Concept explainers
BIO Increasing Safety in a Collision
Safety experts say trial an automobile accident is really a succession of three separate collisions. (1) the automobile collides with an obstacle and comes to rest; (2) people within the car continue to move forward until they collide with the interior of the car, or are brought to rest by a restraint system like a seatbelt or an air bag and (3) organs within the occupants bodies continue to move forward until they collide with the body wail and are brought to rest. Not much can be done about the third collision, but the effects of the first two can be mitigated by increasing the distance over which the car and its occupants are brought to rest
For example, the severity of the first collision is reduced by building collapsible “crumple zones” into the body of a car, and by placing compressible collision barriers near dangerous obstacles like bridge supports. The second collision is addressed primarily through the use of seatbelts and air bags. These devices reduce the force that acts on an occupant to survivable levels by increasing the distance over which he or she comes to rest. This is illustrated in Figure 5-47, where we see the force exerted on a 65.0-kg driver who slows from an initial speed of 18.0 m/s (lower curve) or 36.0 m/s (upper curve) to rest in a distance ranging from 5.00 cm to 1.00 m.
87. •• The combination of "crumple zones" and air bags/seatbelts might increase the distance over which a person stops in a collision to as great as 1.00 m. What is the magnitude of the force exerted on a 65.0-kg driver who decelerates from 18.0 m/s to 0.00 m/s over a distance of 1.00 m?
- A. 162 N
- B. 565 N
- C. 1.05 × 104N
- D. 2.11 × 104N
Want to see the full answer?
Check out a sample textbook solutionChapter 5 Solutions
EBK PHYSICS
Additional Science Textbook Solutions
The Cosmic Perspective (8th Edition)
Introduction to Electrodynamics
Sears And Zemansky's University Physics With Modern Physics
University Physics Volume 2
Glencoe Physical Science 2012 Student Edition (Glencoe Science) (McGraw-Hill Education)
Conceptual Physics (12th Edition)
- In Example 2.12, two circus performers rehearse a trick in which a ball and a dart collide. We found the height and time of the collision graphically. Return to that example, and find height and time by simultaneously solving the equations for the ball and the dart.arrow_forwardTwo identical pucks collide on an air hockey table. One puck was originally at rest. (a) If the incoming puck has a speed of 6.00 m/s and scatters to an angle of 30.0°,what is the velocity (magnitude and direction) of the second puck? (You may use the result that 12=90 for elastic collisions of objects that have identical masses.) (b) Confirm that the collision is elastic.arrow_forwardTwo students hold a large bed sheet vertically between them. A third student, who happens to be the star pitcher on the school baseball team, throws a raw egg at the center of the sheet. Explain why the egg does not break when it hits the sheet, regardless of its initial speed.arrow_forward
- Integrated Concepts A 2.50-kg fireworks shell is fired straight up from a mortar and reaches a height of 110 m. (a) Neglecting air resistance (a poor assumption, but we will make it for this example), calculate the shell's velocity when it leaves the mortar. (b) The mortar itself is a tube 0.450 m long. Calculate the average acceleration of the shell in the tube as it goes from zero to the velocity found in (a). (c) What is the average force on the shell in the mortar? Express your answer in newtons and as a ratio to the weight of the shell.arrow_forwardProfessional Application One hazard of space travel is debris left by previous missions. There are several thousand objects orbiting Earth that are large enough to be detected by radar, but there are far greater numbers of very small objects, such as flakes of paint. Calculate the force exerted by a 0.100-mg chip of paint that strikes a spacecraft window at a relative speed of 4.00103 m/s, given the collision lasts 6.00108 s.arrow_forwardA 60-kg soccer player jumps vertically upwards and heads the 0.45-kg ball as it is descending vertically with a speed of 25 m/s. (a) If the player was moving upward with a speed of 4.0 m/s just before impact, what will be the speed of the ball immediately after the collision if the ball rebounds vertically upwards and the collision is elastic? (b) If the ball is in contact with the players head for 20 ms, what is the average acceleration of the ball? (Note that the force of gravity may be ignored during the brief collision time.)arrow_forward
- You have just planted a sturdy 2-m-tall palm tree in your front lawn for your mother's birthday. Your brother kicks a 500 g ball, which hits the top of the tree at a speed of 5 m/s and stays in contact with it for 10 ms. The ball falls to the ground near the base of the tree and the recoil of the tree is minimal. (a) What is the force on the tree? (b) The length of the sturdy section of the root is only 20 cm. Furthermore, the soil around the roots is loose and we can assume that an effective force is applied at the tip of the 20 cm length. What is the effective force exerted by the end of the tip of the root to keep the tree from toppling? Assume the tree will be uprooted rather than bend. (c) What could you have done to ensure that the tree does not uproot easily?arrow_forwardConstruct Your Own Problem Consider an artillery projectile striking armor plating. Construct a problem in which you find the force exerted by the projectile on the plate. Among the things to be considered are the mass and speed of the projectile and the distance over which its speed is reduced. Your instructor may also wish for you to consider the relative merits of depleted uranium versus lead projectiles based on the greater density of uranium.arrow_forwardUnreasonable Results Squids have been reported to jump from the ocean and travel 30.0 m (measured horizontally) before re-entering the water. (a) Calculate the initial speed of the squid if it leaves the water at an angle of 20.0°, assuming negligible lift from the air and negligible air resistance. (b) The squid propels itself by squirting water. What fraction of its mass would it have to eject in order to achieve the speed found in the previous part? The water is ejected at 12.0 m/s; gravitational force and friction are neglected. (c) What is unreasonable about the results? (d) Which premise is unreasonable, or which premises are inconsistent?arrow_forward
- Two blocks collide on a frictionless surface. After the collision, the blocks stick together. Block A has a mass M and is initially moving to the right at speed v. Block B has a mass 2M and is initially at rest. System C is composed of both blocks, (a) Draw a force diagram for each block at an instant during the collision, (b) Rank the magnitudes of the horizontal forces in your diagram. Explain your reasoning, (c) Calculate the change in momentum of block A, block B, and system C. (d) Is kinetic energy conserved in this collision? Explain your answer. (This problem is courtesy of Edward F. Redish. For more such problems, visit http://www.physics.umd.edu/perg.)arrow_forwardAn amateur skater of mass M is trapped in the middle of an ice rink and is unable to return to the side where there is no ice. Every motion she makes causes her to slip on the ice and remain in the same spot. She decides to try to return to safety by throwing her gloves of mass m in the direction opposite the safe side. (a) She throws the gloves as hard as she can, and they leave her hand with a horizontal velocity vgloves. Explain whether or not she moves. (b) If she does move, calculate her velocity vgirl relative to the Earth after she throws the gloves. (c) Discuss her motion from the point of view of the forces acting on her.arrow_forwardIn a laboratory model of cars skidding to a stop, data are measured for four trials using two blocks. The blocks have identical masses but different coefficients of kinetic friction with a table: k = 0.2 and 0.8. Each block is launched with speed vi = 1 m/s and slides across the level table as the block comes to rest. This process represents the first two trials. For the next two trials, the procedure is repeated but the blocks are launched with speed vi = 2 m/s. Rank the four trials (a) through (d) according to the stopping distance from largest to smallest. If the stopping distance is the same in two cases, give them equal rank. (a) vi = 1 m/s, = 0.2 (b) vi = 1 m/s, k = 0.8 (c) vi = 2 m/s, = 0.2 (d) vi =2 m/s, k = 0.8arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegeCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning