Concept explainers
Earthquakes are essentially sound waves—called seismic waves—traveling through the earth. Because the earth is solid, it can support both longitudinal and transverse seismic waves. The speed of longitudinal waves, called P waves, is
Want to see the full answer?
Check out a sample textbook solutionChapter 16 Solutions
PHYS 212 FOR SCI+ENG W/MAST PHYS >ICP<
- A flute has a length of 58.0 cm. If the speed of sound in air is 343 m/s, what is the fundamental frequency of the flute, assuming it is a tube closed at one end and open at the other? (a) 148 Hz (b) 296 Hz (c) 444 Hz (d) 591 Hz (e) none of those answersarrow_forwardA sound wave can be characterized as (a) a transverse wave, (b) a longitudinal wave, (c) a transverse wave or a longitudinal wave, depending on the nature of its source, (d) one that carries no energy, or (e) a wave that does not require a medium to be transmitted from one place to the other.arrow_forwardRank the waves represented by the following functions from the largest to the smallest according to (i) their amplitudes, (ii) their wavelengths, (iii) their frequencies, (iv) their periods, and (v) their speeds. If the values of a quantity are equal for two waves, show them as having equal rank. For all functions, x and y are in meters and t is in seconds. (a) y = 4 sin (3x 15t) (b) y = 6 cos (3x + 15t 2) (c) y = 8 sin (2x + 15t) (d) y = 8 cos (4x + 20t) (e) y = 7 sin (6x + 24t)arrow_forward
- Two traveling sinusoidal waves are described by the wave functions y1 = 5.00 sin [(4.00x 1 200t)] y2 = 5.00 sin [(4.00x 1 200t 0.250)] where x, y1 and y2 are in meters and t is in seconds. (a) What is the amplitude of the resultant wave function y1 + y2? (b) What is the frequency of the resultant wave function?arrow_forwardA sinusoidal wave travels down a taut, horizontal string with a linear mass density of =0.060 kg/m. The magnitude of maximum vertical acceleration of the wave is aymax=0.90 cm/s2 and the amplitude of the wave is 0.40 m. The string is under a tension of FT=600.00 N. The wave moves in the negative x-direction. Write an equation to model the wave.arrow_forwardA flowerpot is knocked off a window ledge from a height d = 20.0 m above the sidewalk as shown in Figure P17.13. lt falls toward an unsuspecting man of height h = 1.75 m who is standing below. Assume the man requires a time interval of t = 0.300 s to respond to the warning. How close to the sidewalk can the flowerpot fall before it is too late for a warning shouted from the balcony to reach the main in time?arrow_forward
- (a) At an air show a jet flies directly toward the stands at a speed of 1200 km/h, emitting a frequency of 3500 Hz, on a day when the speed of sound is 342 m/s. What frequency is received by the observers? (b) What frequency do they receive as the plane flies directly away from them?arrow_forwardAt t = 0, a transverse pulse in a wire is described by the function y=6.00x2+3.00 where xand y are in meters. If the pulse is traveling in the positive x direction with a speed of 4.50 m/s, write the function y(x, t) that describes this pulse.arrow_forwardA skyrocket explodes 100 m above the ground (Fig. P14.24). Three observers are spaced 100 m apart, with the first (A) directly under the explosion. (a) What is the ratio of the sound intensity heard by observer A to that heard by observer B? (b) What is the ratio of the intensity heard by observer A to that heard by observer C? Figure P14.24arrow_forward
- Problems 32 and 33 are paired. N Seismic waves travel outward from the epicenter of an earthquake. A single earthquake produces both longitudinal seismic waves known as P waves and transverse waves known as S waves. Both transverse and longitudinal waves can travel through solids such as rock. Longitudinal waves can travel through fluids, whereas transverse waves can only be sustained near the surface of a fluid, not inside the fluid. When seismic waves encounter a fluid medium such as the liquid outer core of the Earth, only the longitudinal P wave can propagate through. Geophysicists can model the interior of the Earth by knowing where and when S and P waves were detected by seismographs after an earthquake (Fig. P17.32). Assume the average speed of an S wave through the Earths mantle is 5.4 km/s and the average speed of a P wave is 9.3 km/s. After an earthquake, a seismograph finds that the P wave arrives 1.5 min before the S wave. How far is the epicenter from the detector? FIGURE P17.32arrow_forwardA transverse wave on a string is described by the wave function y=0.120sin(8x+4t) where x and y are in meters and t is in seconds. Determine (a) the transverse speed and (b) the transverse acceleration at t = 0.200 s for an element of the string located at x = 1.60 m. What are (c) the wavelength, (d) the period, and (e) the speed of propagation of this wave?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning