Answered: . Explain the concept of Azeotropic…

. Explain the concept of Azeotropic distillation for the separation of Acetone, chloroform with neat sketch. (4 + 1 = 5Marks

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter20: Nucleophilic Substitution Reactions: Competing Nucleophiles

Section: Chapter Questions

Problem 7Q

See similar textbooks

Related questions

Q: in the separation of these 8 organic herbicides using HPLC in two different modes: Isocratic elution…

A: Solution: i) part Comparison of isocratic elution and gradient elution in this experiment: Isocratic…

Q: When a mixture of A and B were subjected to paper chromatography, A moved up higher than B. However,…

A: The question is based on the concept of chromatography. It is a method of separation and…

Q: For a two-solvent recrystallization, you should have one solvent (solvent # 1) in which your desired…

A: In the process of crystallization first the solid compound is dissolved (In solvent 1) at boiling…

Q: 3 days at room temperature (25°C). 3. Filter the extracts in vacuum using Whatman filter. 4.…

A: The diagram is given as,

Q: Water and chloroform has a partition coefficient of 5.00. A 50.00mL sample of a 8M aqueous solution…

A: The distribution constant or the equilibrium constant, K is called the partition coefficient which…

Q: 1) How would GC analysis resolts be difforent if they were Kept outon a shelf in lab instrad of…

A: Interpretation- We have to tell how would GC analysis results be different if they were kept out on…

Q: For the extraction of acid from a mixture of carboxylic acid and biphenyl you began with 200 mg of…

A: Percent recovery can be calculated using the initial amount and amount recovered.

Q: separate a mixture containing acetone, acetamide and 1,2-dichloroethane using a high- performance…

A: HPLC is based on the principle where the sample (analyte) is distributed between a mobile phase…

Q: After the liquid-liquid extraction of caffeine, you are removing the dichloromethane solvent on the…

A: The rotary evaporator may be described as the physical efficient technique that is used to convert…

Q: Vitamin C Analysis, a student accidentally puts 1.0 g of sodium bicarbonate (NaHCO3) solid into the…

A: The sodium bicarbonate (NaHCO3) solid is a base which neutralises the acid in the reaction. Hence it…

Q: A 72.0 g sample of an organic solid is dissolved in 180mL of water. The solid is extracted using one…

A: A question based on analytical separation that is to be accomplished.

Q: Calculate the percent error in Avogadro's number calculated by using the following experimental…

A: Concentration of stearic acid = 1.2×10-4gram/milliliter.Number of drops to complete monolayer = 23…

Q: A. Water and chloroform has a partition coefficient of 5.00. A 50.00mL sample of a 8M aqueous…

A: The partition coefficient for water and chloroform is given to 5.00. We are required to calculate…

Q: Using Equation 5.9, show that three extractions with 5-mL portions of a solvent give better recovery…

Q: 1) To estimate the accuracy and precision of the method of determination of glucose in a blo sample,…

A: Accuracy can be defined as how close the reading is to actual reading . It can be measured by…

Q: 1.) Would recrystallization work if you more impurity than product and both were soluble in the…

Q: Of Aspirin, ethanol, acetaminophen, ethyl acetate, hexane, and water which could go undetected…

A: HPLC or high perfomance liquid chromatography is a usefull technique to separate and analyse…

Q: Explain the working of fixed-bed carbon solvent recovery system.

A: An atom is the basic and fundamental unit of matter. An atom consists of electrons and the nucleus…

Q: hydrophobic silica gel plates. He then placed each plate in separate developing chambers, one…

A: Concept- In thin layer chromatography, the distance from the baseline of the given compound divided…

Q: Assume an organic compound has a partition cocfficient between water and ethyl acetate equal to…

Q: 1. What is the difference between distribution coefficient and distribution ratio? 2 How does SPE…

A: Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question and…

Q: 10) What is the purpose of a brine wash (saturated sodium chloride solution) in a liquid/liquid…

A: Liquid / Liquid extraction- It is a separation technique used to separate compounds by using two…

Q: what are key reactions involved in seperation of liquid mixtures by simple and fractional…

A: Introduction: Chromatography and distillation is a technique used to separate the mixture of…

Q: profile-image Time remaining: 00 : 09 : 27 Chemistry A group was given the responsibility of…

A: Solutions- The solubility of three different solvents are given in g/100ml solvent

Q: Draw an HPLC instrument diagram by writing the name of the parts. Define the isocratic and gradient…

A: The analytical method that deals with the separation of the components based on the difference in…

Q: Gravimetric factor: A 1.0125 g portion of the sample was oven-dried leaving 0.9385 g of dry matter.…

Q: Gestation time arrangement of Hegran, Hexanol, and Benzene compounds in the reverse phase of column…

A: A question based on analytical process that is to be accomplished.

Q: B. There was big news all over the internet that the Ponkan oranges that were imported from one of…

A: Gas chromatography: Gas chromatography is an analytical technique used to seperate the…

Q: In the multistep reaction, a bromine in acetic acid solution was used that contained 0.15mL of…

A: A bromine in acetic acid solution was used that contained 0.15mL of bromine in 0.3mL of acetic acid.…

Q: After the extraction of benzoic acid from 0.5g impure sample, the weight of pure benzoic acid in the…

A: The given data- The weight of the impure sample = 0.5 g The weight of the pure benzoic acid = 0.4 g…

Q: The following compounds were placed into a column of silica gel for liquid chromatography 1,3…

A: In silica chromatography, we use silica which is acidic in nature. All the basic compounds do not…

Q: A novel compound named “sanaoline” with a partition coefficient (KD) of 6 was extracted from 5.0…

A: Formula for partition coefficient w = W[KD V/(KDV +v)]n Where w is reaming amount of sanaoline = ?…

Q: A brewed tea brand sample was subjected to solvent extraction to extract caffeine. The cup of tea…

Q: kindly help me with this problem thank you ill give like for the answer mixture consists of a…

A: You have to supply distribution coefficient . I am solving that by considering distribution…

Q: A countercurrent extraction cascade is used to extract acetone (A) from its mixture with water by…

A: Given, countercurrent extraction cascade is used to extract acetone (A) from its mixture with water…

Q: Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many…

A: Given that., Distance traveled by the spot from bottom = 3.52 cm Distance travel by mobile phase =…

Q: Extraction of the aqueous salicylic acid solutions with 10% ethyl acetate/hexane (density ~ 0.7…

A: During the extraction process, the two layers organic and aqueous settle separately. The one which…

Q: Crystallization of Benzoic Acid from Water and a Solvent Pair and Melting Point determination of…

A: Recrystallization is a technique used to purify solid compounds. This is done by dissolving the…

Q: Earth, a CHEM 40.1 student, extracted a mixture of pigments from the roots of Rubia tinctorum,…

Q: The goal of the recrystallization procedure is to obtain purified materlal with a maximized…

A: Recrystallization also named fractional crystallization. It is a method used for the purification of…

Q: propose experimental design on the separation of components of the mixture of benzoic acid and…

Q: is hexane or 70:30 hexane: ethyl acetate a better eluent based on their TLC plates and rf value in…

A: Misciblity is main factor which determine that which solvent are best eluent based on their TLC…

Q: i need help calculating the therotical yield based on the data in the lab and please show me the…

Q: A 0.01kg plant extract in 2dm' of water was shaken with 0.1dm' ether. Upon checking, 1.7x10 kg of…

A: Mass of plant extract = 0.01 kg = 10 g

Q: Calculate the amount of phycocyanin in Sample 1 in mg where A620=0.211 and A650=0.086, taking into…

A: Phycocyanin is a protein-pigment complex that belongs to the family of phycobiliprotein. It is a…

Q: 1. A solution containing 5.0 g of n-butyric acid in a 100 mL of water was extracted two times with…

A: Partition or distribution coefficient (KD) is the ratio of concentration of a compound in two…

Q: Which of the following methods of preparing 0.0010M HCl solution from 1.0M stock HCl Solution will…

A: The task is to determine overall uncertainty while preparing 0.0010 M HCl solution from 1.0 M stock…

Question

100%

1. Explain the concept of Azeotropic distillation for the separation of Acetone, chloroform with neat sketch. (4 + 1 = 5Marks) . 2. Explain the application of extractive distillation in nitric acid dehydration using suitable solvent with neat sketch . (4 + 1 = 5Marks) .

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Extraction of the aqueous salicylic acid solutions with 10% ethyl acetate/hexane (density ~ 0.7 g/ml) will give two layers in the separatory funnel. Will the aqueous layer be the upper layer or the lower layer? If dichloromethane (density ~ 1.3 g/ml) were substituted for the 10% ethyl acetate/hexane solution, which layer would be the aqueous layer?
A student recrystallized some impure benzoic acid and isolated it by filtration. He scraped the purified benzoic acid off the filter paper after it had dried and took the melting point as a test for purity. He was surprised that most of the white solid melted sharply between 121 and 122 0C but that a small amount remained unmelted even at temperatures above 200 0C. Explain this behavior.
Describe and explain the effect(s) on your result for the following possible experimental errors. In each case, specify the component(s) whose percentage(s) would be too high or too low and explain your rationale why these would be changed. (a) After adding DCM to the counterfeit pharmaceutical at the beginning, you didn’t stir or shake the mixture before filtering. (b) Washing the sucrose recovered during the first vacuum filtration with water rather than DCM. (c) During the NaHCO3 extraction, you failed to mix the organic and aqueous layers thoroughly. - B (d) You mistakenly extracted the DCM solution with 5% HCl rather than 5% NaHCO3. (e) You neutralised the NaHCO3 solution to pH7 rather than pH2.
Why sometimes derivatization is used in the sample preparation for GC-MS?
is hexane or 70:30 hexane: ethyl acetate a better eluent based on their TLC plates and rf value in column chromatography separation of ferrocene-acetylferrocene.
Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected after recrystilization 8. Let's assume that the melting point of the recrystallized product was 104-108°C. What conclusions can you draw? Provide a brief discussion of these results.
How do I calculate preparation of mobile phase 25mM ammonium acetate in 0.1L from ammonia 25% and acetic acid glacial 100%?
A TLC plate showed two spots with Rf values of 0.25 and 0.26. The plate was removed from the developing chamber, the residual solvent was allowed to evaporate from the plate, and then the plate was returned to the developing chamber. What would you expect to see after the second development was complete?
Which of the following is expected to achieve the best recovery of an organic compound from an aqueous solution? 1.Three extractions with 20 mL of ethyl acetate per extraction (60 mL total) 2.Two extractions with 30 mL of ethyl acetate per extraction (60 mL total). 3.One extraction with 60 mL of ethyl acetate. 4.In theory these extractions yield identical recoveries of the organic compound.
Briefly explain why should the flask be stoppered after the addition of KI in the standardization of sodium thiosulfate VS.
Which of the following could DECREASE the amount of the recovered crystals in the purification by recrystallization experiment? Collecting the recrystallized benzoic acid by filtration using a pre-weighed filter paper. Using a long-stemmed funnel in the hot filtration step. Cooling the filtered solution rapidly. Washing the recovered crystals using hot solvent. a. II, III b. II, IV c. II, III, IV d. I, II, III, IV
For this experiment, yield was not important, but in onsite lab, as well as large-scale processes, a good yield is crucial in the success of a purification step. In what ways do you think a high yield can be assured in recrystallization?