When the three identical star-connected coils are supplied with 400 V, 50 Hz, 3-phase supply, the 1-phase wattmeter whose current coil is connected in line R and pressure coil across the phase Rand neutral reads 6 kW and the ammeter connected in R-phase reads 30 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load, (ii) resistance and reactance of the coil (iii) reactive power of 3-phase load and (iv) Apparent Power Power Factor, of the Load Reactance Resistance Reactive Power Apparent Power

When the three identical star-connected coils are supplied with 400 V, 50 Hz, 3-phase supply, the 1-phase wattmeter whose current coil is connected in line R and pressure coil across the phase Rand neutral reads 6 kW and the ammeter connected in R-phase reads 30 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load, (ii) resistance and reactance of the coil (iii) reactive power of 3-phase load and (iv) Apparent Power Power Factor, of the Load Reactance Resistance Reactive Power Apparent Power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.53P

See similar textbooks

Similar questions

When the three identical star-connected coils are supplied with 415 V, 50 Hz, 3- p supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 12 kW and the ammeter connected in R-phase reads 26 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- p load and (iv) Apparent Power
When the three identical star-connected coils are supplied with 400 V, 50 Hz, 3- φ supply, the 1- φ wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 8 kW and the ammeter connected in R-phase reads 36 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- φ load and (iv) Apparent Power
When the three identical star-connected coils are supplied with 435 V, 50 Hz, 3- φ supply, the 1- φ wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 4 kW and the ammeter connected in R-phase reads 24 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- φ load and (iv) Apparent Power 1-Power Factor, of the Load? 2- Reactance? 3- Resistance? 4- Reactive Power? 5- Apparent Power? A 405 volts, 3phase AC motor has a power output of 12 HP and operates at a power factor of 0.9 lagging and with an efficiency of 91 %. If the motor is star connected, determine the reading on each of the two wattmeter connected to measure the input.? a? b? Three identical capacitors of 20 micro farad are connected in star across a 435 volts, 50Hz, 3-phase supply. What value of capacitance must be connected in delta to take the same line current and line…
A 210V, 50 Hz, single phase radial distribution system, the resistance of the wire is 0.0008 ohm/m supply and return. Two loads are connected and it consumes 10 and 10 A respectively and are fed from the cable at distance of 15 and 15 respectively. Calculate the voltage available across load 1 and 2
A 210V, 50 Hz, single phase radial distribution system, the resistance of the wire is 0.0008 ohm/m supply and return. Two loads are connected and it consumes 20 and 15 A respectively and are fed from the cable at distance of 25 and 10 respectively. Calculate the voltage available across load 1 and 2. a- Voltage across load A is, Va= b- Voltage across load B is, Vb=
Given a 400sq.m single family dwelling unit to be provided with 230V, 1-phase, 2-wire be service, andhaving the following loads: 2-1.5hp A/C, 2-1.0hp A/C, 1-0.5hp water pump, 4-800W water heater, 2-6kWelectric range and 2-1kW microwave oven, determine a) the total connected load, b) the total demand load,c) the overall %demand factor, d) the size of THW feeder conductor, ground wire and IMC conduit, e) therating of feeder overcurrent protection using inverse time circuit breaker
An electrical motor is supplied from a three-phase ,50 Hz, 410 V system on-board a LNG carrier .When connected in star , it takes a line current of 35 A at a power factor of 0.66 leading. The LNG carrier arrives at port and the motor is subsequently used for powering a container crane It is now connected in delta and is supplied on-shore .Determine for this motor when it takes 64 A at 310 V, from the on-shore supply: 2.1 The power factor of the motor 2.2 the frequency of the supply The motor is returned back to its initial supply and now connected with a new motor in parallel . The new motor is connected in delta and it takes 48.216 kVA at a power factor of 0.77597 lagging with a supply of 50 Hz, 410 V system. Determine for this new arrangement : 2.3 The power factor 2.4 Apparent power taken 2.5 True power taken 2.6 Reactive power taken
A single phase a. C distributor AB 300mts long if fed from end A is loaded as under a) 100amps at 0.707 p.f lagging 200mts from pointA(b) 200amps at 0.8p.f lagging 300mts from point A. The total resistance and the Reactance and the distributor is0. 2ohms and0. 1ohms per km respectively. Calculate the total voltage drop in the distributor. The load power factors refer to the voltage at the far end
A single-phase circuit is placed across a 120-Vrms, 60-Hz source, with an ammeter, a voltmeter, and awattmeter connected. The instruments indicate 12 A,120 V, and 800W, respectively. Finda. The power factor.b. The phase angle.c. The impedance.d. The resistance.
In the circuit of figure shown in the next slide, three impedances are 12 – j10 ohms, 10 + j20 ohms, and 15 + j0 ohms, connected between conductors a, b, c and the neutral “n” of a balanced 230 volts, 60 hertz, 3 phase, 4 wire, ABC system. Using Van as the reference vector, determine:a. Current in each impedanceb. Neutral current Inc. Readings of wattmeters W1, W2, & W3d. Power in each impedance
A 100KVA, 220V, a star-connected alternator is loaded at full load and at 60% pf lagging.The effective AC resistance per phase is 0.01411Ω. If the synchronous reactance is 4.5times the effect of the armature leakage reactance wherein the later is 0.046 Ω perphase, find(a) the phase voltage that would be generated at the load if the circuit were operating normally(b) What no-load open-circuit phase voltage must be present in order to circulate full-load current in short-circuit state while maintaining the same speed and field current?(c) What is the terminal phase voltage of the alternator when it is under a shorted load condition? Give an explanation in support of your response using just one sentence. The IA phasor should be used as the reference one.
A 20 kVA, 220 V, wye-connected, 3-phase salient-pole generator supplied load at 0.707 pf lagging. The reactances per phase are Xd = 2 ohms, Xq = 4 ohms and resistance is negligible. Find the %VR at the above load.