Sustainable Energy
2nd Edition
ISBN: 9781337551663
Author: DUNLAP, Richard A.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Estimate the average power available in a tidal basin if the area of the tidalbasin A is 18 × 106 m2, the tidal range H is 4.6 m, and tidal period τ is9 h = 32,400 s. The sea water density ρ is 1025 kg/m3.
The flow of a river is 150 cubic feet per second at a site where a 75 feet hydrostatic head canbe created by the erection of a dam. What is the potential capacity (in kW) of a hydroelectricpower plant if installed at this site? Consider that hydraulic efficiency of energy conversioncan be 80%, and that the electric efficiency can be 90%.
A trapezoidal canal has a bottom width of 6m a side slope of 1:1. It carries a discharge of 12 cu.m./s. Determine the minimum specific energy in meters.
A rectangular channel 2 m wide carries 2.2 cu.m./s of water. Compute the minimum specific energy in meters.
Chapter 13 Solutions
Sustainable Energy
Knowledge Booster
Similar questions
- For a hydraulic jump in a rectangular channel the velocity and depth after the jump are known to be 0.8m/s and 1.75 m respectively. Calculate the depth before the jump, the energy loss and the power dissipated per meter width.arrow_forwardDetermine the maximum flow in a rectangular channel 6m wide if the specific energy is 4 Nm/m.arrow_forwardWater is lifted from a lower reservoir to a higher reservoir by a pump that provides 23 kW of power. The water is being pumped at a rate of 0.03 m^3/s with a velocity V = 1 m/s through the closed conduit connecting the two reservoirs. Accounting for the loss at the submerged discharge at the higher reservoir, determine the friction head loss along the length of the conduit.arrow_forward
- A trout jumps, producing waves on the surface of a 0.8 m deep mountain stream. If it is observed that the waves do not travel upstream, what is the minimum velocity of the current? [Answer in units of m/s]arrow_forwardAt a proposed hydroelectric power plant site, the average elevation of headwater is 600m and the tailwater elevation is 480m. The average annual water flow is determined to be equal to that volume flowing through a rectangular channel 4m wide and 0.5m deep and average velocity of 5.5m/s. Assuming the plant will operate 350 days/year, find the energy kwh that the plant site can developed if the hydraulic turbine that will be used has an efficiency of 78% and generator efficiency of 90%. Consider a headwork loss of 4% of the available head.arrow_forwardFor a tidal range at a particular place with 2 tides daily of 10m, and the surface tidal energy harnessing plant of 9km^2, if the specific gravity of water is 1025.18kg/m^3, determine the total energy potential per day of the plant.arrow_forward
- Water flows from an upper reservoir to a lower one while passing a turbine as shown. 1. Compute the total head loss due to friction when the discharge is 150 lit/s. a. 4.25 m b. 3.84 m c. 5.67 m d. 2.54 m 2. Find the velocity of water. a. 2.05 m/s b. 4.12 m/s c. 3.06 m/s d. 6.57 m/s 3. Find the power input of the turbine. a. 213.5 kW b. 210.6 kW c. 115.2 kW d. 356.2 kWarrow_forwardA saltwater enters into a hydraulic reaction turbine w/ a velocity of 12ft/s & leaves it 3ft lower with a velocity of 4ft/s. If 100,000lbs of water flow thru the turbine each sec, determine its power output in Hp (Assume the turbine is at 80% efficient).arrow_forwardA rectangular channel 2.0 m wide and 1.0 m deep carries a discharge of 4.0 m3/s. A horizontal datum is assumed 2.0 m below the channel bed at a certain point. Calculate the total energy and the specific energy at that pointarrow_forward
- [CE Hydraulics] 3. In a pipeline with converging diameter, will the gradient of the total energy line be steeper or milder than the gradient of the piezometric head line? Why?arrow_forwardIn Figure below, with 35 L/s of seawater (sp gr 1.03) flowing from 1 to 2, the pressure at 1 is 100 kPa, and at 2 is -15 kPa. Point 2 is 6 m higher than point 1. Compute the lost energy in kPa between 1 and 2.arrow_forwardIn a hydroelectric power plant, the tailwater level fixes at 480 m. The net head is 27m and head loss is 5% of the gross head. What is the water elevation? a) 508.97m b) 456.7m c) 508.42m d)903.9marrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
