Concept explainers
In noisy factory environments, it’s possible to use a loudspeaker to cancel persistent low-frequency machine noise at the position of one worker. The details of practical systems are complex, but we can present a simple example that gives you the idea. Suppose a machine 5.0 m away from a worker emits a persistent 80 Hz hum. To cancel the sound at the worker’s location with a speaker that exactly duplicates the machine’s hum, how far from the worker should the speaker be placed? Assume a sound speed of 340 m/s.
Want to see the full answer?
Check out a sample textbook solutionChapter 16 Solutions
College Physics: A Strategic Approach (3rd Edition)
Additional Science Textbook Solutions
University Physics Volume 2
Modern Physics
Conceptual Physics (12th Edition)
Applied Physics (11th Edition)
Essential University Physics: Volume 2 (3rd Edition)
Essential University Physics: Volume 1 (3rd Edition)
- A tuning fork is known to vibrate with frequency 262 Hz. When it is sounded along with a mandolin siring, four beats are heard every second. Next, a bit of tape is put onto each line of the tuning fork, and the tuning fork now produces five beats per second with the same mandolin siring. What is the frequency of the string? (a) 257 Hz (b) 258 Hz (c) 262 Hz (d) 266 Hz (e) 267 Hzarrow_forwardA barrel organ is shown in Figure P18.38. Such organs are much smaller than traditional organs, allowing them to fit in smaller spaces and even allowing them to be portable. Use the photo to estimate the range in fundamental frequencies produced by the organ pipes in such an instrument. Assume the pipes are open at both ends. How does that range compare to a piano whose strings range in fundamental frequency from 21.7 Hz to 4186.0 Hz? FIGURE P18.38arrow_forwardWrite an expression that describes the pressure variation as a function of position and time for a sinusoidal sound wave in air. Assume the speed of sound is 343 m/s, = 0.100 m, and Pmax = 0.200 Pa.arrow_forward
- In figure OQ18.1 (page 566), a sound wave of wave-lenght 0.8 m divides into two equal parts that recombine to interfere constructively, with the original difference between their path lengths being |r2 r1| = 0.8 m. Rank the following situations according to the intensity of sound at the receiver from the highest to the lowest. Assume the tube walls absorb no sound energy. Give equal ranks to situations in which the intensity is equal. (a) From its original position, the sliding section is moved out by 0.1 m. (b) Next it slides out an additional 0.1 m. (c) It slides out still another 0.1 m. (d) It slides out 0.1 m more.arrow_forwardUltrasound is used in medicine both for diagnostic imaging (Fig. P17.9, page 526) and for therapy. For diagnosis, short pulses of ultrasound are passed through the patients body. An echo reflected from a structure of interest is recorded, and the distance to the structure can be determined from the time delay for the echos return. To reveal detail, the wavelength of the reflected ultrasound must be small compared to the size of the object reflecting the wave. The speed of ultrasound in human tissue is about 1 500 m/s (nearly the same as the speed of sound in water). (a) What is the wavelength of ultrasound with a frequency of 2.40 MHz? (b) In the whole set of imaging techniques, frequencies in the range 1.00 MHz to 20.0 MHz are used. What is the range of wavelengths corresponding to this range of frequencies?arrow_forwardA 512-Hz tuning fork is struck and placed next to a tube with a movable piston, creating a tube with a variable length. The piston is slid down the pipe and resonance is reached when the piston is 115.50 cm from the open end. The next resonance is reached when the piston is 82.50 cm from the open end. (a) What is the speed of sound in the tube? (b) How far from the open end will the piston cause the next mode of resonance?arrow_forward
- A driver travels northbound on a highway at a speed of 25.0 m/s. A police car, traveling southbound at a speed of 40.0 m/s, approaches with its siren producing sound at a frequency of 2 500 Hz. (a) What frequency does the driver observe as the police car approaches? (b) What frequency does the driver detect after the police car passes him? (c) Repeat parts (a) and (b) for the case when the police car is behind the driver and travels northbound.arrow_forwardThe area of a typical eardrum is about 5.00 X 10-5 m2. (a) (Calculate the average sound power incident on an eardrum at the threshold of pain, which corresponds to an intensity of 1.00 W/m2. (b) How much energy is transferred to the eardrum exposed to this sound lor 1.00 mill?arrow_forwardA skyrocket explodes 100 m above the ground (Fig. P14.24). Three observers are spaced 100 m apart, with the first (A) directly under the explosion. (a) What is the ratio of the sound intensity heard by observer A to that heard by observer B? (b) What is the ratio of the intensity heard by observer A to that heard by observer C? Figure P14.24arrow_forward
- Dog whistles operate at frequencies above the range of human hearing. Explain how two such whistles operating at slightly different frequencies may be used to make a sound audible to a person.arrow_forwardA driver travels northbound on a highway at a speed of 25.0 m/s. A police car. traveling southbound at a speed of 40.0 m/s. approaches with its siren producing sound at a frequency of 2 500 Hz. (a) What frequency does the driver observe as the police car approaches? (b) What frequency does the driver detect after the police car passes him? (c) Repeat parts (a) and (b) for the case when the police car is behind the driver and travels northbound.arrow_forwardA trumpet creates a sound intensity level of 1.15 102 dB at a distance of 1.00 m. (a) What is the sound intensity of a trumpet at this distance? (b) What is the sound intensity of five trumpets at this distance? (c) Find the sound intensity of five trumpets at the location of the first row of an audience, 8.00 m away, assuming, for simplicity, the sound energy propagates uniformly in all directions. (d) Calculate the decibel level of the five trumpets in the first row. (e) If the trumpets are being played in an outdoor auditorium, how far away, in theory, can their combined sound be heard? (f) In practice such a sound could not be heard once the listener was 2-3 km away. Why cant the sound be heard at the distance found in part (e)? Hint: In a very quiet room the ambient sound intensity level is about 30 dB.arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University