Concept explainers
You have seen dogs shake to shed water from their fur. The motion is complicated, but the fur on a dog’s torso rotates back and forth along a roughly circular arc. Water droplets are held to the fur by contact forces, and these forces provide the centripetal acceleration that keeps the droplets moving in a circle, still attached to the fur, if the dog shakes gently. But these contact forces—like static friction—have a maximum possible value. As the dog shakes more vigorously, the contact forces cannot provide sufficient centripetal acceleration and the droplets fly off. A big dog has a torso that is approximately circular, with a radius of 16 cm. At the midpoint of a shake, the dog’s fur is moving at a remarkable 2.5 m/s.
a. What force is required to keep a 10 mg water droplet moving in this circular arc?
b. What is the ratio of this force to the weight of a droplet?
Want to see the full answer?
Check out a sample textbook solutionChapter 6 Solutions
College Physics: A Strategic Approach (3rd Edition)
Additional Science Textbook Solutions
University Physics Volume 2
The Cosmic Perspective
Essential University Physics: Volume 2 (3rd Edition)
Lecture- Tutorials for Introductory Astronomy
Sears And Zemansky's University Physics With Modern Physics
Conceptual Physical Science (6th Edition)
- A certain string just breaks when it is under 25 N of tension. A boy uses this string to whirl a 2 kg stone in a horizontal circle of radius 3 m. The boy continuously increases the speed of the stone. At approximately what speed will the string break?arrow_forwardA small object of mass 0.500 kg is attached by a 0.840 m-long cord to a pin set into the surface of a frictionless table top. The object moves in a circle on the horizontal surface with a speed of 8.80 m/s. What is the tension in the cord?arrow_forwardA string under tension of 50.0 N is used to whirl a rock in a horizontal circle of radius 2.5 m at a speed of 20.4 m/s on a frictionless table. The string passes through a small hole in the table at the center of this circle. As the string is pulled in, the speed of the rock increases. When the string is 1.00 m long and the speed is 51.0 m/s, the string breaks. What is the breaking strength, in Newtons, of the string?arrow_forward
- A 0.5 kg object moves in a horizontal circular track with a radius of 2.5 m. An external force of 3.0 N, acting always tangent to the track, causes the object to speed up as it goes around. If it starts from rest, its speed at the end of one revolution is:arrow_forwardYou tie one end of 0.3-m-long spring to a 0.5 kg mass. Holding the other end of the spring in your hand, you whirl the mass in a vertical circle at a speed of 4 m/s. If the spring elongates 1 cm at the lowest point in the circular motion, what is the spring constant?arrow_forwardA small block with mass 0.0300 kg slides in a vertical circle of radius 0.550 m on the inside of a circular track. During one of the revolutions of the block, when the block is at the bottom of its path, point A, the magnitude of the normal force exerted on the block by the track has magnitude 3.75 N. In this same revolution, when the block reaches the top of its path, point B, the magnitude of the normal force exerted on the block has magnitude 0.685 N. Part A How much work was done on the block by friction during the motion of the block from point A to point B? Express your answer with the appropriate units. W friction = Submit μA Value Request Answer Units ?arrow_forward
- You are slowly getting sick as you ride the Cajun Cliffhanger, a rotor ride which spins people in a circular room and drops the floor. The ride has a radius of 2.5 meters and makes 10 revolutions in 19 seconds. (a) How big must the friction force be to stop you from sliding down the wall (b) What is the minimum possible coefficient of friction on this ride so that you don’t slide down the wall? (c) If the period of the ride were increased, would the minimum coefficient of friction to hold you up increase or decrease?arrow_forwardA small block with mass 0.0300 kg slides in a vertical circle of radius 0.425 m on the inside of a circular track. During one of the revolutions of the block, when the block is at the bottom of its path, point A, the magnitude of the normal force exerted on the block by the track has magnitude 3.90 N . In this same revolution, when the block reaches the top of its path, point B, the magnitude of the normal force exerted on the block has magnitude 0.675 N . 1) How much work was done on the block by friction during the motion of the block from point A to point B?arrow_forwardA 940 g rock is whirled in a horizontal circle at the end of a 1.5 m-long string. If the breaking strength of the string is 120 N , what is the maximum allowable speed of the rock? At this maximum speed, what angle does the string make with the horizontal?arrow_forward
- A small object of mass 0.20 kg is whirled in a horizontal circle at the end of the 1 m long cord. What is the highest speed that the object can have if the cord can sustain a maximum force of 4 newtons without breaking?arrow_forwardA 0.5-kg ball is attached to a string and whirled around in a circle overhead. The string breaks if the force on it exceeds 46 N. What is the maximum speed the ball can have when the radius of the circle is 1 m?arrow_forwardA velodrome has an aggressively banked curve, where the surface makes an angle of 58.9 degrees with the horizontal. If you are biking around this curve (such that your path traces a horizontal circle with radius 21.7 m as you go around the turn), and the coefficient of static friction of your bike tires with the velodrome surface is 0.617, what is the minimum speed that you can go before starting to slip down the ramp? Give your answer in km/hr.arrow_forward
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON