Experiment1_SimoneDo_14186997_250822

Can you please help me with this homework question? Will thumbs up

1) The following is not an example of a Thyristor a) A Silicon Unilateral Switch b) A TRIAC c) A Silicon Controlled Rectifier d) Amorphous Limpid Trilateral Rodomontade

In the figure below, calculate the following (use the second diode approximation): NiNg D₁ 6:1 Si Vp 120 Vac 60 Hz (a) Vs (b) Vout(pk) (c) Vdc V₂ D₂ 十 Si R₁-500 out (d) IL (e) PIV for D₁ and D₂ (f) fout

Moving to another question will save this response. Quèstion 3 In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases. True False Moving to another question will save this response. to search 近

Question 15 In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases. True False Moving to another question will save this response. ip

What is wrong in this diode? Mullimeter XMMI 35.733 M2 1 dB XMM1 IDEAL DIODE Set O A. Short Circuit O B. None of them O C. Nothing is wrong O D. Not enough data to answer this question O E. Open Circuit

1. How is the capacitor value here calculated? 2. Make a circuit analysis

Conclusion experiment Zener Diode

Question Completion Status: A Moving to another question will save this response. Quèstion 1 Using complete diode model and assuming that the forward resistance of thediode is 152 and a Germanium diode, the voltage across the resistance R equals to R. 5kQ 12V 11.65 V 11.7 V 12 V None of the above.

Please in typing format     Please answer all subpart please let

Someone help me please. I am in a lot of trouble with this question. Someone give me correct the answer to this question please. Please, please, please, please, please, give me correct answer, I am very tensed.please

PROBLEM: The diode (blue line) should be at -10V not -8V SOFTWARE USED: LTspice XVII---Figure 1 is my work, and figure 2 is the correct sample. Please tell me what I did wrong. Thank you :))---Below is the .asc filehttps://www.mediafire.com/file/zxauoh86zi79nfu/EXPERIMENT_01.asc/file

When a 97.36 Hz sinusoidal voltage is applied to the input of a half-wave rectifier, the output frequency (in Hz) is Round your answer to 2 decimal places. Add your answer

The density of doping of zener diode is less than normal diode. True False E 00

B For the figure shown, If SCR 3 and SCR 4 are conducting. The output voltage of three phase controlled rectifier is 3 + m m Vdc C n m A a b 1567 g 8.0 2

Moving to another question will save this response. Quèstion 2 The density of doping of zener diode is less than normal diode. True False Moving to another question will save this response.

· A single-phase controlled rectifier bridge consists of one SCR and three diodes as shown in figure. The average output voltage and power delivered to battery for a firing angle of 45° are R = 52 D3 230V L= 8mH %3D 50 Hz D D2 E= 100V (a) 88.37 V, 1.837 kW (b) 191.88 V, 1.876 kW (c) 100 V, 3.525 kW (d) 88.37 V, 3.525 kW

The diode from the following characteristic curve in Figure 1 was changed to zenerdiode. Determine: the zener impedance if the zener diode voltage changes from 4.59 V to 4.84 Vwhen the current changes from 5.0 mA to 10.0 mA.

In reference to the given circuit, what is the peak load voltage Blank 1 if the diode drop is 0.65V and the lower diode is busted? Round-off your FINAL ANSWER 2 decimal places. {Numbers only} Vin Vout 10:1 BA281 110 VRMS N2 60 Hz N1 N3 R 500 Sine Wave 1N3492

Size the capacitive filter for a source with the following parameters: - bridged full wave rectifier  - Current (Icc) = 0.5 A  - Average voltage at the input of the capacitor = 16 V  - We want the ripple voltage to be at most 10% Mark the correct alternative: a) We will use a 470 micro Faraday 25 Volt electrolytic capacitorb) We will use a 220 micro Faraday 25 Volt electrolytic capacitorc) We will use a 2200 micro Faraday 25 Volt electrolytic capacitord) We will use a 4700 micro Faraday 25 Volt electrolytic capacitore) None of the above answers are correct.

QUESTION 11 The voltage signal coming out of the capacitor is with small ripples compare to the voltage signal out of the diode. O True O False

The diode from the following characteristic curve in Figure 1 was changed to zenerdiode. Determine: the function of zener diode in reverse biased. Briefly explain the differencebetween conventional diode and zener diode.

please please please solve it fast

Required information A diode is operating with iD= 460 μA and vD = 0.75 V. Calculate the saturation current /s if n = 1.07. (Round the final answer to two decimal places.) The saturation current is 15.44 xx 10 -16 A

For a single-phase half wave-controlled rectifier with RL load, use the chart below to find the commutation angle ß for the following cases 1) (a=40°, 0=15° then ß= ) 2) (a=80°, 0 =0° then B= ) 3) (α =100°, 0 =45° then = ) 4) (a=120°, 0=75° then ß= 180° Conduction Angle (0) 160° 140° 120° 100 80° 60% 40% 20° 0° p=0 $=15 6=30 + + 20° 40° 60° X6=75 $90 80° 100 120° Delay Angle (0) 140⁰ 160° 180°

The reverse recovery time of a diode is 8μs and rate of fall of diode current trr di dt = = 10 A/μs, then charge stored during reverse recovery time is A 240μC B 320μC c640μC D 340μC

Question 5 Tabulate three differences between p-n and Schottky diodes

Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)

6..EDC

/1/A single-phase, half-wave, controlled has a source 220V at 50 HZ and is eding a load R=2002 and L=25 mH, the firing angle a=60° and the current tinction angle ß=225° Determine the average load voltage and current. O Determine the rms load voltage and current. led rectifier the value of the output

31.11 here is a WRONG answer, I think the answer should be 30.41 since it need to be subtracted to 0.7 making it 30.41. Kindly solve it"

take Vs=333V round off to 3 decimal places