Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)
Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)
5th Edition
ISBN: 9781305084766
Author: Saeed Moaveni
Publisher: Cengage Learning
Question
Book Icon
Chapter 13, Problem 26P

(a)

To determine

Find the amount of natural gas needed to burn to heat twenty gallons of water, if the water heater has an efficiency of 78%.

(b)

To determine

Find the amount of natural gas needed to burn to heat twenty gallons of water, if the water heater has an efficiency of 85%.

(c)

To determine

Find the amount of natural gas needed to burn to heat twenty gallons of water, if the water heater has an efficiency of 90%.

Blurred answer
Students have asked these similar questions
A copper plate, with dimensions of 3 cm × 3 cm × 5 cm (length, width, and thickness, respectively), is exposed to a thermal energy source that puts out 150 J every second, as shown in the accompanying figure. The density of copper is 8900 kg⁄m3 . Assuming no heat loss to the surrounding block,determine the temperature rise in the plate after 10 seconds.
The design fluid (typically water and antifreeze) flow rate through a solar hot-water heater system is (1 L/s) m ⁄m2 . If a system runs continuously for 3 hours and makes use of two solar panels (each 2 m×4 m) , what is the total volume of the fluid that goes through the collector during this period? Express your answer in liters and m3 .
Replacing incandescent lights with energy-efficient fluorescent lights can reduce the lighting energy consumption to one-fourth of what it was before. The energy consumed by the lamps is eventually converted to heat, and thus switching to energy-efficient lighting also reduces the cooling load in summer but increases the heating load in winter. Consider a building that is heated by a natural gas furnace with an efficiency of 80 percent and cooled by an air conditioner with a COP of 3.5. If electricity costs $0.12/kWh and natural gas costs $1.40/therm (1 therm = 105,500 kJ), determine if efficient lighting will increase or decrease the total energy cost of the building (a) in summer and (b) in winter.