Concept explainers
Coherent monochromatic
Want to see the full answer?
Check out a sample textbook solutionChapter 36 Solutions
University Physics with Modern Physics, Volume 2 (Chs. 21-37); Mastering Physics with Pearson eText -- ValuePack Access Card (14th Edition)
Additional Science Textbook Solutions
Cosmic Perspective Fundamentals
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
Essential University Physics: Volume 2 (3rd Edition)
Modern Physics
College Physics: A Strategic Approach (4th Edition)
Sears And Zemansky's University Physics With Modern Physics
- A Fraunhofer diffraction pattern is produced on a screen located 1.00 m from a single slit. If a light source of wavelength 5.00 107 m is used and the distance from the center of the central bright fringe to the first dark fringe is 5.00 103 m, what is the slit width? (a) 0.010 0 mm (b) 0.100 mm (c) 0.200 mm (d) 1.00 mm (e) 0.005 00 mmarrow_forwardTable P35.80 presents data gathered by students performing a double-slit experiment. The distance between the slits is 0.0700 mm, and the distance to the screen is 2.50 m. The intensity of the central maximum is 6.50 106 W/m2. What is the intensity at y = 0.500 cm? TABLE P35.80arrow_forwardAt the metal fabrication company where you work, you are asked to measure the diameter D of a very small circular hole in a thin, vertical metal plate. To do so, you pass coherent monochromatic light with wavelength 562 nm through the hole and observe the diffraction pattern on a screen that is a distance x from the hole. You measure the radius r of the first dark ring in the diffraction pattern. You make the measurements for four values of x. Your results are given in the table. (a) Use each set of measurements to calculate D. Because the measurements contain some error, calculate the average of the four values of D and take that to be your reported result. (b) For x = 1.00 m, what are the radii of the second and third dark rings in the diffraction pattern?arrow_forward
- Your physics study partner tells you that the width of the central bright band in a single-slit diffraction pattern is inversely proportional to the width of the slit. This means that the width of the central maximum increases when the width of the slit decreases. The claim seems counterintuitive to you, so you make measurements to test it. You shine monochromatic laser light with wavelength λ onto a very narrow slit of width a and measure the width w of the central maximum in the diffraction pattern that is produced on a screen 1.50 m from the slit. (By “width,” you mean the distance on the screen between the two minima on either side of the central maximum.) Your measurements are given in the table. (a) If w is inversely proportional to a, then the product aw is constant, independent of a. For the data in the table, graph aw versus a. Explain why aw is not constant for smaller values of a. (b) Use your graph in part (a) to calculate the wavelength λ of the laser light. (c) What is…arrow_forwardA diffraction grating is used to view the spectrum of light from a helium discharge tube. The 3 brightest lines are red, yellow and blue in colour. In this spectrometer, the distance between the grating and the slit is 30.0 cm and the slit spacing in the grating is 1870 nm. Calculate the wavelength of spectral line C. What is the highest order of spectral line C that can be seen?arrow_forwardDiffraction can be used to provide a quick test of the size of red blood cells. Blood is smeared onto a slide, and a laser shines through the slide. The size of the cells is very consistent, so the multiple diffraction patterns overlap and produce an overall pattern that is similar to what a single cell would produce. Ideally, the diameter of a red blood cell should be between 7.5 and 8.0 μm. If a 633 nm laser shines through a slide and produces a pattern on a screen 24.0 cm distant, what range of sizes of the central maximum should be expected? Values outside this range might indicate a health concern and warrant further study.arrow_forward
- In a diffraction experiment the 1st order light (m = 1) from a diffraction grating is falling onto a single slit (see picture below). The light from the slit is then observed on a second screen and the measured width of the central diffraction peak is found to be 8 mm. Calculate the number of lines per millimetres of the grating. The distance from the slit to the second screen is 1.37 m, the distance from the diffraction grating to the screen with the slit is 5 m, the slit width is 0.25 mm and the distance from the middle of the screen with the slit to the slit is 10 mm..arrow_forwardCoherent electromagnetic waves with wavelength λ = 500 nm pass through two identical slits. The width of each slit is a, and the distance between the centers of the slits is d = 9.00 mm. (a) What is the smallest possible width a of the slits if the m = 3 maximum in the interference pattern is not present? (b) What is the next larger value of the slit width for which the m = 3 maximum is absent?arrow_forwardIn a diffraction experiment, a monochromatic light of 420 nm wavelength pass through a 20 μm wide slit. The screen is placed at 1.5 m from the slit. The ratio between the intensity at a point that is 45 mm from the center light to the maximum intensity of the diffraction pattern is _ percent.arrow_forward
- Coherent electromagnetic waves with wavelength l = 500 nm pass through two identical slits. The width of each slit is a, and the distance between the centers of the slits is d = 9.00 mm. (a) What is the smallest possible width a of the slits if the m = 3 maximum in the interference pattern is not present? (b) What is the next larger value of the slit width for which the m = 3 maximum is absent?arrow_forwardIn a diffraction experiment the 1st order light (m=1) from a diffraction grating is falling onto a single slit (see picture below). The light from the slit is then observed on a second screen and the measured width of the central diffraction peak is found to be 8 mm. Calculate the number of lines per millimetres of the grating. The distance from the slit to the second screen is 2.16 m, the distance from the diffraction grating to the screen with the slit is 5 m, the slit width is 0.25 mm and the distance from the middle of the screen with the slit to the slit is 10 mm. 一个个个 light Grating Screen with slit Slit of size a distance from middle of Screen to the slit مع Width of Central ✓diffraction peakearrow_forwardThe coherence length of an ordinary white light source can be increased if we place a color filter in front of the source, so that the light that passes through the filter is somewhat monochromatic. The minimum wavelength of the emerging light is 564 nm. What is the maximum wavelength in order for the coherence length to be 0.09100 mm?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning