General Physics, 2nd Edition
2nd Edition
ISBN: 9780471522782
Author: Morton M. Sternheim
Publisher: WILEY
expand_more
expand_more
format_list_bulleted
Videos
Question
Chapter 20, Problem 31E
(a)
To determine
The magnetic force on a charge
(b)
To determine
The work done on the charge.
(c)
To determine
The comparison of the EMF found using the equation
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
The drawing shows a type of flow meter that can be used to measure the speed of blood in situations when a blood vessel is sufficiently exposed (e.g., during surgery). Blood is conductive enough that it can be treated as a moving conductor. When it flows perpendicularly with respect to a magnetic field, as in the drawing, electrodes can be used to measure the small voltage that develops across the vessel. Suppose the speed of the blood is 0.35 m/s and the diameter of the vessel is 7.6 mm. In a 0.22-T magnetic field what is the magnitude of the voltage that is measured with the electrodes in the drawing?
Consider the systempictured in Figure P19.31.A 15 - cm length of conductorof mass 15 g, free tomove vertically, is placedbetween two thin, verticalconductors, and a uniformmagnetic field acts perpendicularto the page. When a5.0 - A current is directed asshown in the figure, the horizontalwire moves upward atconstant velocity in the presenceof gravity. (a) What forces act on the horizontal wire, andunder what condition is the wire able to move upward at constantvelocity? (b) Find the magnitude and direction of theminimum magnetic field required to move the wire at constantspeed. (c) What happens if the magnetic field exceedsthis minimum value? (The wire slides without friction on thetwo vertical conductors.)
In the figure below, R1 =10.0kΩ, R2 =15.0kΩ, C=0.40μF, and the ideal battery has an emf E=20.0V. First, the switch is closed until the system reaches steady state; then, the switch is opened at time t = 0 and the capacitor starts to discharge. What is the current in R2 at t = 3.00 ms?
Chapter 20 Solutions
General Physics, 2nd Edition
Ch. 20 - Prob. 1RQCh. 20 - Prob. 2RQCh. 20 - Prob. 3RQCh. 20 - Prob. 4RQCh. 20 - Prob. 5RQCh. 20 - Prob. 6RQCh. 20 - Prob. 7RQCh. 20 - Prob. 8RQCh. 20 - Prob. 9RQCh. 20 - Prob. 10RQ
Ch. 20 - Prob. 11RQCh. 20 - Prob. 12RQCh. 20 - Prob. 13RQCh. 20 - Prob. 1ECh. 20 - Prob. 2ECh. 20 - Prob. 3ECh. 20 - Prob. 4ECh. 20 - Prob. 5ECh. 20 - Prob. 6ECh. 20 - Prob. 7ECh. 20 - Prob. 8ECh. 20 - Prob. 9ECh. 20 - Prob. 10ECh. 20 - Prob. 11ECh. 20 - Prob. 12ECh. 20 - Prob. 13ECh. 20 - Prob. 14ECh. 20 - Prob. 15ECh. 20 - Prob. 16ECh. 20 - Prob. 17ECh. 20 - Prob. 18ECh. 20 - Prob. 19ECh. 20 - Prob. 20ECh. 20 - Prob. 21ECh. 20 - Prob. 22ECh. 20 - Prob. 23ECh. 20 - Prob. 24ECh. 20 - Prob. 25ECh. 20 - Prob. 26ECh. 20 - Prob. 27ECh. 20 - Prob. 28ECh. 20 - Prob. 29ECh. 20 - Prob. 30ECh. 20 - Prob. 31ECh. 20 - Prob. 32ECh. 20 - Prob. 33ECh. 20 - Prob. 34ECh. 20 - Prob. 35ECh. 20 - Prob. 36ECh. 20 - Prob. 37ECh. 20 - Prob. 38ECh. 20 - Prob. 39ECh. 20 - Prob. 40ECh. 20 - Prob. 41ECh. 20 - Prob. 42ECh. 20 - Prob. 43ECh. 20 - Prob. 44ECh. 20 - Prob. 45ECh. 20 - Prob. 46ECh. 20 - Prob. 47ECh. 20 - Prob. 48ECh. 20 - Prob. 49ECh. 20 - Prob. 50ECh. 20 - Prob. 51ECh. 20 - Prob. 52ECh. 20 - Prob. 53ECh. 20 - Prob. 54ECh. 20 - Prob. 55ECh. 20 - Prob. 56ECh. 20 - Prob. 57ECh. 20 - Prob. 58ECh. 20 - Prob. 59ECh. 20 - Prob. 60ECh. 20 - Prob. 61ECh. 20 - Prob. 62ECh. 20 - Prob. 63ECh. 20 - Prob. 64ECh. 20 - Prob. 65ECh. 20 - Prob. 66ECh. 20 - Prob. 67ECh. 20 - Prob. 68ECh. 20 - Prob. 69ECh. 20 - Prob. 70ECh. 20 - Prob. 71ECh. 20 - Prob. 72ECh. 20 - Prob. 73ECh. 20 - Prob. 74ECh. 20 - Prob. 75ECh. 20 - Prob. 76ECh. 20 - Prob. 77ECh. 20 - Prob. 78ECh. 20 - Prob. 79ECh. 20 - Prob. 80ECh. 20 - Prob. 81ECh. 20 - Prob. 82ECh. 20 - Prob. 83ECh. 20 - Prob. 84ECh. 20 - Prob. 85ECh. 20 - Prob. 86ECh. 20 - Prob. 87ECh. 20 - Prob. 88ECh. 20 - Prob. 89ECh. 20 - Prob. 90ECh. 20 - Prob. 91ECh. 20 - Prob. 92ECh. 20 - Prob. 93ECh. 20 - Prob. 94ECh. 20 - Prob. 95E
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- An accelerating voltage of 2.50 x 103 V is applied to an electron gun, producing a beam of electrons originally traveling horizontally north in vacuum toward the center of a viewing screen 35.0 cm away. What are (a) the magnitude and (b) the direction of the deflection on the screen caused by the Earth’s gravitational field? What are (c) the magnitude and (d) the direction of the deflection on the screen caused by the vertical component of the Earth’s magnetic field, taken as 20.0 μT down? (e) Does an electron in this vertical magnetic field move as a projectile, with constant vector acceleration perpendicular to a constant northward component of velocity? (f) Is it a good approximation to assume it has this projectile motion? Explain.arrow_forwarda 2.50m segment of wire supplying current to the motor of a submarine carries 1000 A and feels a 4.00 N repulsive force froma parallel wire 5.00 cm away. What is the direction and magnitude of the current in the other wire?arrow_forwardA 2.40 m segment of wire supplying current to the motor of a submerged submarine carries 1500 A and feels a 2N repulsive force from a parallel wire 3.50cm away. What is the direction and magnitude (in A) of the current in the other wire?arrow_forward
- The cables that connect the starting motor of a car with its battery are 1.0 cm apart for a distance of 40.0 cm. Find the magnitude of the force between the cables when the current in them is 300.0 A.arrow_forwardWhich of the following properties is found only in ferromagnetic materials ? A) Susceptibility independent of temperature B) Point in a particular direction C) Hysteresis D) Attracting a magnetic substancearrow_forwardA 4 m long conductor carrying a current of 10 A in the moon direction lies on the y axis between y = ± 2 m. If area B = 0.05ax T, find the work done by moving the conductor at constant speed x = z = 2 m parallel to itself. A. 2 JB. NoneC. 0 JD. 6 JE. 4 Jarrow_forward
- A 2.4 m segment of wire supplying current to the motor of a submerged submarine carries 950 A and feels a 3.9 N repulsive force from a parallel wire 5.00 cm away. What is the magnitude of the current in the other wire in A?arrow_forwardIt is desired to construct a solenoid that will have a resistance of 4.95 Ω (at 20°C) and produce a magnetic field of 4.00 ✕ 10−2 T at its center when it carries a current of 4.75 A. The solenoid is to be constructed from copper wire having a diameter of 0.500 mm. If the radius of the solenoid is to be 1.00 cm, determine the following. (The resistivity of copper at 20°C is 1.7 ✕ 10−8 Ω · m.) (a) the number of turns of wire needed to build the solenoid turns (b) the length the solenoid should have cmarrow_forwardFor a magnetic field to create an electric current in a circuit, it is necessary that: a. the circuit is placed perpendicular to the field b. The flux through the circuit surface varies with time. c. the circuit remains stationary at all times d. the flux through the surface of the circuit is zeroarrow_forward
- At what speed must the sliding rod in Figure 23.11 move to produce an emf of 1.00 V in a 1.50 T field, given the rod’s length is 30.0 cm?arrow_forward1: 1: A mass spectrometer is being used to separate common oxygen-16 from the much rarer oxygen-18, taken from a sample of old glacial ice. (The relative abundance of these oxygen isotopes is related to climatic temperature at the time the ice was deposited.) The ratio of the masses of these two ions is 16 to 18, the mass of oxygen-16 is 2.66 ✕ 10−26 kg, and they are singly charged and travel at 7.50 ✕ 106 m/s in a 2.00 T magnetic field. What is the separation (in m) between their paths when they hit a target after traversing a semicircle? _______m (resubmitting question, 0.0778m is an incorrect answer)arrow_forwardA circular loop made of copper wire with a diameter 0.96 mm is placed in a uniform magnetic field 0.274 T with field lines directed perpendicular to the loop plane. The shape of the loop is changed from circular to a square one. Find the total charge that flows in the conductor if the radius of the circular loop is 0.1 m. Use the copper resistivity 1.68E-8 Ohm⋅m.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Glencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
What is Electromagnetic Induction? | Faraday's Laws and Lenz Law | iKen | iKen Edu | iKen App; Author: Iken Edu;https://www.youtube.com/watch?v=3HyORmBip-w;License: Standard YouTube License, CC-BY