Concept explainers
Review. Alter removing one string while restringing his acoustic guitar, a student is distracted by a video game. His experimentalist roommate notices his inattention and attaches one end of the string, of linear density μ = 3.00 × 10-3 kg/m. to a rigid support. The other end passes over a pulley, a distance ℓ = 64.0 cm from the fixed end, and an object of mass m = 27.2 kg is attached to the hanging end of the string. The roommate places a magnet across the string as shown in Figure P31.35. The magnet does not touch the string, but produces a uniform field of 4.50 mT over a 2.00-cm length of the string and negligible field elsewhere. Strumming the string sets it vibrating vertically at its fundamental (lowest) frequency. The section of the string in the magnetic field moves perpendicular to the field with a uniform amplitude of 1.50 cm. Find (a) the frequency and (b) the amplitude of the emf induced between the ends of the string.
Trending nowThis is a popular solution!
Chapter 31 Solutions
Physics for Scientists and Engineers, Technology Update (No access codes included)
- A nylon string has mass 5.50 g and length L = 86.0 cm. The lower end is tied to the floor, and the upper end is tied to a small set of wheels through a slot in a track on which the wheels move (Fig. P14.56). The wheels have a mass that is negligible compared with that of the string, and they roll without friction on the track so that the upper end of the string is essentially free. At equilibrium, the string is vertical and motionless. When it is carrying a small-amplitude wave, you may assume the string is always under uniform tension 1.30 N. (a) Find the speed of transverse waves on the string. (b) The strings vibration possibilities are a set of standing-wave states, each with a node at the fixed bottom end and an anti-node at the free top end. Find the nodeantinode distances for each of the three simplest states. (c) Find the frequency of each of these states. Figure P14.56arrow_forwardA vertical spring with constant k = 5 N/m and damping constant β = 6 kg/s has one end fixed to a wall, and a mass of 98 kg at the other end. Being in the position of equilibrium, the mass is propelled downward with a speed of 4 m/s. Suppose that on the system an external force acts in newtons given by f(t) = 8e^ −t What is the diferential equation and conditions that allow to find the position of the spring as function of a time t, with t in secondsarrow_forwardA vertical spring with constant k = 5 N/m and damping constant β = 6 kg/s has one end fixed to a wall, and a mass of 98 kg at the other end. Being in the position of equilibrium, the mass is propelled downward with a speed of 4 m/s. Suppose that on the system an external force acts in newtons given by f(t) = 8e^ −t What is the diferential equation and conditions that allow to fink the position of the spring as function of the time t, with t in seconds Determine a diferential equation of the position of the mass at any time “t”, with t in secondsarrow_forward
- Three light, inextensible strings are tied to the small, light ring, C. Two ends are attached to the ceiling at points A and B, making angles α = 36.9o and β = 60.0o as shown. The third has a mass m = 2.02 kg hanging from it at point D. The system is in equilibrium. What is the magnitude of the tension in the string AC?arrow_forwardA 12.6 inches long key is to be used on a 210 hp, 1200 rpm, slip ring induction motor. The key is 1 in wide and has a depth of 3/4 in. The shaft diameter is 3 7/8 inches. The maximum running torque is 200% of the full-load torque. 1. Determine the maximum compressive (crushing) stress of the key, in psi. 2. Determine the maximum direct shearing stress on the shaft, considering the effect of the keyway, in psi.arrow_forwardThe AB cable in the figure is attached to the top of the 3 m high vertical pole and its tension is 50 kN. What are the tensions on the AO, AC and AD cables?arrow_forward
- The triangular block shown in Fig. P-010 is subjected to the loads P = 1600 lb and F = 600 lb. If AB = 8 in. and BC = 6 in., resolve each load into components normal and tangential to AC.arrow_forwardIntegrated Concepts The Tethered Satellite in Figure 23.12 has a mass at 525 kg and is at the end of a 20.0 km long, 2.50 mm diameter cable with the tensile strength of steel. (a) How much does the cable stretch if a 100 N force is exerted to pull the satellite in? (Assume the satellite and shuttle are at the same altitude above the Earth.) (b) What is the effective force constant of the cable? (c) How much energy is stored in it when Stretched by the 100 N force?arrow_forwardA 60 Hz power line has an angular frequency “ω” (in rad/s) of:arrow_forward
- An antenna behave as resonant ckt only when its length is: a) W length/2 b) W length c) W length/4 d) W length/2 or multiplearrow_forwardConsider a string that rotates around the end of a motor. The string has length L = 0.20m and mass M = 0.015 kg. What (constant) torque must the motor exert on the string for it to bring it from rest to full speed in 0.50 s? Full speed is 1200rpm. Igore wind resistance. The moment of inertia for motion of a rod about the end is I=1/3ML^2.arrow_forwardA 0.55kg block vibrates accordingly to the equation x = 1.5cos(12.4)ta. Determine the equation of the velocity and acceleration as a function of time.b. What is the velocity, acceleration, and restoring force at x=0.5m?arrow_forward
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College