# Must the stop button be pressed between speeds on acceleration or deceleration? Why?

### Electric Motor Control

10th Edition
Herman
Publisher: CENGAGE L
ISBN: 9781133702818

Chapter
Section

### Electric Motor Control

10th Edition
Herman
Publisher: CENGAGE L
ISBN: 9781133702818
Chapter 35, Problem 2SQ
Textbook Problem
4 views

## Must the stop button be pressed between speeds on acceleration or deceleration? Why?

To determine

Explain whether the stop button is to be activated between the speed acceleration or deceleration steps of the motor or not, and state the reason.

### Explanation of Solution

Refer to Figure 35–1 in the textbook which shows the push button speed selection for the wound rotor motor. In this circuit, the motor operates slowly by pressing the low-speed push button and energizing coil M, causing the power to be supplied to the stator winding of a motor through the load contacts M. Therefore, the motor accelerates with full resistance available in the secondary circuit.

When the medium speed push button is pressed, contactor S energizes and closes the two S load contacts. Therefore, the resistance in the secondary circuit reduces and it accelerates the motor at a higher speed. When the high-speed push button is pressed, contactor H energizes and shorts all the resistance out of the rotor circuit. Therefore, the motor accelerates at the highest speed...

### Still sussing out bartleby?

Check out a sample textbook solution.

See a sample solution

#### The Solution to Your Study Problems

Bartleby provides explanations to thousands of textbook problems written by our experts, many with advanced degrees!

Get Started

Find more solutions based on key concepts
A micrometer uses an accurate __________ to perform measurement.

Precision Machining Technology (MindTap Course List)

A conveyer belt runs on 4 in. drums that are driven by a motor. If it takes 5 s for the belt to go from zero to...

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

Define the term, spoofing. How can you tell if an email is spoofed?

Enhanced Discovering Computers 2017 (Shelly Cashman Series) (MindTap Course List)

If your motherboard supports ECC DDR3 memory, can you substitute non-ECC DDR3 memory?

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

What is the purpose of grooving a joint before welding on thick plate?

Welding: Principles and Applications (MindTap Course List)