(a)
Interpretation:
The dew point line(s) from the given graphs is to be identified.
Concept introduction:
The formula to calculate the total pressure of the system with respect to the mole fraction in solution is,
Where,
•
•
•
The plot between the vapor mole fraction and total pressure give the dew point line.
(b)
Interpretation:
The bubble point line(s) from the given graphs is to be identified.
Concept introduction:
The formula to calculate the total pressure of the system with respect to the mole fraction in solution is,
Where,
•
•
•
The plot between the liquid mole fraction and total pressure give the bubble point line.
(c)
Interpretation:
The fractional distillation of a
Concept introduction:
The formula to calculate the total pressure of the system with respect to the mole fraction in solution is,
Where,
•
•
•
Want to see the full answer?
Check out a sample textbook solutionChapter 7 Solutions
Physical Chemistry
- 1. (a) In the experiment carried out to determine the degree of association of benzoic acid in benzene (C6H6), the cooling curves of pure benzene and benzoic acid solution prepared by dissolving 0.358 g benzoic acid in 20 mL of benzene were obtained by using Beckmann thermometer, calibrated before the experiment. The cooling curves are given in the figure below. Calculate the degree of association of benzoic acid in benzene for the given solution. Ky= 5.055 K kg.mol-¹, dbenzene- 0.876 g.cm³, MBenzoic acid=122.12 g.mol-¹ T(°C) 2.88 2.38 Benzene Solution t(min)arrow_forwardUse a temperature-composition diagram to explain why fractional distillation of two components is more easily accomplished if the components have boiling points that differ by 20C or more.arrow_forwardPre-lab Assignment 1.) Note from the 'Introduction' that the freezing-point-depression constant, Kfp, for any solvent can be calculated as long as the heat of fusion, AHfus, and freezing point of the solvent is known. Calculate the freezing-point-depression constant (in SI units) for carbon tetrachloride, CC14, given that its heat of fusion is 2.5 kJ/mol and its freezing point is 250.3 K. M solvent & (TF Solvet) AIFUD - molor Mod 1=0,0821 LATM/ molk ~14=153.82glangs Кы = latm (153.82 $7) (0.0821 (ar) (250.5x)² 2 2.5 123/M/G\arrow_forward
- When 127. mg of a certain molecular compound X are dissolved in 55.0 g of dibenzyl ether point of the solution is measured to be 1.6 °C. Calculate the molar mass of X. If you need any additional information on dibenzyl ether, use only what you find in the ALEKS Data resource. Also, be sure your answer has a unit symbol, and is rounded to the correct number of significant digits. ((C6H₂CH₂)₂0), 2 the freezing OO B olo Xuarrow_forwardin fractional distillation, how do you tell which liquid is in which fraction and which fraction has a mix of liquids if you are trying to seperate cyclohexane and toluene?? what would the density and boiling point of the first fraction bearrow_forward12 g of unknown organic sample was dissolve in 706 mL of Dicloromethane (DCM). The boiling point of benzene was increased by 2.72oC. Determine the molecular weight of the unknown sample? Kb of DCM = 2.42oC/m Bb of benzene = 39.6 oC density of benzene = 1.33 g/mL at 25 °C Round your answer to the nearest whole number, no units required.arrow_forward
- Explain how you could separate an equimolar mixture of Compound A, B and C. (a flow chart). Organic solvent: ether,methylenechloride; Aqueous solution: HCI (ag),NaOH (ag), NaHCO3(ag)arrow_forwardIn the preparation of 1,200 mL of 70% alcohol from stock absolute alcohol solution, what is the volume of Diluent that must be added to the stock absolute alcohol?arrow_forwardA standard solution is prepared by diluting the stock solution and used in chemical analysis for preparing the standard curve. Larutan piawai disediakan dengan melakukan pencairan larutan stok dan digunakan dalam analisis kimia untuk penyediaan lengkuk piawai. A) Illustrate how do you prepare a stock solution of 0.01 g of NaNO2 in one liter of distilled water in laboratory.arrow_forward
- We obtain the value of the ebulloscopic increase of a solution with respect to the solvent. The measured boiling point for the solvent, with its absolute error, is 177±2°C; and that of the solution, 183±4°C. Indicate the statement that is correct.(A). From this experiment it is not possible to give a significant value for the ebulloscopic increase.(B). The ebulloscopic increase is 6±4°C.(C). The relative error in the measurement of the boiling temperature of the solution is twice the relative error in the measurement of the boiling temperature of the pure solvent.(D). The relative error of ebulloscopic magnification is, in round numbers, 2%.arrow_forwardFractional distillation can be represented on a temperature-composition diagram using a stair-step progression that systematically enriches the less volatile component of the mixture in the gas phase. True Falsearrow_forwardThe picture is 1.)A 1B.) If DHsolution for dissolving DMSO in methanol is negative, what does this say about the energy released in mixing methanol and DMSO molecules (DHmixing) as compared to the energy required in separating solute molecules from each other (DHsolute) and separating solvent molecules from each other (DHsolvent)? What can you conclude from this about the strength of DMSO-methanol interactions? Which “wins” in this case? Enthalpy? Entropy? Both? Explainarrow_forward
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning