Tutorials In Introductory Physics: Homework
1st Edition
ISBN: 9780130662453
Author: Lillian C. McDermott, Peter S. Shaffer
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 22.1, Problem 2aTH
Suppose that the radius of the loop were increasing. Use Lenz’ law to explain why there would be an induced current through the wire. Indicate the direction of that current.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Use Lenz’s Law to determine the direction of the induced currents in the following situations.
Show why the induced current in a wire can only be flowing in a particular direction.
. Sketch a graph of current value against time for two complete cycles of an
alternating current of peak value 2 A and frequency 0.5 Hz. Indicate with a
horizontal line on the graph the approximate value of the r.m.s current.
Chapter 22 Solutions
Tutorials In Introductory Physics: Homework
Ch. 22.1 - Use Lenz’ law to predict whether current will flow...Ch. 22.1 - For each of the cases in which you predicted that...Ch. 22.1 - Suppose that the radius of the loop were...Ch. 22.1 - Check your answer regarding the direction of the...Ch. 22.1 - Find: the direction of the magnetic moment of the...Ch. 22.1 - A copper wire loop is initially at rest in a...Ch. 22.2 - On the two diagrams below, indicate the direction...Ch. 22.2 - Suppose the loop were replaced by a second loop...Ch. 22.2 - Five loops of copper wire of same gauge...Ch. 22.2 - Five loops of copper wire of same gauge...
Additional Science Textbook Solutions
Find more solutions based on key concepts
A car leaves the road traveling at 110 km/h and hits a tree, coming to a stop in 0.14 s. What average force doe...
Essential University Physics (3rd Edition)
Freight trains can product only relatively small accelerations. (a) What is the final velocity of a freight tra...
University Physics Volume 1
Choose the best answer to each of the following. Explain your reasoning. How would a flashing red light apppear...
The Cosmic Perspective Fundamentals (2nd Edition)
Does relativity require that the speed of sound be the same for all observers? Why or why not?
Essential University Physics: Volume 2 (3rd Edition)
If you point the pinhole camera of Exercise 111 at the Sun, you will see a clear and bright solar image on the ...
Conceptual Integrated Science
Where (in the southern sky, on the eastern horizon, on the western horizon, high in the sky, etc.) would you l...
Lecture- Tutorials for Introductory Astronomy
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Use Lenz’s law to determine tl direction of induced current in each case.arrow_forwardIn the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?arrow_forwardThe normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially uniform magnetic field B. It has a fixed area and orientation relative to the magnetic fleck Show that the emf induced In the loop is given by i = (dB/dt)(Acos),where A is the area of the loop.arrow_forward
- The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?arrow_forwardA circular loop of wire of radius 10 cm. is mounted on a vertical shaft and rotated at a frequency of 5 cycles per second in a region of uniform magnetic field of 2104T perpendicular to the arcs of rotation, (a) Find an Expression for the time-dependent flux through the ring (b) Determine die time-dependent current through the ring if it has a resistance of 10.arrow_forwardCheck Your Understanding (a) What is the magnetic flux through one turn of a solenoid of self- inductance 8.0 × 10-5 H when a current of 3.0 A flows through it? Assume that the solenoid has 1000 turns and is wound from wire of diameter 1.0 mm. (b) What is the cross-sectional area of the solenoid?arrow_forward
- Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?arrow_forwardCheck Your Understanding A long solenoid of cross-section area 5.0 cm2is wound with 25 turns of wire pet centimeter. It is placed in the middle of a closely wrapped coil of 10 turns and radius 25 cm, as shown below. (a) What is the emfInduced In the coil when the current through the solenoid Is decreasing at a rate dl/dt= -0.20A/s? (b) What Is the electric field Induced In the coil?arrow_forwardDesign a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .arrow_forward
- A metal bar of mass 500 g slides outward at a constant speed of 1.5 cm/s over two parallel rails separated by a distance of 30 cm which are pail of a U-shaped conductor. There is a uniform magnetic field of magnitude 2 T pointing out of the page over the entire area. The railing and metal bar have an equivalent resistance of 150 . (a) Determine the induced current, both magnitude and direction, (b) Find the direction of tire induced current if the magnetic field is pointing into the page, (c) Find the direction of the induced current if the magnetic field is pointed into the page and the bar moves inwards.arrow_forwardA rectangular copper ring, of mass 100 g and resistance 0.2 1, is in a region of uniform magnetic field that is perpendicular to the area enclosed by the ring and horizontal to Earth’s surface. The ring is let go from rest when it is at the edge of the nonzero magnetic field region (see below). (a) Find its speed when the ring just exits the region of uniform magnetic field. (b) If it was let go at t = 0, what is the time when it exits the region of magnetic field for the following values: a=25cm,b=50cmB=3T , and g=9.8m/s2 ? Assume the magnetic field of the induced current is negligible compared to 3T.arrow_forwardA metal bar of mass m slides without friction over two rails a distance D apart in the region that has a uniform magnetic held of magnitude B0 and direction perpendicular to the rails (see below). The two rails are connected at one end to a resistor whose resistance is much larger than the resistance of the rails and the bar The bar is given an initial speed of vg. It is found to slow down. How far does the bar go before coming to rest? Assume that the magnetic held of the induced current is negligible compared to B0arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
Physics for Scientists and Engineers with Modern ...
Physics
ISBN:9781337553292
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
What is Electromagnetic Induction? | Faraday's Laws and Lenz Law | iKen | iKen Edu | iKen App; Author: Iken Edu;https://www.youtube.com/watch?v=3HyORmBip-w;License: Standard YouTube License, CC-BY