Essentials University Physics, Volume 1 and 2 - With Modified MasteringPhysics Access
3rd Edition
ISBN: 9780134235448
Author: Wolfson
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 16, Problem 80P
Use the method outlined in Problem 76 to show that the steady heat-flow rate in the direction of the axis of a truncated cone with
Figure 16.17 Problem 76
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A human body has a temperature of 30°C If its total surface area is 1.2 m2, what is the net rate of heat loss from the body by convection alone considering the surrounding temperature to be 24°C? Consider film coefficient to be h = 4.7 W/m2K.
On a cold winter day when the temperature is -20.0 ∘C, what is the amount of heat needed to warm to internal body temperature (37.0∘C) the 0.550 L of air exchanged with each breath? Assume that the specific heat capacity of air is 1020 J/(kg⋅K) and that 1.0 L of air has a mass of 1.3 g.
Express your answer in joules.
How much heat is lost per hour if the respiration rate is 19.0 breaths per minute?
An engineer who is working on the heat transfer analysis of a house in English units needs the convection heat transfer coefficient on the outer surface of the house. But the only value he can find from his handbooks is 22 W/m2·K, which is in SI units. The engineer does not have a direct conversion factor between the two unit systems for the convection heat transfer coefficient. Using the conversion factors between W and Btu/h, m and ft, and °C and °F, express the given convection heat transfer coefficient in Btu/h·ft2·°F.
Chapter 16 Solutions
Essentials University Physics, Volume 1 and 2 - With Modified MasteringPhysics Access
Ch. 16.1 - Is there (a) no temperature, (b) one temperature,...Ch. 16.2 - A hot rock with mass 250 g is dropped into an...Ch. 16.3 - The figure shows three slabs with the same...Ch. 16.3 - Prob. 16.4GICh. 16.4 - A houses thermostat fails, leaving the furnace...Ch. 16 - If system A is not in thermodynamic equilibrium...Ch. 16 - Does a thermometer measure its own temperature or...Ch. 16 - Compare the relative sizes of the kelvin, the...Ch. 16 - If you put a thermometer in direct sunlight, what...Ch. 16 - Why does the temperature in a stone building...
Ch. 16 - Why do large bodies of water exert a...Ch. 16 - A Thermos bottle consists of an evacuated,...Ch. 16 - Stainless-steel cookware often has a layer of...Ch. 16 - Prob. 9FTDCh. 16 - Prob. 10FTDCh. 16 - Glass and fiberglass are made from the same...Ch. 16 - To keep your hands warm while skiing, you should...Ch. 16 - Since Earth is exposed to solar radiation, why...Ch. 16 - Global warming at Earths surface is generally...Ch. 16 - In its 2014 report, the Intergovernmental Panel on...Ch. 16 - A Canadian meteorologist predicts an overnight low...Ch. 16 - Normal room temperature is 68F. Whats this in...Ch. 16 - Prob. 18ECh. 16 - At what temperature do the Fahrenheit and Celsius...Ch. 16 - The normal boiling point of nitrogen is 77.3 K....Ch. 16 - Prob. 21ECh. 16 - Prob. 22ECh. 16 - Prob. 23ECh. 16 - Whats the specific heat of a material if it takes...Ch. 16 - The average human diet contains about 2000 kcal...Ch. 16 - Prob. 26ECh. 16 - You bring a 350-g wrench into the house from your...Ch. 16 - Prob. 28ECh. 16 - Building heat loss in the United States is usually...Ch. 16 - Find the heat-loss rate through a slab of (a) wood...Ch. 16 - The top of a steel wood stove measures 90 cm by 40...Ch. 16 - Youre a builder whos advising a homeowner to have...Ch. 16 - An 8.0 m by 12 m house is built on a concrete slab...Ch. 16 - Find the -factor for a wall that loses 0.040 Btu...Ch. 16 - Compute the -factors for 1-inch thicknesses of...Ch. 16 - A horseshoe has surface area 50 cm2, and a...Ch. 16 - An oven loses energy at the rate of 14 W per C...Ch. 16 - Youre having your homes heating system replaced,...Ch. 16 - The filament of a 100-W lightbulb is at 3.0 kK....Ch. 16 - A typical human body has surface area 1.4 nr and...Ch. 16 - A constant-volume gas thermometer is filled with...Ch. 16 - A constant-volume gas thermometer is at 55-kPa...Ch. 16 - In Fig. 16.2s gas thermometer, the height h is...Ch. 16 - Prob. 44PCh. 16 - Typical fats contain about 9 kcal per gram. If the...Ch. 16 - A circular lake 1.0 km in diameter is 10 m deep...Ch. 16 - How much heat is required to raise an 800-g copper...Ch. 16 - Initially, 100 g of water and 100 g of another...Ch. 16 - Prob. 49PCh. 16 - Two neighbors return from Florida to find their...Ch. 16 - Prob. 51PCh. 16 - Prob. 52PCh. 16 - Prob. 53PCh. 16 - The temperature of the eardrum provides a reliable...Ch. 16 - Prob. 55PCh. 16 - Your young niece complains that her cocoa, at 90C,...Ch. 16 - A piece of copper at 300C is dropped into 1.0 kg...Ch. 16 - While camping, you boil water to make spaghetti....Ch. 16 - A biology labs walk-in cooler measures 3.0 m by...Ch. 16 - One end of an iron rod 40 cm long and 3.0 cm in...Ch. 16 - Prob. 61PCh. 16 - An electric stove burner has surface area 325 cm2...Ch. 16 - An electric current passes through a metal strip...Ch. 16 - Youre considering purchasing a new sleeping bag...Ch. 16 - A blacksmith heats a 1.1-kg iron horseshoe to...Ch. 16 - Whats the power output of a microwave oven that...Ch. 16 - A cylindrical log 15 cm in diameter and 65 cm long...Ch. 16 - A blue giant star whose surface temperature is 23...Ch. 16 - Prob. 69PCh. 16 - A black wood stove with surface area 4.6 nr is...Ch. 16 - Estimate the average temperature on Pluto,...Ch. 16 - Prob. 72PCh. 16 - Prob. 73PCh. 16 - Prob. 74PCh. 16 - Prob. 75PCh. 16 - In a cylindrical pipe where area isnt constant....Ch. 16 - Prob. 77PCh. 16 - Prob. 78PCh. 16 - Prob. 79PCh. 16 - Use the method outlined in Problem 76 to show that...Ch. 16 - A house is at 20C on a winter night when the...Ch. 16 - A more realistic approach to the solar greenhouse...Ch. 16 - Fiberglass is a popular, economical, and fairly...Ch. 16 - Fiberglass is a popular, economical, and fairly...Ch. 16 - Fiberglass is a popular, economical, and fairly...Ch. 16 - Fiberglass is a popular, economical, and fairly...
Additional Science Textbook Solutions
Find more solutions based on key concepts
7. Why is the following an inaccurate statement about blackout? "As the g forces climb up toward 7 g’s, . . . ....
College Physics
14. A rifle is aimed horizontally at a target 50 m away. The bullet hits the target 2.0 cm below the aim point....
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
By what factor must the volume of a gas with = 1.4 be changed in an adiabatic process if the pressure is to do...
Essential University Physics: Volume 1 (3rd Edition)
Calculate the average volume per molecule for an ideal gas at room temperature and atmospheric pressure. Then t...
An Introduction to Thermal Physics
1.35 Vector is 2.80 cm long and is 60.0° above the x-axis in the first quadrant. Vector is 1.90 cm long and i...
University Physics with Modern Physics (14th Edition)
If the Moon is a full Moon tonight, will the Moon be waxing or waning one week later? Which side of the Moon (...
