Concept explainers
1.89 Imagine that you place a cork measuring
Interpretation:
Write down the steps to determine the combination of the cork and lead cube that will still float in the water.
Concept introduction:
Answer to Problem 1.89PAE
Weight of system < maximum possible buoyant force
The system will float otherwise sink
Buoyant force
Solution
If above relation is valid then cork and lead system will float otherwise sink
Information required:
- Density of cork
- Density of lead
- Density of water
Volume of cork
Volume of lead
Explanation of Solution
If weight of cork
Weight of cork
Weight of lead
Maximum buoyant force
If maximum buoyant force is greater than weight of cork
System float only when.
To find this value you have to find out density of cork and lead.
If density of lead and cork are known then you can find out lead
Want to see more full solutions like this?
Chapter 1 Solutions
Bundle: Chemistry for Engineering Students, Loose-Leaf Version, 4th + OWLv2 with MindTap Reader with Student Solutions Manual, 1 term (6 months) Printed Access Card
- 1-85 In Japan, high-speed “bullet trains” move with an average speed of 220. km./h. If Dallas and Los Angeles were connected by such a train, how long would it take to travel nonstop between these cities (a distance of 1490. miles)?arrow_forward1-89 Consider butter, density 0.860 g/mL, and sand, density 2.28 g/mL. (a) If 1.00 mL of butter is thoroughly mixed with 1.00 mL of sand, what is the density of the mixture? (b) What would be the density of the mixture if 1.00 g of the same butter were mixed with 1.00 g of the same sand?arrow_forward1-98 The antifreeze-coolant compound used in cars does not have the same density as water. Would a hydrometer be useful for measuring the amount of antifreeze in the cooling system?arrow_forward
- 1-76 If the density of air is 1.25 10-3 g/cc, what is the mass in kilograms of the air in a room that is 5.3 m long, 4.2 m wide, and 2.0 m high?arrow_forwardA sample of a bright blue mineral was weighed in air, then weighed again while suspended in water. An object is buoyed up by the mass of the fluid displaced by the object. In air, the mineral weighed 7.35 g; in water, it weighed 5.40 g. The densities of air and water are 1.205 g/L and 0.9982 g/cm3, respectively. What is the density of the mineral?arrow_forwardA sample of vermilion-colored mineral was weighed in air, then weighed again while suspended in water. An object is buoyed up by the mass of the fluid displaced by the object. In air, the mineral weighed 18.49 g; in water, it weighed 16.21 g. The densities of air and water are 1.205 g/L and 0.9982 g/cm3, respectively. What is the density of the mineral?arrow_forward
- 1-51 A nurse practitioner orders isotonic sodium lactate 50. mL/kg body mass to be administered intravenously for a 139-lb patient with severe acidosis. The rate of flow is 150 gtts/min, and the IV administration set delivers 20. gtts/mL, where the unit “gtts” stands for drops of liquid. What is the running time in minutes?arrow_forwardA solution is prepared by dissolving table salt, sodium chloride, in water at room temperature. a Assuming there is no significant change in the volume of water during the preparation of the solution, how would the density of the solution compare to that of pure water? b If you were to boil the solution for several minutes and then allow it to cool to room temperature, how would the density of the solution compare to the density in part a? c If you took the solution prepared in part a and added more water, how would this affect the density of the solution?arrow_forward1-31 In the SI system, the second is the base unit of time. We talk about atomic events that occur in picoseconds (10-12 s) or even in femtoseconds (10-15 s). But we don’t talk about megaseconds or kiloseconds; the old standards of minutes, hours, and days prevail. How many minutes and hours are 20. kiloseconds?arrow_forward
- The following are properties of substances. Decide whether each is a physical property or a chemical property. a Chlorine gas liquefies at 35C under normal pressure. b Hydrogen burns in chlorine gas. c Bromine melts at 7.2C. d Lithium is a soft, silvery-colored metal. e Iron rusts in an atmosphere of moist air.arrow_forwardObtain the difference in volume between two spheres, one of radius 5.61 cm, the other of radius 5.85 cm. The volume V of a sphere is (4/3) r3, where r is the radius. Give the result to the correct number of significant figures.arrow_forwardThe density of a solution of sulfuric acid is 1.285 g/cm3, and it is 38.08% acid by mass. Calculate the volume of the acid solution (in mL) you need to supply 125 g of sulfuric acid.arrow_forward
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningIntroduction to General, Organic and BiochemistryChemistryISBN:9781285869759Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar TorresPublisher:Cengage Learning
- Chemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning