Physics:f/sci.+engrs.,ap Ed.
10th Edition
ISBN: 9781337553469
Author: Jewett, SERWAY
Publisher: Cengage
expand_more
expand_more
format_list_bulleted
Question
Chapter 19, Problem 34AP
To determine
The specific heat of the liquid.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Four closed tanks, A, B, C, and D, each contain an ideal gas. The table gives the absolute pressure and volume of the gas in each tank. In each case, there is 0.17 mol of gas. Using this number and the data in the table, compute the temperature of the gas in each tank.
A sample of an ideal gas is in a tank of constant volume. The sample absorbs heat energy so that its temperature changes from 300 K to 600 K. If v1 is the average speed of the gas molecules before the absorption of heat and v, is their average speed after the absorption of heat, what is the ratio v2/ v1 ?
You do an experiment in which you transfer energy to 1.2 moles of a gas and measure it’s change in temperature. You make a graph of the data as shown. The y-axis is the amount of energy added and the x-axis is the temperature.
A) how many moles per molecule does this substance have?
B) is the substance most likely a monatomic gas, diatomic or another type of gas?
Chapter 19 Solutions
Physics:f/sci.+engrs.,ap Ed.
Ch. 19.2 - Prob. 19.1QQCh. 19.3 - Suppose the same process of adding energy to the...Ch. 19.5 - Prob. 19.3QQCh. 19.5 - Characterize the paths in Figure 19.12 as...Ch. 19.6 - Prob. 19.5QQCh. 19 - Prob. 1PCh. 19 - The highest waterfall in the world is the Salto...Ch. 19 - Prob. 3PCh. 19 - The temperature of a silver bar rises by 10.0C...Ch. 19 - You are working in your kitchen preparing lunch...
Ch. 19 - If water with a mass mk at temperature Tk is...Ch. 19 - An aluminum calorimeter with a mass of 100 g...Ch. 19 - An electric drill with a steel drill bit of mass m...Ch. 19 - A 3.00-g copper coin at 25.0C drops 50.0 m to the...Ch. 19 - How much energy is required to change a 40.0-g ice...Ch. 19 - Prob. 11PCh. 19 - A 3.00-g lead bullet at 30.0C is fired at a speed...Ch. 19 - In an insulated vessel, 250 g of ice at 0C is...Ch. 19 - Prob. 14PCh. 19 - One mole of an ideal gas is warmed slowly so that...Ch. 19 - (a) Determine the work done on a gas that expands...Ch. 19 - A thermodynamic system undergoes a process in...Ch. 19 - Why is the following situation impossible? An...Ch. 19 - A 2.00-mol sample of helium gas initially at 300...Ch. 19 - (a) How much work is done on the steam when 1.00...Ch. 19 - A 1.00-kg block of aluminum is warmed at...Ch. 19 - In Figure P19.22, the change in internal energy of...Ch. 19 - A student is trying to decide what to wear. His...Ch. 19 - A concrete slab is 12.0 cm thick and has an area...Ch. 19 - Two lightbulbs have cylindrical filaments much...Ch. 19 - Prob. 26PCh. 19 - (a) Calculate the R-value of a thermal window made...Ch. 19 - Prob. 28PCh. 19 - Gas in a container is at a pressure of 1.50 atm...Ch. 19 - Prob. 30APCh. 19 - You have a particular interest in automobile...Ch. 19 - You are working in a condensed-matter laboratory...Ch. 19 - Prob. 33APCh. 19 - Prob. 34APCh. 19 - Prob. 35APCh. 19 - Prob. 36APCh. 19 - An ice-cube tray is filled with 75.0 g of water....Ch. 19 - Prob. 38APCh. 19 - An iron plate is held against an iron wheel so...Ch. 19 - One mole of an ideal gas is contained in a...Ch. 19 - Prob. 41APCh. 19 - Prob. 42APCh. 19 - Prob. 43APCh. 19 - A student measures the following data in a...Ch. 19 - (a) The inside of a hollow cylinder is maintained...Ch. 19 - A spherical shell has inner radius 3.00 cm and...Ch. 19 - Prob. 47CP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A sealed cubical container 20.0 cm on a side contains a gas with three times Avogadros number of neon atoms at a temperature of 20.0C. (a) Find the internal energy of the gas. (b) Find the total translational kinetic energy of the gas. (c) Calculate the average kinetic energy per atom, (d) Use Equation 10.13 to calculate the gas pressure. (e) Calculate the gas pressure using the ideal gas law (Eq. 10.8).arrow_forwardIf a gas is compressed isothermally, which of the following statements is true? (a) Energy is transferred into the gas by heat. (b) No work is done on the gas. (c) The temperature of the gas increases. (d) The internal energy of the gas remains constant. (e) None of those statements is true.arrow_forwardA flow calorimeter is a device used to measure the specific heat of a liquid. Energy is added as heat at a known rate to a stream of the liquid as it passes through the calorimeter at a known rate. Measurement of the resulting temperature difference between the inflow and the outflow points of the liquid stream enables us to compute the specific heat of the liquid. Suppose a liquid of density 0.86 g/cm³ flows through a calorimeter at the rate of 8.1 cm³/s. When energy is added at the rate of 200 W by means of an electric heating coil, a temperature difference of 18°C is established in steady-state conditions between the inflow and the outflow points. What is the specific heat of the liquid? Number i Unitsarrow_forward
- A flow calorimeter is a device used to measure the specific heat of a liquid. Energy is added as heat at a known rate to a stream of the liquid as it passes through the calorimeter at a known rate. Measurement of the resulting temperature difference between the inflow and the outflow points of the liquid stream enables us to compute the specific heat of the liquid. Suppose a liquid of density 0.85 g/cm3 flows through a calorimeter at the rate of 8.0 cm3/s.When energy is added at the rate of 250 W by means of an electric heating coil, a temperature difference of 15 C is established in steady-state conditions between the inflow and the outflow points.What is the specific heat of the liquid?arrow_forwardTwo containers hold ideal gases at the same temperature.Container A has twice the volume and half the number of molecules as container B. What is the ratio PA>PB, where PA is the pressure in container A and PB is the pressure in container B?arrow_forwardProblem 2: The enthalpy of a system is given by the equation H = U + PV where U is the internal energy, P = pressure, and V = volume. In addition, the internal energy, U = Q + W where Q is the heat and W is the work. Suppose we want to find the rate of change in the enthalpy at constant pressure of 1.25 atm, what is the value when heat is absorbed by the system at a rate of 45 J/s and work is done by the system at a rate of 100 J/s when the change of volume is rated at 35 x 105 m/s? 1. What is the change in heat with respect to time? 2. What is the change in internal energy of the system with respect to time? 3. What is the change in enthalpy of the system with respect to time?arrow_forward
- Samples A and B are at different initial temperatures when they are placed in a thermally insulated container and allowed to come to thermal equilibrium. Figure (a) gives their temperatures T versus time t. Sample A has a mass of 4.96 kg; sample B has a mass of 1.35 kg. Figure (b) is a general plot for the material of sample B. It shows the temperature change AT that the material undergoes when energy is transferred to it as heat Q. The change AT is plotted versus the energy Q per unit mass of the material, and the scale of the vertical axis is set by AT, = 4.80 °C. What is the specific heat of sample A? 100 AT, 60 20 10 20 8. 16 t (min) Q/m (kJ/kg) (a) (b)arrow_forwardAn oxygen tank has a volume of 100 ft3. When one pound of gas is expelled from the tank, the temperature drops from 80°F to 60°F while the pressure drops to 100psig. Assuming that the oxygen acts as an ideal gas, what is the pressure reading (psig) in the pressure gauge initially?arrow_forwardSamples A and B are at different initial temperatures when they are placed in a thermally insulated container and allowed to come to thermal equilibrium. Figure (a) gives their temperatures T versus time t. Sample A has a mass of 5.37 kg; sample B has a mass of 1.64 kg. Figure (b) is a general plot for the material of sample B. It shows the temperature change AT that the material undergoes when energy is transferred to it as heat Q. The change AT is plotted versus the energy Q per unit mass of the material, and the scale of the vertical axis is set by AT, = 4.10 °C. What is the specific heat of sample A? 100 AT A 60 20 10 20 8. 16 t (min) Q/m (kJ/kg) (a) (b) Number i Units T (°C) AT (C°)arrow_forward
- Consider an ideal gas with an absolute temperature of T1. To A) what temperature would the gas need to be heated to double it’s pressure? Express the answer in terms of T1 B) consider an ideal gas with a volume of V1. To what volume would the gas need to be compressed to double it’s pressure? Express the answer in terms of V1arrow_forwardSamples A and B are at different initial temperatures when they are placed in a thermally insulated container and allowed to come to thermal equilibrium. Figure (a) gives their temperatures T versus time t. Sample A has a mass of 4.79 kg; sample B has a mass of 1.50 kg. Figure (b) is a general plot for the material of sample B. It shows the temperature change AT that the material undergoes when energy is transferred to it as heat Q. The change AT is plotted versus the energy Q per unit mass of the material, and the scale of the vertical axis is set by AT, = 4.50 °C. What is the specific heat of sample A? Number i T (°C) 100 60 20 0 A Units 10 t (min) (a) 20 AT (Cº) AT, 0 8 Q/m (kJ/kg) (b) 16arrow_forwardThe data in the following table are from a constant volume gas thermometer experiment. The volume of the gas was kept constant, while the temperature was changed. The resulting pressure was measured. T (°C) P (atm) 0 1.00 20 1.07 100 1.37 −33 0.88 −196 0.28 Based on these data, estimate the value of absolute zero in Celsius by plotting the data on a pressure vs. temperature diagram.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
Thermodynamics: Crash Course Physics #23; Author: Crash Course;https://www.youtube.com/watch?v=4i1MUWJoI0U;License: Standard YouTube License, CC-BY