developing solvent 3:1:1 n-butanol/acetic acid/water climb up the TLC plate so…

A: Thin-layer chromatography (TLC)-It is a technique used for the separation of a mixture of volatile…

Q: 10. Consider the following compounds when answering the questions below. Assume these compounds can…

Q: Which statement is true? Statement 1: Since tiny amounts of material are exposed on an open…

A: The answer of the above question is given in step 2

Q: Coprecipitation that involves foreign particles? a. Inclusion b. Mechanical entrapment c. Surface…

A: Co-precipitation :– The concurrent precipitation of more than one compound from an solution.…

Q: from one of our neigboring countries are heavily contaminated with pesticides. Upon analysis, some…

A: WORKING OF SOLID PHASE MICROEXTRACTION :

Q: 1. Define sparging. What is the significance of this step in an HPLC analysis?

Q: Name 3 adsorbents used in TLC. Mention their use and properties. Why is it important to use a…

A: 3 adsorbents used in TLC - 1. Silica gel : Silica gel is by far the most widely used adsorbent and…

Q: Which of the following cannot be used as adsorbent in column Chromatography? a) Magnesium oxide b)…

A: The adsorbent is the stationary phase in column chromatography and fills the glass column. The…

Q: Calculate the Rf value for a spot in a TLC experiment if the solvent moved 14.5 cm and the spot…

Q: Differentiate between gel filtration and gel permeation chromatography.

A: Given : We have to tell what is the difference between gel filtration and gel permeation method.

Q: 1.An organic compound is made and needs separating from the reaction mixture and impurities. The…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: For the TLCS shown below, both plates have the exact same materials spotted on each lane (that is,…

A: Thin layer chromatography.

Q: Explain the term gradient elution mode in HPLC

A: Given : We have to tell about gradient elution term .

Q: Which of the following statements is not true? A. In TLC, the relative intensity of the spots is not…

Q: In TLC, why does a 3:1:1 ratio of the developing solvent of n-butanol/acetic acid/water move up the…

A: The strength of interactions between adsorbent and adsorbate depends upon the type of interactions…

Q: 3. Find the molar absorptivity Concentration Measured coefficient, the R? assuming that the path…

A: To find out molar absorptivity, first draw the graph for given data and then solve all the questions…

Q: 18. Semi-permanent adsorption of polar analytes will cause: severe tailing of the peaks…

A: Gas chromatography (GC) is basically an analytical technique which can be used for the separation of…

Q: Why are some of the detectors listed unsuitable for HPLC? Which of the GC detectors ) in the table…

A: The function of detectors used in high-performance liquid chromatography is to monitor the mobile…

Q: Question attached

Q: Write four factors that will influence the adsorption capacity?

A: Adsorption is a surface phenomenon that occurs when a gas or liquid solute accumulates on the…

Q: 1. The properties that must be possessed by the adsorption reagent in air sampling are… a. Reagents…

A: Air sampling is the process by which the type and quantity of airborne contaminants present in an…

Q: Measurement of adsorption of 40 mL of solution containing Hg by atomic absorption spectrometer…

A: Measurement of adsorption of 40 mL of solution containing Hg by atomic absorption Spectrometer…

Q: You will run a TLC plate after the CC placing in one spot the original sample of pigments, one spot…

A: Thin Layer chromatography (TLC) TLC is a chromatographic technique used to separate mixtures of…

Q: From the experiment in Question 1, the following data were obtained: 2. Distance traveled by spot O…

Q: Explain why TLC cannot be used for some volatile low molecular weight substances such as toluene.

A: Thin layer chromatography, a thin layer is pressed over the chromatographic plate. A drop or small…

Q: Which of the following are the three main factors affecting the rate of movement of a compound on a…

A: When a compound is converted into its vapor form and the pressure exerted by its vapor is known as…

Q: Calculate the Rf value for a spot in a TLC experiment if the solvent moved 13.5 cm and the spot…

Q: You have a concentrated sample solution of a new wine from a winery to analyze for malic acid…

A: A common relation for the absorbance recorded is, A=εclA=Absorbanceε=Molar absorptivity…

Q: Different from GCMS, why is an interface needed when coupling HPLC with MS?

A: In addition to the liquid chromatography and mass spectrometry devices, an LC-MS system contains an…

Q: TLC was used to compare the solubility of two compounds A and B in a solvent system (acetic acid,…

Q: w Solid, unknown acid were contaminated with pure, adsorbed water prior to weighing out the Sample,…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: a) Thin layer chromatography (TLC) and high performance liquid chromatography (HPLC) can be used as…

A: The solution of the question is given below:

Q: What type of materials can be used as the stationary phase for column chromatography? O Inorganic…

Q: 1. In the chromatography plate there are three solutes that move forward: 2cm, 2.5cm and 3cm Which…

Q: A student spots an unknown sample on a TLC plate and develops it in dichloromethane solvent. Only…

A: TLC is thin-layer chromatography which involves distribution of a solid sample by solid-liquid…

Q: (5) A colored solution of a substance that obeys Beer's law, showed a transmittance of 80% when…

A: A/Q to the beer lamberts law, we know the equation : A =ε × b × C = -log T…

Question

Need help with these practice problem.

What adsorbents are typically used in TLC?
On a TLC, a compound traveled 3.5 cm when the
solvent front traveled 10.8 cm. Determine the Rf of
the compound.
For polar stationary phases, which has the greater
eluting power: dichloromethane or ethyl acetate?
Explain.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What effect does molecular size have on the adsorption process?
Effect of dose on adsorption percentage of cadmium onto magnetite (pH 7; adsorbent dose = 0.05, 0.1, 0.5, 0.10, 0.15 g; initial concentration 100 ppm, T = 25°C, 150 rpm, Contact Time = 2 h) performed with ASS instrument. What is the optimal dosage?
Why are adsorbate particles attracted and retained on the surface ofadsorbent?
which of the folowing(s) is/are true ? 1 split ratio in GC is a ratio of sample passed to column to amount of mobile phashe 2 column resolution decreases with increasing column lenght 3 decreasing the tube diameter ,increases the resolution
Different from GCMS, why is an interface needed when coupling HPLC with MS?
kindly answer this problem and follow this format GIVEN REQUIRED SOLUTION and write regibly thank you so much For the adsorption of a substance A from aqueous solution by charcoal at25oC the freundlich constants are n=3.0 and k=0.50 for y in grams per gramand C in grams per liter. What weight of a W is adsorbed by 2 g of charcoalfrom 1 L of a solution containing originally 2 g of the substance?
Q1) Describe in detail Process of Adsorption, its types and Industrial application.
1. Define sparging. What is the significance of this step in an HPLC analysis? 2. What are the two types of pre-column? What is the purpose of each type? 3. What are the two types of packing used in HPLC column? Describe each type. Please answer numbers 1-3. Need asap
a) Thin layer chromatography (TLC) and high performance liquid chromatography (HPLC) can be used as examples to explain difference between adsorption and partition. For each of these chromatographic techniques, identify: + the stationary and mobile phase + how the mobile phase moves b) How is the Rf value for a spot on a TLC plate calculated? What can the Rf value be used for? In order to achieve the best separation of several components of different polarity in a mixture spotted on a TLC plate, what guideline should one follow regarding the choice of a developing solvent? (i.e. polar, non-polar, etc.)
A student performs a separation by TLC on a silica gel platee that results in three spots. A red spot is measured 23 mm away from the original sample spot, a blue spot is 42 mm away, and a yellow spot is 49 mm away. the distance from the original spot to where the solvent stopped is 55 mm. a) calculate the Rf value for each componenet in the mixture (show work and report th correct number of significant figures) b) the silica gel plate is polar. rank the three componenets in the mixture from lowest to highest polarity. Explain your answer.
Find out the atomic form factor of the C in diamond (400) diffraction peak using Cu Kα1 radiation! How about the atomic form factor of the (400) diffraction peak for Ge crystal using Cu Kα1 radiation! Needs Complete typed solution with 100 % accuracy.
What is laser ablation and how can it he used to sample solids for ICPMS?