MOD.MASTER.W/ETEXT ENG.MECHANICS CARD+BK
15th Edition
ISBN: 9780137519170
Author: HIBBELER
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 15, Problem 122P
The fountain shoots water in the direction shown. If the water is discharged at 30° from the horizontal, and the cross-sectional area of the water stream is approximately 2 in2, determine the force it exerts on the concrete wall at B. γw = 62.4 lb/ft3.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
: Water Flow into
horizontal pipe with velocity of v.
Determine the horizontal and
vertical component of force and
the moment at A need to hold the
elbow in place. Neglected the
weight of the elbow and the water
within it . Take v between 1 to 5 m/s
and D1 between 0.2 to 1.0 m and D2
between 1.0 to 0.2 m.
3 m
D1
v1
A
В
Q2
The truck dumps water on the ground such that it
flows from the truck through a 100-mm-wide opening at an
angle of 60°. The length of the opening is 2 m. Determine
the friction force that all the wheels of the truck must exert
on the ground to keep the truck from moving at the instant
the water depth in the truck is 1.75 m.
A
1.75 m
B
60°
The chute is used to divert the flow of water. The flow is 0.4 m /s and it has a cross-sectional area of 0.03 m?. Neglect the weight
of the chute and the water on it
4 m
Part A
Determine the horizontal force acting on the chute at the roller B, necessary for equilibrium.
Express your answer to three significant figures and include the appropriate units.
Part B
Determine the z component of the force acting on the chute at the pin A, necessary for equilibrium.
Express your answer to three significant figures and include the appropriate units.
Part C
Determine the y component of the force acting on the chute at the pin A, necessary for equilibrium.
Express your answer to three significant figures and include the appropriate units.
Chapter 15 Solutions
MOD.MASTER.W/ETEXT ENG.MECHANICS CARD+BK
Ch. 15 - The 0.5kg ball strikes the rough ground and...Ch. 15 - Prob. 2FPCh. 15 - Prob. 3FPCh. 15 - The wheels of the 1.5-Mg car generate the traction...Ch. 15 - Prob. 5FPCh. 15 - If the coefficient of kinetic friction between the...Ch. 15 - Prob. 3PCh. 15 - Each of the cables can sustain a maximum tension...Ch. 15 - Crates A and B weigh 100 lb and 50 lb,...Ch. 15 - Prob. 8P
Ch. 15 - Prob. 9PCh. 15 - During operation the jack hammer strikes the...Ch. 15 - For a short period of time, the frictional driving...Ch. 15 - The 2.5-Mg van is traveling with a speed of 100...Ch. 15 - Prob. 14PCh. 15 - The towing force acting on the 400-kg safe varies...Ch. 15 - Prob. 18PCh. 15 - Prob. 19PCh. 15 - If it takes 35 s for the 50-Mg tugboat to increase...Ch. 15 - Prob. 23PCh. 15 - The balloon has a total mass of 400 kg including...Ch. 15 - Prob. 26PCh. 15 - Prob. 30PCh. 15 - Prob. 7FPCh. 15 - The cart and package have a mass of 20 kg and 5...Ch. 15 - The 5-kg block A has an initial speed of 5 m/s as...Ch. 15 - Prob. 10FPCh. 15 - Prob. 11FPCh. 15 - The cannon and support without a projectile have a...Ch. 15 - The 5-Mg bus B is traveling to the right at 20...Ch. 15 - Prob. 36PCh. 15 - A railroad car having a mass of 15 Mg is coasting...Ch. 15 - A ballistic pendulum consists of a 4-kg wooden...Ch. 15 - Prob. 39PCh. 15 - Prob. 43PCh. 15 - Prob. 44PCh. 15 - Prob. 45PCh. 15 - The 30-Mg freight car A and 15-Mg freight car B...Ch. 15 - Blocks A and B have masses of 40 kg and 60 kg,...Ch. 15 - Block A has a mass of 5 kg and is placed on the...Ch. 15 - Solve Prob. 15-53 if the coefficient of kinetic...Ch. 15 - Prob. 56PCh. 15 - Prob. 13FPCh. 15 - Prob. 14FPCh. 15 - The 30-lb package A has a speed of 5 ft/s when it...Ch. 15 - The ball strikes the smooth wall with a velocity...Ch. 15 - Prob. 17FPCh. 15 - Prob. 18FPCh. 15 - Prob. 58PCh. 15 - Prob. 59PCh. 15 - Prob. 61PCh. 15 - Prob. 62PCh. 15 - Prob. 63PCh. 15 - Prob. 64PCh. 15 - A 1-lb ball A is traveling horizontally at 20 ft/s...Ch. 15 - Prob. 69PCh. 15 - Prob. 73PCh. 15 - Two smooth disks A and B each have a mass of 0.5...Ch. 15 - Prob. 75PCh. 15 - The cue ball A is given an initial velocity (vA)1...Ch. 15 - Prob. 78PCh. 15 - Prob. 79PCh. 15 - A ball of negligible size and mass m is given a...Ch. 15 - Prob. 81PCh. 15 - The 20-lb box slides on the surface for which k =...Ch. 15 - Prob. 84PCh. 15 - Prob. 85PCh. 15 - Prob. 90PCh. 15 - Prob. 92PCh. 15 - Disks A and B have a mass of 15 kg and 10 kg,...Ch. 15 - Prob. 19FPCh. 15 - Prob. 20FPCh. 15 - Initially the 5-kg block is moving with a constant...Ch. 15 - Prob. 22FPCh. 15 - Prob. 23FPCh. 15 - Prob. 24FPCh. 15 - Determine the angular momentum HO of the 6-lb...Ch. 15 - Determine the angular momentum HP of the 6-lb...Ch. 15 - Prob. 96PCh. 15 - Determine the angular momentum Hp, of each of the...Ch. 15 - Prob. 98PCh. 15 - Determine the angular momentum Hp of the 3-kg...Ch. 15 - The 800-lb roller-coaster car starts from rest on...Ch. 15 - The 800-lb roller-coaster car starts from rest on...Ch. 15 - If the rod of negligible mass is subjected to a...Ch. 15 - The amusement park ride consists of a 200-kg car...Ch. 15 - An earth satellite of mass 700 kg is launched into...Ch. 15 - Prob. 115PCh. 15 - Prob. 116PCh. 15 - Prob. 119PCh. 15 - The gauge pressure of water at A is 150.5 kPa....Ch. 15 - Prob. 121PCh. 15 - The fountain shoots water in the direction shown....Ch. 15 - A plow located on the front of a locomotive scoops...Ch. 15 - Prob. 124PCh. 15 - Water is discharged from a nozzle with a velocity...Ch. 15 - Prob. 127PCh. 15 - Prob. 128PCh. 15 - Sand drops onto the 2-Mg empty rail car at 50 kg/s...Ch. 15 - Prob. 133PCh. 15 - A rocket has an empty weight of 500 lb and carries...Ch. 15 - Prob. 135PCh. 15 - Prob. 138PCh. 15 - The missile weighs 40 000 lb. The constant thrust...Ch. 15 - Prob. 140PCh. 15 - Prob. 1RPCh. 15 - Prob. 2RPCh. 15 - Prob. 3RPCh. 15 - Prob. 4RPCh. 15 - The 200-g projectile is fired with a velocity of...Ch. 15 - Block A has a mass of 3 kg and is sliding on a...Ch. 15 - Two smooth billiard balls A and B have an equal...Ch. 15 - Prob. 8RP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- If the absolute velocity of the blade is 20 fps; the absolute velocity of the water is 100 fps and the angle between them is 120°, determine the velocity of the water relative to the blade.arrow_forwardThe car is used to scoop up water that is lying in a trough at the tracks. Determine the force needed to pull the car forward at constant velocity v for each of the three cases. The scoop has a cross-sectional area A and the density of water is ρw .arrow_forwardDetermine the magnitude and location of the resultant force acting onthe triangular end plates of the water trough shown; ρw = 1000 kg/m3.arrow_forward
- A jet issues without loss from a hole in a water tank that is open to the atmosphere. The hole is located a distance H below the free surface, and the jet issues at an angle θ to the horizontal direction, and it has an exit area of A. Express the maximum height of the jet as a function of θ and H (which is held constant). What is the the horizontal component of the force exerted on the tank by the jet? Ignore losses.arrow_forward3 - Oil flows through the horizontal pipe under a pressure of 400 kPa and a velocity of 2.5 m/s at A. Determine the pressure in the pipe at B if the pressure at C is 150 kPa.Disregard any difference in elevation. Consider the specific mass of the oil equal to 880 kg/m3.arrow_forwardThe balloon has a mass of 25 g (empty) and it is filled with air having a temperature of 20 ∘C having the density of 1.202 kg/m3. If it is released, it begins to accelerate upward at 8 m/s2 Determine the initial mass flow of air from the stem. Assume the balloon is a sphere having a radius of 180 mm .arrow_forward
- Water flows through the 200-mm-diameter pipe bend with a velocity of 11 m/s and discharges into the atmosphere at B. The mass of the pipe bend and the water within it is 25 kg, having a center of gravity at G. 600 mm 450 mm 200 mm Part A Determine the r-component of force acting on the coupling at A. Express your answer to three significant figures and include the appropriate units.arrow_forwardProblem 2. Air is drawn into the 200-mm-diameter cylinder through the opening at A. If the piston is moving downward at a constant velocity of 10 m/s, determine the average pressure within the cylinder and the force required to move the piston. Take pa = 1.23 kg/m'. 200 mm Barrow_forwardIf 0.00063 m of kerosene is then poured into the pipe, determine the height h to which the kerosene rises from the top of the glycerin.arrow_forward
- Water flows into the horizontal bend fitting at A with a velocity of V = 4.2 m/s, and exits at B into the atmosphere as shown in (Figure 1). A 150 mm 200 mm 400 mm y 30° B Determine the r-component of force at C needed to hold the fitting in place. Determine the y-component of force at C needed to hold the fitting in place. Determine the moment at C needed to hold the fitting in place.arrow_forwardIf the absolute velocity of the blade is 70 fps; the velocity of the water relative to the blade is 100 fps and the angle between them is 60°, determine the angle (in degrees)between absolute velocities (i.e. of the water and the blade).arrow_forwardGiven the velocity through the exhaust of the rocket is: U(r) = Umax (1-1) 1¹/² R Umax is a constant r is the radial coordinate out from the center of the engine R is the outside radius of exhaust flow Determine the reaction force of the exhaust in terms of: p, Umax, and Rarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
International Edition---engineering Mechanics: St...Mechanical EngineeringISBN:9781305501607Author:Andrew Pytel And Jaan KiusalaasPublisher:CENGAGE L
International Edition---engineering Mechanics: St...
Mechanical Engineering
ISBN:9781305501607
Author:Andrew Pytel And Jaan Kiusalaas
Publisher:CENGAGE L
Intro to Compressible Flows — Lesson 1; Author: Ansys Learning;https://www.youtube.com/watch?v=OgR6j8TzA5Y;License: Standard Youtube License