PROGRAMMABLE LOGIC CONTROLLERS BUNDLE
5th Edition
ISBN: 9781260582475
Author: Petruzella
Publisher: MCG
expand_more
expand_more
format_list_bulleted
Expert Solution & Answer
Chapter 12, Problem 1P
Explanation of Solution
Operations of drum switch:
The structure and operations of the given drum switch is as follows:
- To operate the contact blocks in the drum, the “pegs” are situated at the particular locations around the drum.
- The contacts which are associated with the “pegs” are closed and the contacts without pegs are opened when the drum gets rotated.
- The logical value “1” or “ON” is used to represent the peg existence and the logical value “0” or “OFF” is used to represent the peg non-existence.
Sequencer data table:
The equivalent sequencer data table for the four steps of the
0 | 1 | 0 | 1 | 0 | 0 |
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Draw the schematic/circuit diagram of a modulo-8 counter using the decade ripple counter 74HCT390. Be sure to draw it in a detailed and labeled manner since you will be building this circuit.If you are able to hand draw this circuit, that would be greatly appreciated !!
Design the digital circuit that collects three 4-bit numbers and displays it on the Hexadecimal 7-segment display, using the necessary integrated circuits.
Design a BCD (Binary Coded Decimal) to Excess – 3 code converter circuit. Implement using 7408, 7432, and 7486 provide a schematic logic diagram. Even a photo of it will surely help me in my review. Thank you so much!!
Chapter 12 Solutions
PROGRAMMABLE LOGIC CONTROLLERS BUNDLE
Knowledge Booster
Similar questions
- Design a 3-bit down-up counter using S-R FFS.arrow_forwardDesign a code converter that converts a BCD to seven segment display using NOR gate only, provide a schematic logic diagram of it. Even a photo of it will surely help my review a lot. Thank you so much!!!arrow_forwardDesign and explain the block diagram of sequential circuit.arrow_forward
- design 8-to-1 multiplexer using two 4-to-1 multiplexers and any other necessary logic.arrow_forwardDesign a 4-bit Arithmetic Logic Unit with proper connections that shows the operation of Output and justify your design through mathematical analysis.arrow_forwardDesign a combination circuit that allows to add two digits BCD 8421. The inputs and outputs will be displayed on 7-segment displays, design with a mix of multiplexers, decoders and demultiplexers, additional elements are allowed.arrow_forward
- Explain the principle of operation of the Mod-14 asynchronous counter with using the required figures, then draw the timing diagram for the input and output of this counter when the frequency of the input signal is 10KHz.arrow_forwardDerive the state diagram (Mealy design) for a sequence counter which detect and count the sequence of "101101" (without overlapping).arrow_forwardDesign an interfacing circuit to interface a 2KB ROM and 4KB RAM to 8085 processor.arrow_forward
- Design 2-bit synchronous counter that counts 0, 1, 2, 3 in succession. Draw the given counter’s counting table (state diagram) in binary and decimal form below . Indicate the transitions.arrow_forwardDesign a single-digit decade counter that counts from 0 to 9 and repeats. The single-digit decade counter should be built by a cascaded synchronous binary counter (74LS163) and other basic logic gates. Simulate the complete counter circuit by OrCAD and PSPICE. Capture the circuit schematic and the simulated waveform. (Define the simulation timings for at least one full counting cycle from 0 to 9 and back to 0.) (Hint: Use the DigClock input from the SOURCE as shown below and setup the CLK ONTIME and OFFTIME accordingly for the clock source.)arrow_forwardDesign a 2-bit synchronous counter using D Flip-flops. That is the counter should go through the sequences 10-01-11-00-10 not 00-01-10-11. Draw the state diagram, show the state transition table, write the flip-lops input equations and k-map and draw the final design using logisim.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Systems ArchitectureComputer ScienceISBN:9781305080195Author:Stephen D. BurdPublisher:Cengage Learning
Systems Architecture
Computer Science
ISBN:9781305080195
Author:Stephen D. Burd
Publisher:Cengage Learning