A large spool of rope rolls on the ground with the end of the rope lying on the top edge of the spool. A person grabs the end of the rope and walks a distance l, holding onto it, Fig. 10–62. The spool rolls behind the person without slipping. What length of rope unwinds from the spool? How far does the spool’s center of mass move?
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
Modified Mastering Physics without Pearson eText-- Instant Access -- for Physics for Scientists & Engineers with Modern Physics
Additional Science Textbook Solutions
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
The Cosmic Perspective Fundamentals (2nd Edition)
Physics: Principles with Applications
College Physics: A Strategic Approach (4th Edition)
Conceptual Integrated Science
Tutorials in Introductory Physics
- Repeat Example 10.15 in which the stick is free to have translational motion as well as rotational motion.arrow_forwardIf the torque acting on a particle about an axis through a certain origin is zero, what can you say about its angular momentum about that axis?arrow_forwardWhen tightening a bolt, you push perpendicularly on a wrench with a force of 165 N at a distance of 0.140 m from the center of the bolt. How much torque are you exerting in newton-meters (relative to the center of the bolt)?arrow_forward
- The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?arrow_forward(3) www. During a stendy right turn, a person exerts the forces shown on the steering wheel. Note that each force consista of a tangential component and a radially- inward component. Determine the moment exerted about the steering column at O. 30 15 15 30 8 N 375 mmarrow_forward(II) Two masses, mA = 35.0 kg and mB = 38.0 kg, are connected by a rope that hangs over a pulley (as in Fig. 10-59). The pulley is a uniform cylinder of radius 0.381 m and mass 3.1 kg. Initially ma is on the ground and mB rests 2.5 m above the ground. If the system is released, use conservation of energy to deter- mine the speed of mB just before it strikes the ground. Assume the pulley bearing is frictionless. %3D RO mB mA 2.5 m FIGURE 10-59 ba Problem 67. inoni lo (IID) A.arrow_forward
- (II) A potter is shaping a bowl on a potter's wheel rotating at constant angular velocity of 1.6 rev/s (Fig. 8–48). The friction force between her hands and the clay is 1.5 N total. (a) How large is her torque on the wheel, if the diameter of the bowl is 9.0 cm? (b) How long would it take for the potter's wheel to stop if the only torque acting on it is due to the potter's hands? The moment of inertia of the wheel and the bowl is 0.11 kg•m². FIGURE 8–48 Problem 40.arrow_forwardA uniform rod of mass M and length l can pivot freely (i.e., we ignore friction) about a hinge attached to a wall, as in Fig. 8-63. The rod is held horizontally and then released. At the moment of release, determine (a) the angular acceleration of the rod, and (b) the linear acceleration of the tip of the rod. Assume that the force of gravity acts at the center of mass of the rod, as shown. [Hint: See Fig. 8–20g.] СМ FIGURE 8-63 Problem 89. Mỹarrow_forward(II) A grinding wheel is a uniform cylinder with a radius of 8.50 cm and a mass of 0.380 kg. Calculate (a) its moment of inertia about its center, and (b) the applied torque needed to accelerate it from rest to 1750 rpm in 5.00 s. Take into account a frictional torque that has been measured to slow down the wheel from 1500 rpm to rest in 55.0 s.arrow_forward
- 6 In the overhead view of Fig. 10-24, five forces of the same magnitude act on a strange merry-go-round; it is a square that can rotate about point P, at midlength along one of the edges. Rank the forces according to the mag- nitude of the torque they create about point P,greatest first.arrow_forward(II) A ball of mass M and radius r on the end of a thin massless rod is rotated in a horizontal circle of radius Ro about an axis of rotation AB, as shown in Fig. 10-58. (a) Considering the mass of the ball to be concentrated at its center of mass, calculate its moment of inertia about AB. (b) Using the parallel-axis theorem and considering the finite radius of the ball, calculate the moment of inertia of the ball about AB. (c) Calculate the percentage error intro- duced by the point mass approximation for r 1.0 m. s 9.0 cm and %3D Ro to Toinso odt 1s oizs IsB gadsion ai m %3D 08.2 (E 10-0 boT Ro UKE or da Problem 89. ► M 10-65 FIGURE 10-58 molecule. The H bonds incrtia Problem 58. A gl00Aarrow_forward10-105 Determine the moment of inertia of the compos- ite body shown in Fig. P10-105 with respect to the y-axis shown on the figure. The specific weiglıt of the material is 175 lb/ft. 3 in. 8 in. 6 in. 6 in. 6 in. . 6 in. 5 in. 8 in. 5 in. 12 in. 3 in. Fig. P10-105arrow_forward
- University Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College