Concept explainers
CP A thin uniform film of refractive index 1.750 is placed on a sheet of glass of refractive index 1.50. At room temperature (20.0°C), this film is just thick enough for light with wavelength 582.4 nm reflected off the top of the film to be cancelled by light reflected from the top of the glass. After the glass is placed in an oven and slowly heated to 170°C, you find that the film cancels reflected light with wavelength 588.5 nm. What is the coefficient of linear expansion of the film? (Ignore any changes in the refractive index of the film due to the temperature change.)
Want to see the full answer?
Check out a sample textbook solutionChapter 35 Solutions
University Physics (14th Edition)
Additional Science Textbook Solutions
Essential University Physics (3rd Edition)
Introduction to Electrodynamics
Physics for Scientists and Engineers with Modern Physics
Conceptual Integrated Science
College Physics: A Strategic Approach (3rd Edition)
College Physics: A Strategic Approach (4th Edition)
- Both sides of a uniform film that has index of refraction n and thickness d are in contact with air. For normal incidence of light, an intensity minimum is observed in the reflected light at λ2 and an intensity maximum is observed at λ1, where λ1 > λ2. (a) Assuming no intensity minima are observed between λ1 and λ2, find an expression for the integer m in Equations 27.13 and 27.14 in terms of the wavelengths λ1 and λ2. (b) Assuming n = 1.40, λ1 = 500 nm, and λ2 = 370 nm, determine the best estimate for the thickness of the film.arrow_forwardThe light from a mercury lamp is incident on a water film of refractive index 1.33 and thickness t = 150nm which is suspended in ambient environment. At what wavelength the light reflected by film falls in a region of infraredarrow_forwardLaser light of wavelength 460 nmnm is traveling in air and shines at normal incidence onto the flat end of a transparent plastic rod that has nn = 1.30. The end of the rod has a thin coating of a transparent material that has refractive index 1.75. a)What is the minimum (nonzero) thickness of the coating for which there is maximum transmission of the light into the rod? b)What is the minimum (nonzero) thickness of the coating for which transmission into the rod is minimized?arrow_forward
- White light is sent downward onto a horizontal thin film that is sandwiched between two materials. The indexes of refraction are 1.80 for the top material, 1.70 for the thin film, and 1.50 for the bottom material. The film thickness is 5.00* 10-7 m. Of the visible wavelengths (400 to 700 nm) that result in fully constructive interference at an observer above the film, which is the (a) longer and (b) shorter wavelength? The materials and film are then heated so that the film thickness increases. (c) Does the light resulting in fully constructive interference shift toward longer or shorter wavelengths?arrow_forwardIf the wavelength of a monochromatic source is 316 nm in vacuum, what is the wavelength from the same source when it passes through a liquid where the speed of light is 1.86 × 108 m/s? (c = 3.00 × 108 m/s)arrow_forward1. (a) The speed of a 500 nm light is 3 .00x10^8 m/s in vacuum and 1.95x10^8 m/s in a certain glass. What is theindex of refraction of the light? (b) What is the frequency of the 500 nm light in a vacuum? (c) What is the frequency of the 500 nm light in the glass? (d)If the 500 nm light is incident on a flat boundary between the glass part in Ia and air (nair= 1.00) asshown, what is the angle of reflection? Sketch on the given diagram. Do the samework for the refracted ray.arrow_forward
- It is desired to apply an anti-reflection coating on a glass lens used in air, by coating the lens with a thin film of magnesium fluoride of refractive index nf = 1.37; (assume the glass has refractive index larger than nfd ). Write down the formula for optical path difference between waves reflected at top and bottom of the film, and use this to calculate the minimum required thickness of the coating to give a reflectance minimum for normal-incidence green light of wavelength 550 nm in air.arrow_forwardThe rhinestones in costume jewelry are glass with index of refraction 1.50. To make them more reflective, they are often coated with a layer of silicon monoxide of index of refraction 2.00.What is the minimum coating thickness needed to ensure that light of wavelength 560 nm and of perpendicular incidence will be reflected from the two surfaces of the coating with fully constructive interference?arrow_forwardWhite light is incident normally on a glass lens (n=1.52) that is coated with a film of MgF2 (n=1.38). For what minimum thickness of the film will the reflections at the two interfaces result in total destructive interference of yellow light of wavelength 580 nm (in air)?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning