Loose Leaf for Engineering Circuit Analysis Format: Loose-leaf
9th Edition
ISBN: 9781259989452
Author: Hayt
Publisher: Mcgraw Hill Publishers
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 2, Problem 38E
Refer to the circuit represented in Fig. 2.35, while noting that the same current flows through each element. The voltage-controlled dependent source provides a current which is five times as large as the voltage Vx. (a) For VR = 10 V and Vx = 2 V, determine the power absorbed by each element. (b) Is element A likely a passive or active source? Explain.
FIGURE 2.35
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A 500 W heating coil, designed to operate at 110V, it is made of 0.500mm diameter nichrome wire. a) If the resistivity of nichrome remains constant at 20.0 ° C, determine the length of the wire used. b) What will be the power given to the coil from part (a) when heated to 1200 ° C? c) If the electric company charges B/0.16 per kW-h, how much you will have to pay to keep the heating coil working at this temperature for 45 minutes?
Assuming a global population of 9 billion people, each using approximately 100 W of power continuously throughout the day, calculate the total land area that would have to be set aside for photovoltaic power generation, assuming 800 W/m2 of incident solar power and a conversion efficiency (sunlight to electricity) of 10%.
The total land area that would have to be set aside for photovoltaic power generation is km2.
Suppose the cost of an incandescent bulb is 28 cents and that electricity costs 10.5 cents/kWh. Compact fluorescent lightbulbs (CFL), while they are more expensive, use 1/10 of the power for the same amount of illumination.
What would be the maximum cost (in dollars) of a CFL such that the total cost (investment plus operating) would be the same for both CFL and incandescent 60 W bulbs? Assume both lightbulbs run for 1000 h.
Chapter 2 Solutions
Loose Leaf for Engineering Circuit Analysis Format: Loose-leaf
Ch. 2.1 - A krypton fluoride laser emits light at a...Ch. 2.1 - A typical incandescent reading lamp runs at 60 W....Ch. 2.2 - In the wire of Fig. 2.7, electrons are moving left...Ch. 2.2 - For the element in Fig. 2.11, v1 = 17 V. Determine...Ch. 2.2 - Prob. 6PCh. 2.2 - Determine the power being generated by the circuit...Ch. 2.2 - Determine the power being delivered to the circuit...Ch. 2.2 - Your rechargeable smartphone battery has a voltage...Ch. 2.3 - Find the power absorbed by each element in the...Ch. 2.4 - Prob. 11P
Ch. 2.4 - Prob. 12PCh. 2.4 - The power absorbed by the resistor if i = 3 nA and...Ch. 2 - Convert the following to engineering notation: (a)...Ch. 2 - Convert the following to engineering notation:...Ch. 2 - Prob. 3ECh. 2 - Prob. 4ECh. 2 - Convert the following to SI units, taking care to...Ch. 2 - Prob. 6ECh. 2 - It takes you approximately 2 hours to finish your...Ch. 2 - A certain krypton fluoride laser generates 15 ns...Ch. 2 - Your recommended daily food intake is 2500 food...Ch. 2 - An electric vehicle is driven by a single motor...Ch. 2 - Under insolation conditions of 500 W/m2 (direct...Ch. 2 - A certain metal oxide nanowire piezoelectricity...Ch. 2 - Assuming a global population of 9 billion people,...Ch. 2 - The total charge flowing out of one end of a small...Ch. 2 - Prob. 15ECh. 2 - The total charge stored on a 1 cm diameter...Ch. 2 - A mysterious device found in a forgotten...Ch. 2 - A new type of device appears to accumulate charge...Ch. 2 - The current flowing through a tungsten-filament...Ch. 2 - The current waveform depicted in Fig. 2.28 is...Ch. 2 - The current waveform depicted in Fig. 2.29 is...Ch. 2 - A wind power system with increasing windspeed has...Ch. 2 - Two metallic terminals protrude from a device. The...Ch. 2 - The convention for voltmeters is to use a black...Ch. 2 - Determine the power absorbed by each of the...Ch. 2 - Determine the power absorbed by each of the...Ch. 2 - Determine the unknown current for the circuit in...Ch. 2 - A constant current of 1 ampere is measured flowing...Ch. 2 - Determine the power supplied by the leftmost...Ch. 2 - The currentvoltage characteristic of a silicon...Ch. 2 - A particular electric utility charges customers...Ch. 2 - The Tilting Windmill Electrical Cooperative LLC...Ch. 2 - A laptop computer consumes an average power of 20...Ch. 2 - You have just installed a rooftop solar...Ch. 2 - Prob. 35ECh. 2 - Some of the ideal sources in the circuit of Fig....Ch. 2 - Prob. 37ECh. 2 - Refer to the circuit represented in Fig. 2.35,...Ch. 2 - Prob. 39ECh. 2 - Prob. 40ECh. 2 - Prob. 41ECh. 2 - Determine the magnitude of the current flowing...Ch. 2 - Real resistors can only be manufactured to a...Ch. 2 - (a) Sketch the current-voltage relationship...Ch. 2 - Prob. 45ECh. 2 - Figure 2.38 depicts the currentvoltage...Ch. 2 - Examine the I-V characteristics in Fig. 2.38....Ch. 2 - Determine the conductance (in siemens) of the...Ch. 2 - Determine the magnitude of the current flowing...Ch. 2 - A 1% tolerance 1 k resistor may in reality have a...Ch. 2 - Utilize the fact that in the circuit of Fig. 2.39,...Ch. 2 - For the circuit in Fig. 2.39, suppose that the...Ch. 2 - For each of the circuits in Fig. 2.40, find the...Ch. 2 - Sketch the power absorbed by a 100 resistor as a...Ch. 2 - You built an android that has a subcircuit...Ch. 2 - Using the data in Table 2.4, calculate the...Ch. 2 - Prob. 58ECh. 2 - Prob. 59ECh. 2 - Prob. 60ECh. 2 - The resistance values in Table 2.4 are calibrated...Ch. 2 - Prob. 62ECh. 2 - Prob. 63ECh. 2 - The network shown in Fig. 2.42 can be used to...Ch. 2 - Prob. 65ECh. 2 - An LED operates at a current of 40 mA, with a...Ch. 2 - You have found a way to directly power your wall...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- A barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder. The resistance of which is 0.0078 ohm per 1,000 ft the bus bar voltage is maintained constant at 600V. Determine the load current.arrow_forward1. Assume that on a sunny summer day, the solar panel delivers its rated (midday) current for the equivalent of 6 hours. If you assume the 200 Ah deep cycle battery begins the day of solar charging (0 hours) at 30% capacity (i.e. with 60 Ah of stored charge), how many Amp-hours are stored in the battery at the end of the first day of charging (i.e. after 6 hours)?arrow_forwarda) Assume that on a sunny summer day, the solar panel delivers its rated (midday) current for the equivalent of 6 hours. If you assume the 200 Ah deep cycle battery begins the day of solar charging (0 hours) at 30% capacity (i.e. with 60 Ah of stored charge), how many Amp-hours are stored in the battery at the end of the first day of charging (i.e. after 6 hours)? b)Overnight, the solar panel produces zero current, but its shunt resistance remains connected. Calculate the stored charge in the battery at the beginning of the next day of charging (i.e. after 24 hours). Perform calculations and use circuit simulation software (supported by screenshots) to verify your design.arrow_forward
- A 250 V, 1.5 kW single element electric furnace is to employ a nichrome wire operating at 900°C. Estimate a suitable diameter and lengh of wire.Assume radiating efficiency = 1, emissivity=0.9, resistivity = 1.1 x 10^-6 ohm Ambient temperature = 30°C.arrow_forwardAn overhead power line travels 10km to supply a factory with 10MW of power (1MW = 1 × 106 W ). If the power line reaches the factory at 60 kV , what radius should it have so that it dissipates 1% of the power delivered (1% of 10MW)? Take the wire to be made out of copper with ρ = 1.68 × 10−8 Ω · m.arrow_forwardSubject: Renewable Energy System Describe the following; 1. Distributed Flexible Load 2.Secondary Storage Batteryarrow_forward
- Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a distance of 16 miles. A power link is to be established between them. The power link delivers a maximum power of 584 megawatts at full capacity with an operating voltage of 580 kilovolts. Note that 1 mile is 1.6 kilometers. Solve for the resistivity (in ohm-micrometers) of the cable asusming a conductor diameter of 1.55 centimeters.arrow_forwardThe resistance of a coil aluminum wire at 21OC is 210Ω. The temperature of the wire is increased and the resistance rises to 240Ω. If the coefficient of resistance of aluminum is 0 .0039/OC at 21OC, determine the temperature to which the coil has risen.arrow_forwardA static electrical device has 2000 turns uses 4000 mA from the supply connected to a laptop whichhas a power of 20 V, 1000 W. How can you find the amount of current used by the laptop? Identify suchstatic electrical device used and evaluate supply voltage taken by it. Which category does it belong basedon its ability to change voltage? Practical efficiency of such electrical device is less than 100 %. Justifywith reasons. What are possible ways to improve its efficiency?arrow_forward
- 1.What happens to the current in a circuit with a resistance of 50ohms is removed and replaced by 100 ohms? 2.A 6.8A-current passes a bulb. Find the charge in coulombs used by the lamp in 1 min. 3.How long will it take for 2.51 L of a 0.52 M CuSO4 solution being electrolyzed with a current of 4.30 A to reach a concentration of 0.1 M? 4.Calculate the emf of the cell in which the following reaction takes place: Ni(s) + 2Ag+ (0.005 M) = Ni2+ (0.170 M) + 2Ag(s). Given that (cell) EV = 1.05 V.arrow_forward.A secondary battery containing Li and Lead acid weighing 60 g that operates continuously through 16 ohms resistance for 300 min .The initial voltage is 3.60 V and the effective voltage over the whole life of the battery is taken to be 1.00.Theoretically, how many miles above the earth could thus battery be raised by the energy delivered under these conditions?arrow_forwardConsider a 250 Wp rated monocrystalline PV module. It results from a manufacturing process that consumes 10kWh/Wp of energy. Assume that the PV module is used in a location with an average annual PV yield of 500 kWh. Its lifetime is 20 years. a) Determine the total energy consumed during the production of the module. b) Calculate the energy yield ratio of the PV module over its lifetime of 20 years. c) What is the energy payback period of the PV module?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,
Introductory Circuit Analysis (13th Edition)
Electrical Engineering
ISBN:9780133923605
Author:Robert L. Boylestad
Publisher:PEARSON
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Programmable Logic Controllers
Electrical Engineering
ISBN:9780073373843
Author:Frank D. Petruzella
Publisher:McGraw-Hill Education
Fundamentals of Electric Circuits
Electrical Engineering
ISBN:9780078028229
Author:Charles K Alexander, Matthew Sadiku
Publisher:McGraw-Hill Education
Electric Circuits. (11th Edition)
Electrical Engineering
ISBN:9780134746968
Author:James W. Nilsson, Susan Riedel
Publisher:PEARSON
Engineering Electromagnetics
Electrical Engineering
ISBN:9780078028151
Author:Hayt, William H. (william Hart), Jr, BUCK, John A.
Publisher:Mcgraw-hill Education,
What is an electric furnace and how does it work?; Author: Fire & Ice Heating and Air Conditioning Inc;https://www.youtube.com/watch?v=wjAWecPGi0M;License: Standard Youtube License