Lecture- Tutorials for Introductory Astronomy
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A body whose surface area is 0.2 m2, emissivity is 0.8, and temperature is 100°C is placed in a large, evacuated chamber whose walls are at 25°C. What is the rate at which radiation is emitted by the surface, in W? What is the net rate at which radiation is exchanged between the surface and the chamber walls, in W?arrow_forwardConsider steady heat transfer between two large parallel plates at constant temperatures of T1 = 290 K and T2 = 150 K that are L = 2 cm apart. Assuming the surfaces to be black (emissivity « = 1), determine the rate of heat transfer between the plates per unit surface area assuming the gap between the plates is (a) filled with atmospheric air, (b) evacuated, (c) filled with fiberglass insulation, and (d) filled with superinsulation having an apparent thermal conductivity of 0.00015 W/m·K.arrow_forwardCompute the heat transfer through the air condition if the outside temperature is outside temperature, To = 5 degrees Celsius, inside temperature = 20 degrees Celsius, in a room with length 5 m, width of 6 m and height of 4 m. A typical volume flow for ventilation is 20 liters/second or 0.02 cubic meter/s, how much time will it take to replace all air within this room? Then, compute total thermal power flux out of the room through the ventilation? Given, Cp = 1005 J/khK, and roho = 1.2 kg/cubic.arrow_forward
- For a temperature difference ΔT = 20C, one slab of material conducts 10W/m². What is the rate of heat flow per m² of surface area when the slabs are placed side by side with ΔTtot = 20C?arrow_forwardConsider a 20 cm thick granite wall with a thermal conductivity of 2.79 W/m·K. The temperature of the left surface is held constant at 50°C, whereas the right face is exposed to a flow of 22°C air with a convection heat transfer coefficient of 15 W/m2·K. Neglecting heat transfer by radiation, find the right wall surface temperature and the heat flux through the wall.arrow_forwardDuring heavy exercise, the body pumps 2.00 L of blood per minute to the surface, where it is cooled by 2.00C. What is the rate of heat transfer from this forced convection alone, assuming blood has the same specific heat as water and its density is 1050 kg/m3 ?arrow_forward
- (a) Cherry-red embers in a fireplace are at 850ºC and have an exposed area of 0.200 m2 and an emissivity of 0.980. The surrounding room has a temperature of 18.0ºC . If 50% of the radiant energy enters the room, what is the net rate of radiant heat transfer in kilowatts? (b) Does your answer support the contention that most of the heat transferinto a room by a fireplace comes from infrared radiation?arrow_forwardSuppose you want to raise the temperature of a mass m of ice from T0 < 0 °C to T > 100 °C. In this problem, represent the heat of fusion as Lf, the heat of vaporization as Lv, and the temperatures at which the phase changes occur as Tf and Tv. How much heat must be transferred for this to happen, including the energy needed for phase changes? Your answer should be in terms of the variables in the introduction and the specific heats of ice (ci), water (cw), and steam (cs). The talent heats are Lf= 334kJ/kg and Lv=2256kJ/kg?arrow_forwardConsider a surface of area A at which the convection and radiation heat transfer coefficients are hconv and hrad, respectively. Explain how you would determine (a) the single equivalent heat transfer coefficient and (b) the equivalent thermal resistance. Assume the medium and the surrounding surfaces are at the same temperature.arrow_forward
- While attempting to forge a sword in Skyrim, you obtain an iron ore sample of unknown mass to work with. The iron ore sample has a resting temperature of 4°C. In order to reach the forging temperature of the iron, 974°C, the system requires 225 calories, which is supplied by the forge. Given that the specific heat of the iron ore sample is 0.111 kcal/kg°C, what is the mass, m, of the iron ore sample in kg?arrow_forwardSuppose a person is covered head to foot by wool clothing with an average thickness of d = 1.95 cm and is transferring energy by conduction through the clothing at the rate of Q / Δt = 45 W. What is the temperature difference, in terms of the quantities given in the problem statement, across the clothing? Denote the surface area of the wool by A and the thermal conductivity by k.arrow_forwardA heavily insulated copper rod or diameter 2 cm and length 25 cm is used to pipe heat between two objects. If the rate of heat transfer is 100 W and the hot object has a temperature of 50oC, what is the temperature of the cold object in oC?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Thermodynamics: Crash Course Physics #23; Author: Crash Course;https://www.youtube.com/watch?v=4i1MUWJoI0U;License: Standard YouTube License, CC-BY