Find the stiffness of the piled raft K p r and relative proportion carried by the raft ( X ).

Question

Want to see the full answer?

Answer 1

Question

Chapter 14, Problem 14.3P

To determine

Find the stiffness of the piled raft Kpr and relative proportion carried by the raft (X).

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The section of a 4 x 4 group pile in a layered saturated clay is shown in Figure P 9.29. The piles are square in cross section (356 mm x 356 mm). The center-to-center spacing (d) of the piles is 1 m. Determine the allowable load bearing capacity of the pile group. Use FS = 3 and Table 9.10.

2. Consider a group of 450 mm x 450 mm reinforced concrete piles were driven into thick loose sand layer with the average unit weight and internal friction angle of 16 kN/m3 and 30°, respectively. Estimate the group pile capacity with the arrangement as shown in Figure Q2 if the length of pile embedment is 30 m assuming ground water table is far below the ground surface. Use 8 = 0.80 and K = 1.5Ko. 3B 3B 3B 1 3 3.5B b 'P 9. 10 11 a 3.5B 2 4 1.5B 1.5B 1.5B 1.5B 1.5B 1.5B Figure Q2

A 600 mm diameter and 25 m long driven concrete pile carries a column load of 1200 kN. It is estimated that the shaft carries 900 kN and the point carries 300 kN. Determine the settlement of the pile head using the Poulos and Davis method with the following data: Es = 25 MN/m2, Ep = 30,000 MN/m2 and ?s = 0.2.