You are working as an expert witness for an environmental agency. A utility in a neighboring town has proposed a new power plant that produces electrical power P from turbines. The utility claims that the plant will take in steam at temperature Th and reject water at temperature Tc into a flowing cold-water river. The flow rate of the river is Δm/Δt. The agency supervisor is concerned about the effect of dumping warm water on the fish in the river. (a) The utility claims that the power plant operates with Carnot efficiency. With that assumption, you need to determine for a trial presentation by how much the temperature of the water downstream from the power plant will rise due to the rejected energy from the power plant. (b) If you abandon the utility’s claim that the power plant operates at Carnot efficiency and assume a more realistic efficiency e, you need to determine the increase in water temperature in the stream. (c) Finally, you need to testify whether the increase in water temperature in part (b) will be higher or lower than that found in part (a).
Want to see the full answer?
Check out a sample textbook solutionChapter 21 Solutions
Physics:f/sci.+engrs.,ap Ed.
- Water at 15°C is to be pumped from a reservoir (zA = 2 m) to another reservoir at a higher elevation (zB = 9 m) through two 25-m-long plastic pipes connected in parallel. The diameters of the two pipes are 3 cm and 5 cm. Water is to be pumped by a 68 percent efficient motor–pump unit that draws 8 kW of electric power during operation. The minor losses and the head loss in the pipes that connect the parallel pipes to the two reservoirs are considered to be negligible. Determine the total flow rate between the reservoirs and the flow rates through each of the parallel pipes.arrow_forwardRefrigerant 134a enters a compressor with a mass flow rate of 5 kg/s and a negligible velocity. The refrigerant enters the compressor as a saturated vapor at 10°C and leaves the compressor at 1400 kPa with an enthalpy of 281.39 kJ/kg and a velocity of 50 m/s. The rate of work done on the refrigerant is measured to be 132.4 kW. If the elevation change between the compressor inlet and exit is negligible, determine the rate of heat transfer associated with this process, in kW.arrow_forwardIn a solar water heater, energy from the Sun is gathered by water that circulates through tubes in a rooftop collector.The solar radiation enters the collector through a transparent cover and warms the water in the tubes; this water is pumped into a holding tank. Assume that the efficiency of the overall system is 20% (that is, 80% of the incident solar energy is lost from the system). What collector area is necessary to raise the temperature of 200 L of water in the tank from 20C to 40°C in 1.0 h when the intensity of incident sunlight is 700 W/m2?arrow_forward
- An electrical power plant has an overall efficiency of 15%. The plant is to deliver 150 MW of electrical power to a city, and its turbines use coal as fuel. The burning coal produces steam at 190°C, which drives the turbines. The steam is condensed into water at 25°C by passing through coils that are in contact with river water. (a) How many metric tons of coal does the plant consume each day (1 metric ton = 1 × 103 kg)? (b) What is the total cost of the fuel per year if the delivery price is $8 per metric ton? (c) If the river water is delivered at 20°C, at what minimum rate must it flow over the cooling coils so that its temperature doesn’t exceed 25°C? Note: The heat of combustion of coal is 7.8 × 103 cal/g.arrow_forwardA 50 W electric heater (1 W = 1 J/s) operates for 10.0 minutes to heat a gas in a cylinder. At the same time, the gas expands from 6 to 12 L against to a constant pressure of 3.2 atm. Calculate for the amount of heat.arrow_forwardIn an industrial process, a fuel-air mixture is fitted with a piston. When the mixture is ignited at a constant pressure of 700mm Hg, 2.0 kJ of energy is released and is found to occupy a final volume of 200L. What would be the initial volume occupied by the mixture if all energy released is converted as work done by the system to push the piston?arrow_forward
- A nuclear power plant has a power output (i.e. output to do useful work) of 1505 MW and operates at an efficiency of 21.1%. The excess energy is carried away by a river which has a flow rate of 1.15e+6kg/s. What is the rise in temperature (C) of the river downstream?arrow_forwardConsider a water-to-water counter-flow heat exchanger with these specifications. Hot water enters at 95°C while cold water enters at 20°C. The exit temperature of hot water is 15°C greater than that of cold water, and the mass flow rate of hot water is 50 percent greater than that of cold water. The product of heat transfer surface area and the overall heat transfer coefficient is 1400 W/K. Taking the specific heat of both cold and hot water to be cp = 4180 J/kg·K, determine (a) the outlet temperature of the cold water, (b) the effectiveness of the heat exchanger, (c) the mass flow rate of the cold water, and (d) the heat transfer rate.arrow_forwardAs an engineer in an automotive company, you are assigned to design an engine with the highest possible efficiency to compete with other company. (a) What is the main thermodynamic principle you will use in designing the engine? (b) Using an appropriate graph, describe the thermal processes of your engine. (c) The competitor company claims to have constructed an engine that has an efficiency of 75% when operated between boiling and freezing temperatures of water. Is this possible? Give your comment.arrow_forward
- An inventor is claiming that she has developed a heat engine that can operate with a thermal efficiency of η = 37% while operating between high and low temperature thermal reservoirs at Th = 305 K and Tc = 260 K . Evaluate her claim. Is this claim possible? Yes or Noarrow_forwardA certain coal-fired power plant has a rated power capacity of P = 950 MW. The output of this plant is W = 0.25QH, where QH is the energy input as heat from the hot reservoir. a)Calculate the absolute value of the exhausted heat (QC) each second in MJ for the power plant. b)If the power plant operates for a full day at its rated capacity, how much energy QH in MJ is needed? c)If, on average, one ton of coal contains Q = 25 GJ of energy, how many tons nH of coal would the plant need to operate for a day at its rated capacity?arrow_forwardA 100-W lightbulb is placed in a cylinder equipped with a moveable piston. The lightbulb is turned on for 0.015 hour, and the assembly expands from an initial volume of 0.85 L to a final volume of 5.88 L against an external pressure of 1.0 atm. Use the wattage of the lightbulb and the time it is on to calculate ΔE in joules (assume that the cylinder and lightbulb assembly is the system and assume two significant figures). Calculate w and q.arrow_forward
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON