Sustainable Energy
1st Edition
ISBN: 9781133108689
Author: Richard A. Dunlap
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
error_outline
This textbook solution is under construction.
Students have asked these similar questions
If a certain gasoline weighs 20 lb/ft3, what are the values of its density, specific volume, and specific gravity relative to water?
In a racing contest, there are 240 cars which will have fuel provisions that will last for 15 hours. Assuming a constant hourly consumption for each car, how long will the fuel provisions lasts if 8 cars withdraw from the race every hour after the first.
Select one:
a. 20 hours
b. 25 hours
c. 36 hours
d. 18 hours
Assume that gasoline is burned with 99% efficiency in a car engine, with 1% remaining unbumed in the exhaust gases as VOCs; If the engine exhausts 16 kg of gases (MW = 30) for each kg of gasoline (MW = 100), calculate the fraction of VOCs in the exhaust. Give your answer in parts per million.
Knowledge Booster
Similar questions
- In the U.S., the fuel consumption of an automobile is expressed in X miles per gallon. Obtain a single factor that could be used to convert the X miles per gallon to km per liter.arrow_forwardA water treatment plant with an average flow of Q = 0.8 m3/s treats its water with alum at a dose of 27 mg/L. Alum (Al2(SO4)3. 14.3 H2O) coagulation is used to remove particulate matter, reduce the concentration of organic matter, and reduce the alkalinity of the water. Determine the total mass of aluminum hydroxide (Al(OH)3) consumed per day (kg/d, no decimal point) (atomic mass: Al: 27, S: 32, H: 1, O: 16).arrow_forwardA water treatment plant with an average flow of Q = 0.5 m3/s treats its water with alum at a dose of 34 mg/L. Alum (Al2(SO4)3. 14.3 H2O)coagulation is used to remove particulate matter, reduce the concentration of organic matter, and reduce the alkalinity of the water. Determine the total mass of alkalinity (HCO3-) consumed per day (kg/d, no decimal point) (atomic mass: Al: 27, S: 32, H: 1, O: 16, C: 12)arrow_forward
- 1 A woman works in a factory for 15 years. The drinking water in the factory contains xylene and fluoride. Her only exposure to these chemicals in water is at work. Using Table 10,find the hazard index associated with this exposure?Xylene: 0.6 mg/LFluoride: 3.1 mg/Larrow_forwardDetermine the mass of carbon tetrachloride that should be mixed with 80 kg of glycerin so that the combined mixture has a density of 1450 kg/m3.arrow_forwardEnvironmental Engineering A liter of water was found to contain 10mg of benzene (C6H6). What is the concentration of benzene in mg/L, ppm, and molarity?arrow_forward
- A cylindrical tank of methanol has a mass of 40 kg and a volume of 51 L. Determine the methanol’sweight, density, and specific gravityarrow_forwardA 20,000 L tank of water with pH of 7.5 is to be treated with a liquid hydrogen bromide acid (HBr). If after 5000 L of the acid was added to the volume in the tank the pH becomes 5.5, how much mass of hydrogen was added to the system? How much total HBr was added?arrow_forwardChoose the correct answer 200 g CO2 approximately takes up ____ L volume in air at 1 atm and 0oC? 4480; 100; C. 200; D. Undetermined Which of the following gases has the greatest contribution to the greenhouse effect on the Earth? A. Water vapor; B. CO2; C. CH4; D. O3 Based on what you have learned, which of the following can contribute(s) greenhouse gases? A. landfills; B. a deep lake with organic rich sediments; C. septic tanks; D. all of the above Which of the following gases is NOT a greenhouse gas? A. methane; B. carbon monoxide; C. hydrofluorocarbons; D. water vaporarrow_forward
- A factory is discharging wastewater containing 1 mg/L chromium into a lake. The wastewater discharge rate is 10 gallon/min. Please estimate the mass of chromium (g) entering the lake every day.arrow_forwardYou have been tasked with designing a chlorination tank for killing microorganisms in the effluent from a wastewater treatment plant. It is necessary to achieve 99.99% kill in a wastewater flow of 100 m3/hr. You may assume that the disinfection process is first-order with a rate constant of 0.2/min. Note: a 99.99% kill percentage means that if 10,000 cells/L enter, only 1 cell/L will “live” through the process. a) Calculate the tank volume required (in m3) if disinfection occurs in a CSTR. b) Calculate the tank volume required (in m3) if disinfection occurs in a PFR. c) Identify the residence time (in hours) for each reactor and explain why one system is superior to the other.arrow_forwardEnvironmental Engineering, disaggregation exponential growth question: Consider the following disaggregation of carbon emissions: Carbon emissions (kg C/year)= [Population] x [Energy (kJ/year/person)] x [Carbon (kg C/Energy (kJ)] Using the following estimates for the United States and assuming growth rates remain constant, 1990 amounts: Population: 2.5 x 108, growth rate: 0.6% Energy: 3.2 x 108 kJ/yr/person, growth rate: 0.5% Carbon emissions: 1.5 x 10-5 kg C/kJ, growth rate: -0.3% Find: a) The carbon emission rate in 2020 b) The carbon emitted in those 30 years c) The total energy demand in 2020 d) the per capita carbon emission rate in 2020arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
