2. A rectangular plate 4X8 in. is in full contact with the base of a fixture. The hole in the workpiece has been machined to 1.500 in. at the exact center of the plate. Figure 2 shows this plate. The plug diameter is 1.495. Calculate: a) the maximum height of the plug if the 4-in. side is lifted of the plug, and b) the maximum height of the plug if the 8-in. side is lifted off the plug. c) Compare the two plug designs.

2. A rectangular plate 4X8 in. is in full contact with the base of a fixture. The hole in the workpiece has been machined to 1.500 in. at the exact center of the plate. Figure 2 shows this plate. The plug diameter is 1.495. Calculate: a) the maximum height of the plug if the 4-in. side is lifted of the plug, and b) the maximum height of the plug if the 8-in. side is lifted off the plug. c) Compare the two plug designs.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Calculate the vertical and horizontal distances for three equally spaced holes on a 4-in. diameter circle located in the center of a 6-in.-square plate.
A 3/4-in.-diameter hole is drilled in a piece of 1-in.-thick steel; the hole is then countersunk as shown. Determine the volume of steel removed during the countersinking process.
In a lathe machine, The diameter of the driver and driven pulley are 2745 mm and 1200 mm respectively, And the driver pulley runs at speed of 225 rpm. Find the speed at which is driven pulley runs in the machine. the speed of the driven pulley in rpm is
With clear concise answer. Round off to 4 decimals thank u. (15ft) Shown in illustration
3 29knd. A cylinder of 50 mm diameter and height 60 mm is resting on base in H.P. A circular hole of 20 mm diameter is drilled , so that the axis of the hole is perpendicular to V.P and bisects the axis of cylinder at right angles . Draw the development of the lateral surface of the cylinder with the slot . Draw neatly with pencil and take correct values must**
a circular copper rod is 20.02 mm in diamter and has to be insterted into a square hole that is 20.0 mm on each side . How much does the shaft need to be cooled to allow this operation ?
The machine tool diagram below shows a symmetric worm thread, in which a circular roller of diameter 1.5 inches sits. Find the amount d that the top of the roller rises above the top of the thread, given the information in the diagram.
Two parallel shafts, 36 inches apart are connected by a belt drive. The driving pulley rotates at 600 RPM and the driven pulley at 250 RPM. The smaller pulley diameter is 10 inches. For both an open and a crossed belt, determine: A. the length of the belt.
Draw a common tangent to two circles of diameter 6cm and 4cm respectively if the distance between their centers is 12cm
On the attached part print, what is the diameter of the part at points "D" and "E"?
Pls her solve with explain
An engineer is using a machine to cut a flat square of Aerogel of area 144 sq. c.m. If there is a maximum error tolerance in the area of 8 sq. c.m., how accurately must the engineer cut on the side, assuming all sides have the same length? How do these numbers relate to δ, ε, a, and L?