Concept explainers
Interpretation:
The blanks in the each row of the table by using
Concept Introduction:
Ideal gas law provides the relationship between the four gas variables temperature, pressure, volume, and molar amount of a gaseous substance at specified set of conditions. The mathematical expression for ideal gas law can be shown below,
Answer to Problem 7.46EP
At given conditions the blanks in the table is filled by using ideal
P | V | n | T | |
10.9 atm | 3.00 L | 1.00mole | 127oC | |
a | 22.4 atm | 3.30 L | 3.00 mole | 27oC |
b | 7.10 atm | 8.00 L | 2.00 mole | 73oC |
c | 2.50 atm | 2.50 L | 0.761mole | -173oC |
d | 5.00 atm | 10.0 L | 2.00 mole | 32oC |
Explanation of Solution
(a)
Record the given data,
Now, substitute these values in ideal gas law and do some mathematical calculation as shown in below,
Therefore, the new volume is
(b)
Record the given data,
Now, substitute these values in ideal gas law and do some mathematical calculation as shown in below,
Therefore, the new pressure is
(c)
Record the given data,
Now, substitute these values in ideal gas law and do some mathematical calculation as shown in below,
Therefore, the number of moles is
(d)
Record the given data,
Now, substitute these values in ideal gas law and do some mathematical calculation as shown in below,
Now, convert the obtained Kelvin temperature into degree Celsius temperature by using the following equation,
Therefore, the new temperature is
Want to see more full solutions like this?
Chapter 7 Solutions
EBK GENERAL, ORGANIC, AND BIOLOGICAL CH
- Gas moves from an area of ________ partial pressure to an area of ________ partial pressure. low; high low; low high; high high; lowarrow_forwardDetermine and report the pressure of collected hydrogen gas in atmospheres. Report this result to one more digit than allowed by applying the rules of significant figures. (1 atm = 760 mm Hg, an exact conversion factor.) Determine the moles of hydrogen collected by substituting the appropriate quantities into the ideal gas equation and solving. Report this result to one more digit than allowed by applying the rules of significant figures. Notes: the gas temperature is the same as the listed temperature; R = 0.082057 L-atm/mol-K. Be mindful of units. Determine the experimental atomic mass of Cu. Round this result to the correct number of significant figures. Determine the percent relative error (= ????????????−?h????????? ? 100). The molar mass of Cu is 63.546 g/mol. Mass of copper before electrolysis 6.008 g Mass of copper after electrolysis 5.860 g Volume of H2 collected 58.9 mL Pressure of H2, PH2 720.8 mm Hg Temperature 24.0 oCarrow_forwardA machine produces 599 L of hydrogen at 101 kpa each day . If each days supply of hydrogen were kept at a pressure of 366 kpa, what would the volume of the hydrogenarrow_forward
- A cylinder of gas at room temperature (20 degrees Celsius) has a pressure P1. To what temperature in degrees Celsius would the temperature have to be increased for the pressure to be 1.2p1?arrow_forwardDiscuss how temperature of a commodity can influence the vapor pressure deficitarrow_forwardAfter admission to the hospital, the patient becomes acutely short of breath. An arterial blood gas (ABG) was drawn, Which of the following ABG results would you expect to see and why? a. pH: 7.46, pCO2: 35, HCO3: 24, pO2: 86 b. pH: 7.36, pCO2: 44, HCO3: 22, pO2: 97arrow_forward
- A typical room is 4.0 m long, 5.0 m wide, and 2.5 m high. What is the total mass of the oxygen in the room assuming that the gas in the room is at STP and that air contains 21% oxygen and 79% nitrogen?arrow_forwardIf 4.00 L of ethyl alcohol at 18.0 ⁰C is exposed to a temperature of 25.0 ⁰C, what is the resulting volume? (Alcohol: β = 1100x10⁻⁶ / ⁰C) * a. 4.03 L b. 4.31 L c. 0.308 L d. 0.0308 Larrow_forwardThe substance oxygen has the following properties: normal melting point: 54.8 K normal boiling point: 90.2 K triple point: 1.50×10-3 atm, 54.4 K critical point: 49.8 atm, 154.6 K A sample of oxygen is initially at a pressure of 58.9 atm and a temperature of 96.9 K. The pressure on the sample is reduced to 1.50×10-3 atm at a constant temperature of 96.9 K. Which of the following are true?Choose all that apply The sample is initially a liquid. The gas initially present will solidify. The final state of the substance is a gas. One or more phase changes will occur. The final state of the substance is a solid.arrow_forward
- Would it be more difficult to meet a 70 ppb one hour averaged standard or 70 ppb 8-hr averaged standard and why?arrow_forwardWhich sample is larger? 1.0 mg or 0.01 g 1.0 μg or 0.01 mg 12 mg or 0.12 g 12 mg or 1200 μgarrow_forwardUnder which of the conditions would the magnetic field clearly dominate the behavior of the plasma?A. Beta >> 1B. Beta << 1C. Beta ~ 1arrow_forward
- Basic Clinical Lab Competencies for Respiratory C...NursingISBN:9781285244662Author:WhitePublisher:Cengage
- Anatomy & PhysiologyBiologyISBN:9781938168130Author:Kelly A. Young, James A. Wise, Peter DeSaix, Dean H. Kruse, Brandon Poe, Eddie Johnson, Jody E. Johnson, Oksana Korol, J. Gordon Betts, Mark WomblePublisher:OpenStax CollegeCardiopulmonary Anatomy & PhysiologyBiologyISBN:9781337794909Author:Des Jardins, Terry.Publisher:Cengage Learning,