3-6 3 SOLUTIONS AND NAME SOLUTION CONCENTRATIONS 1415 Section Pre-Lab Assignment Experiment objectives A, B, and C require you to devise procedures for preparing a saturated aqueous solution of potassium sulfate, experimentally determining the density of this solution, and experimentally determining the mass percent of potassium sulfate in this solution. Your pre-lab assignment is to develop procedures for parts A, B, and C. You will then execute these procedures in lab. PREPARATION OF A SATURATED AQUEOUS POTASSIUM SULFATE SOLUTION Reminder: use a maximum of 75 ml of water. A. B. DENSITY OF SATURATED AOUEOUS POTASSIUM SULFATE SOLUTION MASS PERCENT OF POTASSIUM SULFATE IN A SATURATED POTASSIUM SULFATE SOLUTION C.

3-6 3 SOLUTIONS AND NAME SOLUTION CONCENTRATIONS 1415 Section Pre-Lab Assignment Experiment objectives A, B, and C require you to devise procedures for preparing a saturated aqueous solution of potassium sulfate, experimentally determining the density of this solution, and experimentally determining the mass percent of potassium sulfate in this solution. Your pre-lab assignment is to develop procedures for parts A, B, and C. You will then execute these procedures in lab. PREPARATION OF A SATURATED AQUEOUS POTASSIUM SULFATE SOLUTION Reminder: use a maximum of 75 ml of water. A. B. DENSITY OF SATURATED AOUEOUS POTASSIUM SULFATE SOLUTION MASS PERCENT OF POTASSIUM SULFATE IN A SATURATED POTASSIUM SULFATE SOLUTION C.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 27QRT: Refer to Figure 13.10 ( Sec. 13-4b) to answer these questions. (a) Does a saturated solution occur...

See similar textbooks

Similar questions

6-112 List the following aqueous solutions in order of increasing boiling point: 0.060 M glucose (C6H12O6), 0.025 M LiBr, and 0.025 M Zn(NO3)2.Assume complete dissociation of any salts.
A solution is made by dissolving 34.0 g of NaCl in 100 g of H2O at 0C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated
6-96 We know that a 0.89% saline (NaCI) solution is isotonic with blood. In a real-life emergency, you run out of physiological saline solution and have only KCI as a salt and distilled water. Would it be acceptable to make a 0.89% aqueous KCI solution and use it for intravenous infusion? Explain.
6-103 A swimming pool containing 20,000. L of water is chlorinated to have a final CI2 concentration of 0.00500 M. What is the CI2 concentration in ppm? How many kilograms of CI2 were added to the swimming pool to reach this concentration?
Some lithium chloride, LiCl, is dissolved in 100 mL of water in one beaker, and some Li2SO4 is dissolved in 100 mL of water in another beaker. Both are at 10 C, and both are saturated solutions; some solid remains undissolved in each beaker. Describe what you would observe as the temperature is raised. The following data are available to you from a handbook of chemistry:
6-67 Calculate the freezing points of solutions made by dissolving 1.00 mole of each of the following ionic solutes in 1000. g of H2O. (a) NaCI (b) MgCI2 (c) (NH4)2CO3 (d) AI(HCO3)3
6-111 As noted in Section 6-8C, the amount of external pressure that must be applied to a more concentrated solution to stop the passage of solvent molecules across a semipermeable membrane is known as the osmotic pressure The osmotic pressure obeys a law similar in form to the ideal gas law (discussed in Section 5-4), where Substituting for pressure and solving for osmotic pressures gives the following equation: RT MRT, where M is the concentration or molarity of the solution. (a) Determine the osmotic pressure at 25°C of a 0.0020 M sucrose (C12H22O11) solution. (b) Seawater contains 3.4 g of salts for every liter of solution. Assuming the solute consists entirely of NaCl (and complete dissociation of the NaCI salt), calculate the osmotic pressure of seawater at 25°C. (c) The average osmotic pressure of blood is 7.7 atm at 25°C. What concentration of glucose (C6H12O6) will be isotonic with blood? (d) Lysozyme is an enzyme that breaks bacterial cell walls. A solution containing 0.150 g of this enzyme in 210. mL of solution has an osmotic pressure of 0.953 torr at 25°C. What is the molar mass of lysozyme? (e) The osmotic pressure of an aqueous solution of a certain protein was measured in order to determine the protein's molar mass. The solution contained 3.50 mg of protein dissolved in sufficient water to form 5.00 mL of solution. The osmotic pressure of the solution at 25°C was found to be 1.54 torr. Calculate the molar mass of the protein.
6-99 A concentrated nitric acid solution contains 35% HNO3. How would we prepare 300. mL of 4.5% solution?
6-21 Are mixtures of gases true solutions or heterogeneous mixtures? Explain.
6-54 An industrial wastewater contains 3.60 ppb cadmium Cd2+. How many mg of Cd2+ could be recovered from a ton (1016 kg) of this wastewater?
How do colloids differ from solutions with regard to dispersed particle size and homogeneity?
6-38 Describe how we would prepare 250 mL of 0.10 M NaOH from solid NaOH and water.