Sustainable Energy
1st Edition
ISBN: 9781133108689
Author: Richard A. Dunlap
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Determine the mass flow rate of fuel from the gasoline tank to the car’s fuel injection system. Assume that the gasoline consumption of the car is 8.5 km/L when the car is moving at 90 km/h. Use the specific gravity value of 0.72 for the gasoline.
Civil engineering: Energy
Please solve the problem clearly , don't use previously solved solutions.
I am asking this for a second time.
Hope you understand
Question:
The atmosphere is stable with a lapse rate of -0.2 degree C/100 m. The surfaces air temperature is 15 degree C. A parcel of air is released at the ground with a temperature of 25 degree C. Calculate the maximum mixing height, in m.
The design fluid (typically water and antifreeze) flow rate through a solar hot-water heater system is (1 L/s) m ⁄m2 . If a system runs continuously for 3 hours and makes use of two solar panels (each 2 m×4 m) , what is the total volume of the fluid that goes through the collector during this period? Express your answer in liters and m3 .
Chapter 20 Solutions
Sustainable Energy
Knowledge Booster
Similar questions
- the reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. if the tank is 30 cm. deep, and is contaminated with 3.42 cm. of water at the bottom, how many meters of air remains at the top when the gage indicates "FULL"? use weight of: gasoline = 6.62 kN/m^3; air = 14.67 N/m^3. the tank is closed.arrow_forwardThe figure below shows a pump delivering 0.014 m3/s of crude oil (SG = 0.85) from an underground storage drum to the first stage of a processing system. (a) If the total energy loss in the system is , calculate the power added by the pump in kW. (b) If the power input to the pump is 16.5 kW, what is the mechanical efficiency of the pump?arrow_forwardA balloon filled with hydrogen gas has a volume of 5200 cubic centimeters at 44 degrees Celsius and 9.0 x 104 Pa. What volume (in liters) does the H2 occupy at standard temperature and pressure(STP).arrow_forward
- Calculate the pressure on 1.00 lb mol of Nitrogen gas ,N2, contained in a 100 ft^3 container at 70 degree Fahrenheitarrow_forwardA 0.8 lbm object traveling at 200 ft/sec enters a viscous liquid and is essentially brought to rest before it strikes the bottom. What is the increase in internal energy, taking the object and the liquid as the system? Neglect the potential energy change.arrow_forwardDetermine the energy consumption (BTU/min), If two 50-kg LPG tanks are needed per 24-hour operation, heating value for the LPG of 11,000 kcal/kg. Subject: Civil Engineering: Thermodynamicsarrow_forward
- 1) Heating the water in a 55-gallon water heater requires about 2.0 x 103 kJ of energy. a) Assume the energy came from natural gas with 80% efficiency; how many grams of natural gas are required? b) Assume the energy came from electricity with 80% efficiency and that the electricity was produced from the combustion of coal with 30% efficiency; how many grams of coal are required? For problem above, calculate how much CO2 in grams is emitted to the atmosphere. For a: Use the balanced equation for the combustion of methane (CH4) to determine how many grams of CO2are produced from the amount of natural gas required. For b: Assume that coal produces 5.25 kJ of energy per gram of CO2 produced. Calculate how much CO2 in grams is produced.arrow_forwardReplacing incandescent lights with energy-efficient fluorescent lights can reduce the lighting energy consumption to one-fourth of what it was before. The energy consumed by the lamps is eventually converted to heat, and thus switching to energy-efficient lighting also reduces the cooling load in summer but increases the heating load in winter. Consider a building that is heated by a natural gas furnace with an efficiency of 80 percent and cooled by an air conditioner with a COP of 3.5. If electricity costs $0.12/kWh and natural gas costs $1.40/therm (1 therm = 105,500 kJ), determine if efficient lighting will increase or decrease the total energy cost of the building (a) in summer and (b) in winter.arrow_forwarda) Calculate the partial pressure of oxygen in the air at 100 kPa if nitrogen has a partial pressure of 82 kPa and carbon dioxide and water combined have a partial pressure of 0.77 kPa. b) A container of compressed helium has in it 15.0 L pressurized to about 2250 kPa at 24.5°C. How many moles of helium are in the container? c) i) Determine the volume of oxygen gas required to completely combust 5.5 mol of propane (C3H8) in a barbecue at 101.3 kPa and 28.0°C. ii) What mass of helium would be required to fill a balloon to 6.8 L at 100 kPa and 25°C?arrow_forward
- The Energy Efficiency Rating (EER) of an air-conditioning unit is defined asthe ratio of the heat removed in Btu/h divided by the energy used in watts.The EEI (Edison Electric Institute) names an air-conditioning unit as anEnergy Star unit if it has an EER of 13 or greater. A 21⁄2-ton air-conditioningunit uses 2.41 kilowatts (2,410 watts) of energy. One ton is equivalent to12,000 Btu/h. Can this unit be termed an Energy Star unit?arrow_forwardEach month the Speedy Dry Cleaning Company buys 1 barrel (0.160 m3) of dry cleaning fluid. Ninety percent of the fluid is lost to the atmosphere and 10 percent remains as residue to be disposed of. The density of the dry cleaning fluid is 1.5940 g/mL. Draw a mass balance diagram and estimate the monthly mass emission rate to the atmosphere in kg/moarrow_forwardThe system in Figure 2-5 is at 20oC. If atmospheric pressure is 101.03 kPa and the absolute pressure at the bottom of the tank is 231.3 kPa, what is the specific gravity of olive oil? Note: density of water=9.79 kN/m3 (specific gravity SAE oil is 0.89, h SAE oil is 1.5m, h water is 2.5m, H olive oil is 2.9m, h mercury is 0.4m, specific gravity mercury is 13.6 ) and use g=9.79m/s2. a) 1.39 b) 1.29 c) 1.49 d) 1.59 e) none of the abovearrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning
Engineering Fundamentals: An Introduction to Engi...
Civil Engineering
ISBN:9781305084766
Author:Saeed Moaveni
Publisher:Cengage Learning