Sustainable Energy, Si Edition
1st Edition
ISBN: 9781133108771
Author: DUNLAP, Richard A.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Assuming 80% efficiency, 100 m³/sec of design discharge, and 100 m
of design head, what will be the approximate electrical power
producted?
A pipe of diameter 300 mm and length 3500 m is used for the transmission of
power by water. The total head at the inlet of the pipe is 500 m. What willI be the
maximum power available at the outlet of the pipe, if the value of f = 0.06?
A PV battery system has an efficiency of 80%. The system is used to run an all-AC load that is run only at night. The charge controller efficiency is 96% and the inverter efficiency is 85%. How much energy will need to be generated by the PV array if the load is 150 watts running for 5 hours per night?
Chapter 18 Solutions
Sustainable Energy, Si Edition
Knowledge Booster
Similar questions
- Required information A generator supplies an average power of 14.0 MW through a transmission line that has a resistance of 10.0 0. rms ww Transmission line 10.0 Ω ww Load Calculate the rms current drawn by the load if &rms 249 kv. Aarrow_forwardi) What is a photovoltaic cell? ii) A certain solar cell type has an output capability of 0.5 A at 0.4Volts. A series / parallel solar array has been designed of such cells with 80 parallel strings and each string has 1500 cells in series. Calculate: (i) Voltage capability (ii) Current capability and (iii) Power output capability of the array.arrow_forwardI need the answer as soon as possiblearrow_forward
- Two automobile headlights are connected in series to a 25 Volts battery each having a resistance of 1.0 Ohm and 2 Ohms respectively. What is the current flowing in the circuit? (in ampere)arrow_forwardProblem 1: A solid steel shaft 5 m long is stressed at 80 MPa when twisted through 4º. Using G = 83 GPa, compute the shaft diameter. What power can be transmitted by the shaft at 20 Hz? (in Kilowatts)arrow_forwardA 150-mm-diameter jet of water is discharging from a nozzle into the air at a velocity of 45 m/s. Find the power in the jet with respect to a datum at the jet.arrow_forward
- Quickly.pls.arrow_forwardA Francis turbine of diameter 3.0 m develops 6750 kW at 300 rpm under a net head of 45 m. A geometrically similar model of scale ratio 1: 8 is to be tested at a head of 9 m. Estimate the size, speed discharge and power developed by the model. What is the specific speed of the model? (Assume overall efficiency of 0.82 for both the prototype and model)arrow_forwardProblem 3 Water (20°C) is pumped through the 300-mm steel pipe from the lower tank to the upper one at a rate of 0.4 m³/s. Given that the pump efficiency is 65% and the pump is on for 5 hours each day, what will be the monthly (30 days) energy cost for the pump if the electricity rate is 0.5 USD per kWh? Assume α = 1.0 throughout. Elevation=235 m 10 m 50 m Elevation 200 m = 300 mm r = 300 mm 100 marrow_forward
- A friend returns to the United States from Europe with a 960-W coffeemaker, designed to operate from a 240-V line. She wants to operate it at the USA-standard 120 V by using a transformer. If the secondary coil has 60 turns, what the number of turns in the primary coil? What current will the coffeemaker craw from the 120V line?arrow_forwardIn the mountains, hydroelectric facilities transport water from a reservoir through enclosed tubes to a turbine. In these plants, the intake tube of 100 cm (Point 2), 50 meters in diameter, is under the water surface of the reservoir (Point 1). Before the turbine falls into a 50-cm diameter bucket 200 meters through the tube (Point 3). (a) What is the speed of the water in the image when the turbine approaches Point 3?(b) Calculate the flow rate of the water at Point 3(c) Calculate the pressure P at point 1 (water surface), point 2 (intake) and Point 3 (nozzle), respectivelyarrow_forward1. An unknown lamp placed 6m from a photometer screen provides the same illuminance as a 90 cd lamp placed 4 m from the screen. What is the candlepower of the unknown lamp? 2. The illuminance of a room 20 ft x 15 ft is being designed. The illuminance required is 50 footcandles. What is the total required lumens output of the lamp assuming room and luminaire efficiency of 42%?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning
Engineering Fundamentals: An Introduction to Engi...
Civil Engineering
ISBN:9781305084766
Author:Saeed Moaveni
Publisher:Cengage Learning