Principles Of Foundation Engineering 9e
9th Edition
ISBN: 9781337705035
Author: Das, Braja M.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Question
Chapter 10, Problem 10.4P
To determine
Find the allowable net pressure using Equation 9.51 and 10.14.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
The attached figure shows the plan of rectangular foundation which transmits a uniform contact pressure of 120 kN/m2. The width of the foundation is 15 m.
A) Determine the increase in vertical pressure at a depth of 10 m below point A
B) The vertical stress at a depth of 10m below point B
A footing of size 2m x 2m transferring a pressure
of 200 kN/m2, is placed at depth of 1.5 m below
the ground as shown in the figure (not drawn to
the scale). The clay stratum is normally
consolidated. The clay has specific gravity of 2.65
and compression index of 0.3.
200 kN/m?
1.5 m
GWT
Ya = 15 kN/m
18 kN/m
elemiu
1 m
Silty Sand
Ysat =
10.5 m
1.5 m
Clay
Yat = 17 kN/m
Dense Sand
Consideration 2:1 (vertical to horizontal) method
of load distribution and yw
primary consolidation settlement (in mm, round
off to two decimal places) of the clay stratum is
10kN/m, the
A footing of size 2m×2m transferring a
pressure of 200 kN/m², is placed at a
depth of 1.5 m below the ground as
shown in the figure (not drawn to the
scale). The clay stratum is normally
consolidated. The clay has specific
gravity of 2.65 and compression index
of 0.3.
1.5m
1m
1.5 m
200 kN/m²
Silty sand
Clay
Ya =15kN/m³
Y sat = 18kN/m³
Y sat = 17 kN/m³
GWT
$0.5 m
Dense sand
Considering 2:1 (vertical to horizontal)
method of load distribution and
Y₁ = 10kN/m³, the primary consolida-
tion settlement (in mm, round off to two
decimal places) of the clay stratum is
Chapter 10 Solutions
Principles Of Foundation Engineering 9e
Ch. 10 - Refer to the rectangular combined footing in...Ch. 10 - Prob. 10.2PCh. 10 - Prob. 10.3PCh. 10 - Prob. 10.4PCh. 10 - Prob. 10.5PCh. 10 - Prob. 10.6PCh. 10 - Prob. 10.7PCh. 10 - Prob. 10.8PCh. 10 - A plate loading test was carried out on a medium...Ch. 10 - A 300 mm 450 mm plate was used in carrying out a...
Knowledge Booster
Similar questions
- Q3. Two meters of compacted fill (y= 20 kN/m³) is placed over a large area (Figure 4). A rectangular foundation of size 4 m x 5 m is constructed at the site with its base located at the existing ground surface. GWT is found at a depth of 3 m below the existing ground surface. a). Calculate and plot the in-situ vertical effective stress profile to a depth of 16 m below the existing ground surface prior to fill and footing placement. Use points with z = +2, +1, 0, -1, -2, -3, -5, -10, -13, -16 m (with z measured from the existing ground surface). b). Calculate and plot the additional effective stress due to the fill to a depth of 16 m. Use the same points as in part a). c). If the load applied on the foundation is 4 MN, calculate and plot the effective stress increase due to the footing to a depth of 16 m. Use the 2:1 approximate method and the same points as in part a). Summarize your calculations in an Excel spreadsheet and present sample calculations for z = 0, -3, -10 and -16 m (with…arrow_forwardThe plan of a rectangular foundation shown in figure transmits a uniform contact pressure of 120 kN/m². Determine the vertical stress induced by this loading at point B under a depth of 5 m. (40 marks) 25.0- 15.0 6.0- 4.0 B•arrow_forward(b) Figure Q2 (b) shows the ring foundation to support a silo. Given R1 = 3 m while R2 =6 m. The total vertical load is 7500 kN. (i) Calculate and plot the vertical stress increase with depth up to 7 m (use 1 minterval) under the centre of the ring (point O).(ii) Determine the maximum vertical stress increase and its location.arrow_forward
- A rectangular footing (4.89 x 4.38 m.) is placed 1.21 m. below the ground surface. The soil arrangement is composed of sand (ground) for the first 6.52 meters and followed by clay for the next 6.98 meters. The force acting on the footing is 10,293 kN. Determine the resulting stress increase at the midheight of the consolidating layer in kPa. Assume a 2V:1H pressure diagram. Unit weight of sand = 16.1 kN/m3. Unit weight of clay = 18.7 kN/m3. Use stored value. Answer in five decimal places.arrow_forwardCalculate the settlement of the 10-ft-thick clay layer that will result from the load carried by a 5-ft-square footing. The clay is normally consolidated. Use the 2:1 method to calculate the average increase of effective pressure in the clay layer. 10 ft 10 ft 10 ft 5 ft ↓ Dry sand Footing size 5 ft x 5ft Sand Clay Ydry = 100 pcf Groundwater table Ysat = 120 pcf Ysat = 110 pcf % = 1.0 LL=40arrow_forwardThe plan of a flexiblerectangular loaded area is shown with a uniformly distributed load q =100 KN/m2. Determine the increasein the vertical stress (A6z) at Z= 2.0 meters bel ow (a) Point A = (b) Point B= (c) Point C= 4 m 1.6 m- 2 m 0.8 m q = 100 kN/m? C 1.2 m-arrow_forward
- A 1.8 m square, 2 m deep and 1 m high footing supports a column load of 570 kN. It is supported on a clayey sand. There is no water present at the site. Use unit weight for the concrete 24 kN/m³. A dilatometer test run at the site has returned the following constrained modulus profile: Depth (m) M (MPa) 2 7.7 3 8.8 4 5 10.2 14.8 6 15.4 Plot the modulus distribution with depth considering both the strain distribution with depth and the soil moduli, and divide soil into 5 layers, then determine the average modulus for each soil layer.arrow_forward2 m 3 m 3 m 1 m 5. Refer to Prob. 3. Determine the vertical stress at a depth of 2.5 m below point E in Fig. Prob. 3. All the other data given in Prob. 3 remain the same. 6. A rectangular footing 6x3 m carries a uniform pressure of 300 KN/m2 on the surface of of a soil mass. Determine the vertical stress at a depth of 4.5 m below the surface on the center line 1.0 m inside the long edge of the foundation. 7. A tower is founded on a circular ring type foundation. The width of the ring is 4 m and its internal radius is 8m. Assuming the distributed load per unit area as 300 KN/m2, determine the vertical pressure at a depth of 6 m below the center of the foundation. The footing is founded at a depth of 2.5m below the ground surface. 8. The L-shaped area shown in figures carries a 96KN/m2 uniform load. Find the vertical increment due to the structure load at a depth of 8m below comers A and E. Sm 4m 6.5m 4m E- 9. The plan of a rectangular loaded area is shown in the figure. The uniformly…arrow_forwardThe soil profile at a road construction site is as shown in figure (not to scale). A large embankment is to be constructed at the site. The ground water table (GWT) is located at the surface of the clay layers, and the capillary rise in the sandy soil is negligible. The effective stress at the middle of the clay layer after the application of the embankment loading is 180 kN/m². Take unit weight of water, Yw = 9.81 kN/m3. Embankment load boudi Sand GWT 2m y = 18.5 kN° it enit Clay Specific gravity, G̟ = 2.65 Water content, w = 45% Compession index, C. = 0.25 6m %3D %3D Impermeable layer The primary consolidation settlement (in m, round off to two decimal places) of the clay layer resulting from this loading will bearrow_forward
- 3. Point A lies in a clayey sand layer with $' = 38, c'= 10 kPa, and K, = 0.5. The ground surface is flat. A planned construction operation will cause the vertical effective stress at point A to reach 80 kPa. a. Use a compass to draw the expected MC for point A (after construction) on the space shown on the right. b. Will point A reach failure? Explain your answer with one sentence.arrow_forwardA rectangular footing 6 x 3 m carries a uniform pressure of 300 kN/m2 on the surface of a soil mass. Determine the vertical stress at a depth of 4.5 m below the surface on the center line 1.0 m inside the long edge of the foundation.arrow_forwardA loaded footing ABCD with q = 200 kN/m2 on the ground is shown in Figure 8.19. Compute Ao, under Points E, F, B, and G at a depth of 5 m. 3 m 2 m q = 200 kN/m? 2 m A F Вarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Foundation Engineering (MindTap Cou...Civil EngineeringISBN:9781337705028Author:Braja M. Das, Nagaratnam SivakuganPublisher:Cengage Learning
Principles of Foundation Engineering (MindTap Cou...
Civil Engineering
ISBN:9781337705028
Author:Braja M. Das, Nagaratnam Sivakugan
Publisher:Cengage Learning