10.Consider synthesis of nylon-6,10 from stoichiometric amounts of hexamethylene diamine, H2N(CH2)6NH2, and sebacic acid, HOO(CH2)8COOH. At 98% conversion of carboxylic acid groups, determine (a) Mn and Mw of the product,

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter31: Thermal Methods

Section: Chapter Questions

Problem 31.5QAP

See similar textbooks

Related questions

Q: Using the information below, calculate the percentage w/V of lidocaine (MM (234-34 g/mol) in…

Q: It was found that solubility of benzoic acid in water at differont temjperatures Was according to…

Q: 4. At 25 °C, 1.0 g of caffeine will dissolve in 47 mL of water, in 8.1 mL of chloroform, in 86 mL of…

A: The solubility of caffeine in g/100mL in each of the solvents can be calculated as:

Q: Look up the pKa values for trimethylamine, dimethylamine, ethylamine, and ammonia. Predict the order…

A: Ion exchange chromatography is the process by which a mixture of similar charged ions can be…

Q: 3. Calculate the mean-square end-to-end distance and root-mean-square radius of gyration of…

A: Given data: Characteristic ratio, C = 6.9 bond length, l = 0.12nm Formula used: Mean square…

Q: Briefly outline the experimental procedure used in obtaining the data required for External-Standard…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: 2. Separation of Amino Acids by lon-Exchange Chromatography Mixtures of amino acids can beanalyzed…

A: Introduction: Chromatography is a technique used to separate the mixture if solution. There are two…

Q: Given: A weak acid, HA (whose Ka is 1.00 x 10-6 and KD is 100) that distributes between benzene and…

Q: Write three substances or species that can be determined using each of the following instrumental…

A: Introduction: A pH meter is a device used to measure the hydrogen ion activity in the solution. The…

Q: 3 days at room temperature (25°C). 3. Filter the extracts in vacuum using Whatman filter. 4.…

A: The diagram is given as,

Q: 4. A 0.1475-M solution of Ba(OH)2 was used to titrate the acetic acid (60.05 g/mol) in a dilute…

A: Molar concentration, also known as molarity, is defined as the number of moles of solute present in…

Q: Give advantages of Ziegler–Natta catalysts ?

A: A group of catalysts are collectively termed as Ziegler-Natta catalysts. They are compounds of…

Q: A feed mixture containing 50 wt% n-heptane and 50 wt% methyl cyclohexane (MCH) is to be separated by…

Q: Jörgen et al. Extracted acrylamide from potato chips by soxhlet extraction. They used methanol as a…

A: From the unit (hours) given it can be concluded that time has been plotted in X-axis.

Q: For the copolymerization of monomer (M1) with monomer (M2), the reactivity ratio's are r1 = 0.33, r2…

A: Combining the co-polymer equation or Mayo-Lewis equation in polymer chemistry with the equation for…

Q: Calculate the yield of tert- butyl chloride if we take 7ml of tert- butanol and the actual mass of…

A: Given in questiin: Moles ratio =1:1 Volume of tert-butanol = 7mL Molecular weight of tert-butanol…

Q: What is the essential difference between the Langmuir and BET isotherms?

A: The adsorption of the gases and the solute is basically explained through isotherms. The adsorbate…

Q: Ethyl heptanoate (EH), a food aroma compound, was added to water and allowed to come to equilibrium…

A: Partition coefficient is the ratio of concentrations of a particular compound distributed in a…

Q: If the enthalpy change of an enzymatic reaction associated with the conversion of 2000 g of a target…

Q: For a normal phase separation, predict the order of elution of the following compounds a. n-hexane,…

A: Polarity is the property of having differences in electronegativity. If there is a difference in…

Q: There is a class of polyesters that have the general structure shown below. For example, in…

A: Since in the above case, molecular weight is constant and it will affect the glass transition…

Q: Distinguish between TSS and TDS to understand why one is a physical parameter and the other is a…

A: Distinguish between TSS and TDS to understand why one is a physical parameter and the other is a…

Q: 6. Below is an extraction scheme in which a mixture of four initial organic compounds is separated,…

A: Given is four different types of compounds, phenol, neutral ,base and carboxylic acid. We can…

Q: Ethane (C2H6) is burned with (0.8) theoretical air, assuming complete combustion of hydrogen in the…

Q: It can be shown mathematically that 2 or more smaller extractions (using smaller portions of a…

Q: v- BTEXS are a class of volatile organic compounds that should be monitored and measured regularly…

Q: (b) A 2.000 g of an organic compound X was dissolved in 50.00 mL of dichloromethane. This organic…

Q: Derive the equations for the critical parameters VC, TC, and PC, (in terms of a, b and R) for the…

A: Given: critical parameters VC, TC, and PC, (in terms of a, b and R) for the Berthelot EOS To…

Q: Fumarase catalyzes the hydration of fumarate to L-malate via the following reaction: Fumarate + H2O…

Q: Predict the major fractions of this molecule in GC/MS:

A: The chemical formula of the given compound: C27H33NO2 The exact mass of the given structure: 403.25…

Q: An organic compound is extracted from an aqueous phase using an organic solvent: 40 ml of the…

Q: When a Levy-Jennings graph for TSH was checked, the mean of results was found to have shifted by…

A: Ans. (a) This is a systematic type error (a constant shift in one direction). Systematic or bias…

Q: The partition coefficient, Kp. at 25°C (1.e., room temperature) for compound A is 9.71 (for water…

Q: Briefly explain four importance of conducting sample preparation prior to instrumental analysis.

A: Sample preparation is a very crucial step in experimental analysis . This is one of the most…

Q: 1. The properties that must be possessed by the adsorption reagent in air sampling are… a. Reagents…

A: Air sampling is the process by which the type and quantity of airborne contaminants present in an…

Q: 4. For the system in question 2, estimate tlGo for micellization if the molecular weight of the…

A: Gibb’s free energy (∆G)– Formula is, ∆G=∆H-T∆S Where, ∆G= Gibb’s free energy ∆H=change in…

Q: With the principles of GFC, which of the following statements is incorrect? a. For small molecules,…

A: All of the statements are correct.

Q: Predict the order of elution of the following compounds from a GC column packed with polyethylene…

A: Gas chromatography The mobile phase used is an inert gas and the stationary phase is gas or liquid.…

Q: Calculate the retardation factor (Rf) for dissolved Tetrachloroethene contamination given the bulk…

A: Soil contains various ions, nutrients and waste material present in them. This substances are…

Q: 5. By a fractional precipitation a polymer A with most probable distribution (I = 2.0) and an…

A: PDI of polymer A = 2. Weight average molecular weight = 2 × 120000 = 240000 g/mol. If mole fraction…

Q: The weight percent %W/W of a saturated solution of potassium chloride in 20CO was: (NOTE: the…

A: Given, mass of the solution = 298g Mass of KCl or mass of solute = 74.5531 g Formula for % w/w is…

Q: A 0.01kg plant extract in 2dm' of water was shaken with 0.1dm' ether. Upon checking, 1.7x10 kg of…

A: Mass of plant extract = 0.01 kg = 10 g

Q: Arrange the following compounds in order of decreasing ease of elution from a column of silica gel

A: Silica gel acts as a stationary phase in silica gel chromatography column and it retains the polar…

Q: The absorbance of a 0.5 mM aqueous salicylic acid solution was 0.925. This solution was extracted…

Q: 7) The rate of flow of Na2SO4 solution is to be controlled in an ion-exchange experiment, justify?

Q: In the experiment borohydride reduction , using 2.0g of benzophenone, a student obtained 1.6g of…

Question

10.Consider synthesis of nylon-6,10 from stoichiometric amounts of hexamethylene diamine, H2N(CH2)6NH2, and sebacic acid, HOO(CH2)8COOH. At 98% conversion of carboxylic acid groups, determine (a) Mn and Mw of the product, and (b) the sum of the mole fractions and that of the weight fractions of species containing 1 through 6 (inclusive) monomer units.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Quality Assurance and Calibration Methods

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The procedure for the synthesis of menthone indicates that you should use 10 cm³ of 6M sulphuric acid. Suppose that only sulphuric acid with concentration 1.5M is available in the laboratory. What volume in cubic centimetres of this solution do you need to add to the reaction mixture to replace the solution originally specified?
Carboxylic acids, including fatty acids and benzoic acids, are often present inboth municipal and industrial effluents. Describe a sample preparationcombined with GC method for identification and determination of carboxylicacids in raw wastewater at ppb (µg L-1) level. Point out a suitable samplepreparation technique and GC conditions in details and give justifications foryour choice
9.In the polymerization of H2 N(CH2 )10 COOH to form nylon-11, what is the molecular weight of the species that has the largest weight fraction in the reaction mixture at 99% conversion ?
In the experiment borohydride reduction , using 2.0g of benzophenone, a student obtained 1.6g of filtered material. Calculate the percentage yield and comment on whether this represents the true yield of the reaction product diphenylmethanol.
In a sample consisting of lysine, leucine, and glutamic acid, which will be eluted last from an anion exhange resin at pH7?
What is the essential difference between the Langmuir and BET isotherms?
Chemistry Sketch a flow chart of the entire caffeine extraction and purification used in the laboratory (Caffeine extraction from tea). Show all major steps in the recovery of caffeine crystals and provide a detailed description of the workflow required to recover the crystals. must include the rationale for the key steps in the protocol, describing why each step is performed.
The solubility of Lorazepam (a tranquilizer found in Emotival , Lorax, Wypax, and other prescription medicines) is 0.08mg/mL and 2.62mg/mL, in water and chloroform, respectively. Estimate the partition coefficient of lorazepam between chloroform and water. 3. The solubility of benzoic acid at 25 degrees Celsius in water and diethyl ether is 3.35 mg/mL and 0.353 g/mL, respectively. Estimate the percent recovery of benzoic acid in the organic phase, if a solution of benzoic acid in water is extracted with an equivalent volume of ether. [HINT-pay attention to the units] 4. The solubilities of cholesterol in water and chloroform are 0.550mg/100mL and 1.00g/5.25mL, respectively. Estimate the partition coefficient of cholesterol between chloroform and water. [HINT- units] What conclusion can be drawn about the polarity of cholesterol?
The researcher extracts a sample of well water and prepares it for TXRF analysis with a 10.00 mg/L V internal standard, like the calibration standards. The result produces SCa = 69297.81 and SV = 13481.2.Determine the concentration of Ca.
Deduce the equilibrium ratio of NH4+ to NO3- at a pH of 6.0 (a) for aerobic water having a pE value of +11, and (b) for anaerobic water for which the pE value is -3.
The partition coefficient of ammonia between water and chloroform is wanted to be determined. The necessary quantities of ingredients are taken into the separation funnel, and the extraction process is applied. At the end of the extraction process, 5 mL portions of each of the water and chloroform phases are titrated with 0.1 M HCI in the presence of methyl orange indicator. If the volumes spent at the turning points are 7.2 and 5.1 mL, respectively, calculate the KSU, KLOROFORM (Dispersion coefficient) value.
Thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) are widely applied for the thermal analysis of food samples. (a.) With the aid of diagrams, explain how the measurement is achieved using these two methods. (b.) Which of the method is more preferred in the determination of the change of physical structure of food samples? Explain your answer briefly.