Concept explainers
Predict/Calculate Referring to Example 28-3 The
Want to see the full answer?
Check out a sample textbook solutionChapter 28 Solutions
Physics, Books a la Carte Edition (5th Edition)
Additional Science Textbook Solutions
Life in the Universe (4th Edition)
Physics for Scientists and Engineers with Modern Physics
Essential University Physics: Volume 2 (3rd Edition)
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
College Physics: A Strategic Approach (4th Edition)
An Introduction to Thermal Physics
- (a) What is the distance between the slits of a diffraction grating that produces a first-order maximum for the first Balmer line at an angle of 20.0°? (b) At what angle will the fourth line of the Balmer series appear in first order? (c) At what angle will the second-order maximum be for the first line?arrow_forwardThree discrete spectral lines occur at angles of 10.1, 13.7, and 14.8, respectively, in the first-order spectrum of a diffraction grating spectrometer. (a) If the grating has 3 660 slits/cm, what are the wavelengths of the light? (b) At what angles are these lines found in the second-order spectra?arrow_forwardWhen we studied Youngs double-slit experiment, we mostly ignored the dark fringe pattern produced by diffraction. Use Figure 35.21 to describe situations in which that omission makes sense. Think especially about the single slit used in front of the double slit in Youngs experiment (Fig. 35.9).arrow_forward
- Assume Figure 38.1 was photographed with red light of a single wavelength 0. The light passed through a single slit of width a and traveled distance L to the screen where the photograph was made. Consider the width of the central bright fringe, measured between the centers of the dark fringes on both sides of it. Rank from largest to smallest the widths of the central fringe in the following situations and note any cases of equality. (a) The experiment is performed as photographed. (b) The experiment is performed with light whose frequency is increased by 50%. (c) The experiment is performed with light whose wavelength is increased by 50%. (d) The experiment is performed with the original light and with a slit of width 2a. (e) The experiment is performed with the original light and slit and with distance 2L to the screen.arrow_forward(a) Find the angle between the first minima for the two sodium vapor lines, which have wavelengths of 589.1 and 589.6 nm, when they fall upon a single slit of width 2.00 m. (b) What is the distance between these minima if the diffraction pattern falls on a screen 1.00 m from the slit? (c) Discuss the ease or difficulty of measuring such a distance.arrow_forwardMonochromatic coherent light of amplitude E0 and angular frequency passes through three parallel slits, each separated by a distance d from its neighbor. (a) Show that the time-averaged intensity as a function of the angle is I()=Imax[1+2cos(2dsin)]2 (b) Explain how this expression describes both the primary and the secondary maxima. (c) Determine the ratio of the intensities of the primary and secondary maxima. Hint: See Problem 16.arrow_forward
- The intensity on the screen at a certain point in a double- slit interference pattern is 64.0% of the maximum value. (a) What minimum phase difference (in radians) between sources produces this result? (b) Express this phase difference as a path difference for 486.1-nm light.arrow_forwardThe intensity of light in a diffraction pattern of a single slit is described by the equation I=Imaxsin22 where = (a sin )/. The central maximum is at = 0, and the side maxima are approximately at =(m+12) for m = 1, 2, 3, . Determine more precisely (a) the location of the first side maximum, where m = 1, and (b) the location of the second side maximum. Suggestion: Observe in Figure 37.6a that the graph of intensity versus has a horizontal tangent at maxima and also at minima.arrow_forwardLight of wavelength 587.5 nm illuminates a slit of width 0.75 mm. (a) At what distance from the slit should a screen be placed if the first minimum in the diffraction pattern is to be 0.85 mm from the central maximum? (b) Calculate the width of the central maximum.arrow_forward
- Light of wavelength 5.00 102 nm is incident normally on a diffraction grating. If the third-order maximum of the diffraction pattern is observed at 32.0, (a) what is the number of rulings per centimeter for the grating? (b) Determine the total number of primary maxima that can be observed in this situation.arrow_forwardCoherent light of wavelength 501.5 nm is sent through two parallel slits in an opaque material. Each slit is 0.700 m wide. Their centers are 2.80 m apart. The light then falls on a semicylindrical screen, with its axis at the midline between the slits. We would like to describe the appearance of the pattern of light visible on the screen. (a) Find the direction for each two-slit interference maximum on the screen as an angle away from the bisector of the line joining the slits. (b) How many angles are there that represent two-slit interference maxima? (c) Find the direction for each single-slit interference minimum on the screen as an angle away from the bisector of the line joining the slits. (d) How many angles are there that represent single-slit interference minima? (e) How many of the angles in part (d) are identical to those in part (a)? (f) How many bright fringes are visible on the screen? (g) If the intensity of the central fringe is Imax, what is the intensity of the last fringe visible on the screen?arrow_forwardShow that the distribution of intensity in a double-slit pattern is given by Equation 36.9. Begin by assuming that the total magnitude of the electric field at point P on the screen in Figure 36.4 is the superposition of two waves, with electric field magnitudes E1=E0sintE2=E0sin(t+) The phase angle in in E2 is due to the extra path length traveled by the lower beam in Figure 36.4. Recall from Equation 33.27 that the intensity of light is proportional to the square of the amplitude of the electric field. In addition, the apparent intensity of the pattern is the time-averaged intensity of the electromagnetic wave. You will need to evaluate the integral of the square of the sine function over one period. Refer to Figure 32.5 for an easy way to perform this evaluation. You will also need the trigonometric identity sinA+sinB=2sin(A+B2)cos(AB2)arrow_forward
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegeCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning