![Traffic and Highway Engineering - With Mindtap](https://www.bartleby.com/isbn_cover_images/9781305360990/9781305360990_largeCoverImage.gif)
Traffic and Highway Engineering - With Mindtap
5th Edition
ISBN: 9781305360990
Author: Garber
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Question
Chapter 3, Problem 24P
To determine
The minimum distance required for the road sign should be located from the diversion.
Expert Solution & Answer
![Check Mark](/static/check-mark.png)
Want to see the full answer?
Check out a sample textbook solution![Blurred answer](/static/blurred-answer.jpg)
Students have asked these similar questions
Traffic on a freeway gives a Greenshield's traffic flow relationship expressed as:
Q = 60k-0.16667k?
At 10AM, an accident occurs 4 km downstream of an access ramp. The vehicles pull onto the shoulder of
the roadway, but traffic passing the accident area slows to 10 kph as drivers survey the damage on the side
of the road. A patrol car enters the freeway via access ramp, also at 10AM. Upon entering the freeway, the
patrol car notes that traffic on the freeway is moving along at about 40 kph.
Determine the following:
1. Capacity flow of the highway
2. Traffic shockwave created by the road accident
3. Time in AM the patrol car will reach the accident zone
4. Plotted traffic shockwave line in the Q-k traffic model diagram
Question 4
One stretch of two-lane two-way roadway that traverses through level terrain is expected
to carry 1400 vehicle per hour. Determine the Level of Service (LOS) in the peak
direction for the road based on average travel speed (ATS) if the characteristics of the
roadway are as follows:
Table Q4-1
Percentage of Trucks
Percentage of Recreational Vehicle
Peak Hour Factor
10
0.97
60:40
60
Percent Directional Split
Percent no-passing Zone
Lane Widths
Shoulder Widths
Design Speed
Road Length
Access Points
3.35 m
1.2 m
96 km/h
8 km
10 access points per km
State all assumption (if any) used in calculation..
1- You are assigned to evaluate the level of service for a section of a six-lane rural highway
that stretches along a level terrain with shoulder width of eight ft and lane width of
twelve ft. The average annual daily traffic is fifty-five thousand vehicles per day with ten
percent trucks, five percent buses, and three percent recreational vehicles. The peak hour
factor is 0.80 and the directional split is fifty-fifty. The distance between consequent
interchanges is two miles. Calculate the level of service for this highway section and
show your calculation steps.
Chapter 3 Solutions
Traffic and Highway Engineering - With Mindtap
Knowledge Booster
Similar questions
- Consider the following data: Design speed = 96 kmph Speed of overtaken vehicle = 80 kmph Reaction time for overtaking = 2 sec Acceleration = 2.5 kmph/sec The safe overtaking sight distance on a two-way traffic road way be nearlyarrow_forwardAssume you are observing traffic in a single lane of McArthur Highway at a specific location. You measure the average headway and average spacing of the vehicles as 3.2sec. and 50 m. respectively. Determine the traffic speed in kilometer/hourarrow_forwardProblem 23: A motorist traveling at 100 kph on an expressway intends to leave the expressway using an exit ramp with a maximum speed of 50 kph. At what point on the expressway should the motorist steps on her brakes in order to reduce her speed to the maximum allowable on the ramp just before entering the ramp? The section of the expressway has a downgrade of 3%. Acceleration is 3.5 m/sec?.arrow_forward
- 2. A section of a roadway changes its speed from 65 mph to 45 mph due to start of a work zone. If the sign is visible from 70 ft away for a standard driver, how far away from the start of the work zone area should the sign be placed?arrow_forwardTraffic in an interstate at 7:+15 Am and average headway of 3 sec estimate Volume Density Speedarrow_forward5. Calculate the minimum passing sight distance required for a two-lane rural roadway that has a posted speed limit of 45 mi/h. The local traffic engineer conducted a speed study of the subject road and found the following: average speed of the passing vehicle was 47 mi/h with an average acceleration of 1.43 mi/h/sec, and the average speed of impeder vehicles was 40 mi/h.arrow_forward
- Calculate the minimum passing sight distance required for a two-lane rural roadway that has a posted speed limit of 45 mi/h. The local traffic engineer conducted a speed study of the subject road and found the following: average speed of the passing vehicle was 47 mi/h with an average acceleration of 1.43 m/h/sec, and the average speed impeder vehicles was 40 mi/h. Show your solutions.arrow_forwardThe average speed of cars passing a busy intersection between 4:30 P.M. and 6:30 P.M. on a Friday is 32.3 mi/h.A) Continuous B) Discretearrow_forwardMCQ (Multiple Choice Question) If the speed limit of a rural two-lane highway is 110 km/h on a straight level segment followed by a horizontal curve with a speed limit 50 km/h. As you a transportation engineering, where should a traffic warning sign to be placed from the beginning of the curve to warn the drivers to reduce their speed knowing that the driver can see the warning sign from 25 m? * O 159.9 m O 184.9 m O 212.9 m O 187.9 marrow_forward
- Assume you are observing traffic in a single lane of McArthur Highway at a specific location. You measure the average headway and average spacing of the vehicles as 3.2sec. and 50 m. respectively. Determine the traffic flow in vehicle/hour.arrow_forward1. The rate flow at a point in the highway is 1200 vehicles/hour. Find the space mean speed in mph if the density of traffic is 25 vehicles per mile 2. Assume you are observing traffic in a single lane of McArthur Highway at a specific location. You measure the average headway and average spacing of the vehicles as 3.2sec. and 50 m. respectively. Determine the traffic speed in kilometer/hourarrow_forwardTraffic on a freeway gives a Greenshield's flow relationship expressed as: Q = 65k-0.354k2 At 10AM, an accident occurs 4 km downstream of an access ramp. The vehicles pull onto the shoulder of the roadway, but traffic passing the accident area slows to 10 kph as drivers survey the damage on the side of the road. A patrol car enters the freeway via access ramp, also at 10AM. Upon entering the freeway, the patrol car notes that traffic on the freeway is moving along at about 60 kph. Determine the following: 1. Capacity flow of the highway 2. Traffic shockwave created by the road accident 3. Time in AM the patrol car will reach the accident area 4. Traffic shockwave line as plotted and shown in the Q-k traffic model diagram Note: Show full solution. Do not copy in chegg it has different question Topic: Highway Engineering (Greenshield Model)arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
![Text book image](https://www.bartleby.com/isbn_cover_images/9781305156241/9781305156241_smallCoverImage.jpg)
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning