Answered: What do electronically controlled…

What do electronically controlled systems use to control the primary ignition circuit? NPN transistor photoelectric sensor knock sensor engine coolant sensor

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter22: Basics Of Electronics And Computer Systems

Section: Chapter Questions

Problem 9ASRQ: While diagnosing an electronic control system: Technician A turns the ignition off before...

See similar textbooks

Related questions

Q: The oil level sensor use the ... technic for * operation.

A: Oil level sensors: A oil level sensor works on the principle of buoyancy.

Q: The firing lines on an oscilloscope pattern are all abnormally low. Technician A says that the…

A: Solution:

Q: List all the control modes for both engine crank and engine warmup.

Q: What are the advantages and disadvantages of the engine lubrication

A: The lubrication system's job is to provide oil to moving parts in order to minimise friction…

Q: On an engine management syste with feedback control from an oxygen sensor why may a missing engine…

A: Given Engine management system To find Importance of thermostat in closed loop operation

Q: Technician A says that the oxygen sensor provides the major input during the open-loop mode.…

A: Explanation: The closed-loop and open-loop refer to the mode of operation of engines that are…

Q: 1: List the safety mechanisms that contrast medium injection devices are equipped with. 2: What…

A: 1. Safety mechanisms that contrast medium injection devices are equipped with- The function…

Q: 1 Before conducting a __________ test, disable the ignition and the __________ injection system.…

A: Compression test Compression test is the test for the engine to check the condition of the parts of…

Q: Explain the steps involved in disconnecting a fuel line on a vehicle Multi port direct injection…

A: 1.Let the engine cool down; Most direct injection vehicles have aluminum cylinder heads and…

Q: What affects the efficiency of a catalytic converter?

A: The converter has a proficiency rating that is figured by the vehicle. This number rates the…

Q: While discussing EFI systems: Technician A says that the PCM provides the proper air-fuel ratio by…

A: The PCM chooses the air-fuel proportion by admiring the look-into tables enlisted in its memory. The…

Q: The throttle opening is electronically controlled; the position When the throttle is fully open,…

A: Given Engine setup To find Role of Air filter Air temperature sensor Intake manifold (tumbler) valve…

Q: What does a slope in the spark line represent? a. Low secondary resistance b. High resistance…

A: The spark plug is an important element of SI engines to burn the air-fuel mixture (Petrol-Air). It…

Q: Emission control systems are installed on engines to reduce what three specific exhaust products?…

A: Emission control system is used to control the discharge of harmful gases from the engine. The are…

Q: 3- In the event of a malfunction in the engine temperature sensor, how will it affect the operation…

A: Given :- In the event of a malfunction in the engine temperature sensor, how will it affect the…

Q: Because modern engines heat up rapidly heated oxygen sensor (ho2s) are not required. True False

A: Given data:- Because modern engines heat up rapidly heated oxygen sensor (ho2s) are not required.…

Q: The dieseling is O a. the engine is still working without ignition. O b. Engine use diesel as fuel O…

A: To find: The dieseling is

Q: d. Check oil level & moisture content 19. If the main wire (coil) to the distributor and the coil to…

A: 19. if the main wire (coil) to the distributor and the coil to the switch are broken , replace them…

Q: Below figure is an air-cooling system for the battery pack. Is this an Active or Passive air-cooling…

A: Generally, there are 2 types of air-cooling systems, i.e., active and passive. Active air-cooling…

Q: What is a method of post-combustion control? EVAP Air injector EGR PCV

A: A method of post-combustion control is

Q: Technician A says that an air-conditioning system removes heat from inside the engine. Technician B…

A: Technician A says that an air-conditioning system removes heat from inside the engine. Technician B…

Q: In a single-cylinder, two-stroke petrol engine, the charge ( fuel-air mixture ) enters the cylinder…

A: Two stroke engine: A two-stroke engine is a type of IC engine which completes one power cycle with…

Q: Explain the principle of operation of the ICEs fuel supply system.

A: In essence, the system is "ready" moment the tank is filled with gasoline. The fuel pump begins the…

Q: Which is not a cause of detonation? Wrong ignition timing Allowing the engine to overheat Fuel/air…

Q: While discussing electronic fuel injection principles: Technician A says that the PCM always adjusts…

A: By analyzing the discussion about electronic fuel injection principles…

Q: 5- In the event of a malfunction in the incoming air temperature sensor, what is its effect on the…

A: Question number 4 found to be incomplete or missing. Solving question no 5 Incoming air…

Q: While discussing the MIL on OBD II systems: Technician A says that the MIL will flash if the PCM…

A: Check Engine light (also known as "Malfunction Indicator Lamp" or MIL) is supposed to alert the…

Q: What are the 4 ancillary systems of a marine propulsion system? * Steering Gear System…

A: given; What are the 4 ancillary systems of a marine propulsion system? * 1.teering Gear System…

Q: Excessive oxygen in the exhaust indicates an improper air/fuel mixture.

A: Excess oxygen in the exhaust demonstrates an inability to accomplish that objective and is for the…

Q: 4- Explain the operation of the Common-Rail fuel injection system?

A: A common rail fuel injection system is a fuel injection system in which two or more than two high…

Q: Increasing engine speed will decrease the engine knocking tendency because: Select one: O a…

A: Given: To select the correct option.

Q: The catalyst monitor test may fail for all of these reasons, except ________. a. defective upstream…

Q: the goverment mandated warranty that specifically covers the catalytic converter and engine control…

A: the goverment mandated warranty that specifically covers the catalytic converter and engine control…

Q: Technician A says there is less heat energy in high octane gasoline and, therefore less power is…

A: Technician A says there is less heat energy in high octane gasoline and, therefore less power…

Q: The FRL and compressor is used as energy source which excludes exhaust also in the pneumatic system…

A: Solution:

Q: The required gap in ignition system between---- O -0.4 to 5 O .-4 to 5 O 0.4 to 0.5 O .-4 to 0.5 O…

A: Required gap in ignition system in automobile generally 0.6 to 1.8 mm. M15 is used for high…

Q: What is the wet bulb temperature of the indoor air that is being recirculated

A: Given: Recirculated air at indoor space conditions DBT =75 degree F RH =50% To determine: For this…

Q: what is the purpose of having two accelerator pedal signals in an electronic throttle control system

A: The accelerator pedal signals are used to control the throttle valves in an electronic throttle…

Q: True or False? The diesel fuel’s antiknock quality ismeasured by the cetane rating

Q: Di ignition systems are capable of producing higher electrical energy than the DIS ignit

A: given: Di ignition systems are capable of producing higher electrical energy than the DIS ignition…

Q: Technician A says that the PCV system is designed tolimit CO emissions. Technician B says that…

A: The PCV valve regulates emissions by rerouting gases generated by the crankcase back into the…

Q: vapor lock is caused by fuel that does not vaporize easily in hot weather. T F

A: Given :- vapour lock is caused by fuel that does not vaporize easily no hot weather. True or False

Q: Which type of fuel injection system has the fuel pressure regulator located in the fuel tank? a.…

A: The purpose of pressure regulator is to maintain the specified fuel system pressure and to send the…

Q: Which of the following is not a Gen2 plasma ignition system? O Dual frequency drive O Capacitive…

A: ignition system: The ignition system create an electric spark in the engine combustion chamber,…

Q: Which of the following is a control that relates directly to vacuum controlled EGR systems??…

A: PORTED VACCUM SWITCH IS A CONTROL THAT relates directly to vacuum controlled EGR systems as No…

Q: Q156. which of the following components can cause execcively high pressure in a returnless fuel…

Q: ke air flow rate rific value of fuel ine cooling water flow rate

A: Dynamometer torque =132 NmFuel consumption=12kg/hIntake air flow rate =168kg/hcalorific…

Q: How do most electronic ignition systems differ? number of spark plugs the use of CMP and…

Q: ECU collects and processes signals from O various engine sensors. controls the fuel level in the…

A: ECU - Engine control unit. It is basically electronic circuits which collects the input from various…

Q: respect to ignition

A: 1. S. I. Engine ( Spark ignition engine) works on otto cycle as C. I. Engine ( compression ignition…

Question

What do electronically controlled systems use to control the primary ignition circuit?

	NPN transistor
	photoelectric sensor
	knock sensor
	engine coolant sensor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is the least likely cause of a no-start condition? Faulty CKP sensor Faulty KS Fuel or ignition system faults Faulty PCM wiring
While discussing ignition timing control in EI systems: Technician A says that when the engine coolant temperature is low, the timing is retarded until normal operating temperature is reached. Technician B says that the PCM will retard the timing during EGR operation. Who is correct? Technician Ac.Both A and B b. Technician B d. Neither A nor B
How do most electronic ignition systems differ? number of spark plugs the use of CMP and CKP sensors number of transistors the use of a distributor
True or False? The spark plug wire is eliminated in all coil-per-cylinder ignition systems to reduce maintenance and the chances of EMI and RFI.
While discussing ignition systems: Technician A says that an ignition system must supply high-voltage surges to the spark plugs. Technician B says that the system must maintain the spark long enough to burn all of the air-fuel mixture in the cylinder. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor B
True or False? The neutral safety switch and reverse lamp switch are typically part of a digital transmission range sensor.
Explain how the computer controls the air-fuel ratio on an EFI system.
On an engine management syste with feedback control from an oxygen sensor why may a missing engine thermostat prevent closed loop operation
Which of the following systems is designed to reduce NOX? VVT EVAP PCV AIR
Technician A says that the PCV system is designed tolimit CO emissions. Technician B says that catalyticconverters reduce HC emissions at the tailpipe. Whois correct?a. Technician Ab. Technician Bc. Both A and Bd. Neither A nor B
Technician A says there is less heat energy in high octane gasoline and, therefore less power is genorated during combustion. Technician B says usung a higher octane gasoline than required will not produce more power inless the engine has a knock sensor that allows the system to adjust ignition timing to take advantage of the higher octane. who is correct?
True or False? All turn signal flasher units contain a temperature-sensitive bimetallic strip and a heating element.