3. A student performed this experiment, and formed the solid Ag2CrO4. The solution above theprecipitate was removed and tested in the spectrophotometer, as you did. The [Cr042-] ion readfrom the graph, was determined to be 6.67 x 10-5 M.a. What is the [Ag+] in this solution?b. Calculate the Ksp based on these experimental results?

The solubility of [CrO42-] = 6.67 × 10-5 M. The reaction is, Ag2CrO4⇌ 2 Ag++ CrO42-

3. A student performed this experiment, and formed the solid AgoCr04. The solution above the precipitate was removed and tested in the spectrophotometer, as you did. The [CrO42-1 ion read from the graph, was determined to be 6.67 x 10-5 M. a. What is the [Ag+] in this solution? b. Calculate the Ken based on these experimental results?

3. A student performed this experiment, and formed the solid AgoCr04. The solution above the precipitate was removed and tested in the spectrophotometer, as you did. The [CrO42-1 ion read from the graph, was determined to be 6.67 x 10-5 M. a. What is the [Ag+] in this solution? b. Calculate the Ken based on these experimental results?

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter13: Mass Spectrometry

Section: Chapter Questions

Problem 2Q

See similar textbooks

Similar questions

Following the experimental procedure, a student combined 5.00 mL of 0.0020 M Fe3+ and 1.00 mL of 0.0020 M SCN- with 4.00 mL of water to create their Trial 1 solution. The student used their spectrophotometer to measure the absorbance of the reaction mixture and recorded an absorbance of 0.095. a. The initial concentration of Fe3+: M (give to nearest 0.0001 M) b. The initial concentration of SCN-: M (give to nearest 0.0001 M) c. The equilibrium concentration of FeSCN2+: (give as decimal to nearest 0.000 001)Hint: The extinction coefficient of FeSCN2+ is 4,630 M-1*cm-1 and the cuvettes we use have a path length of 1.0 cm. d. The equilibrium concentration of Fe3+: M (give as decimal to nearest 0.000 001 M) e. The equilibrium concentration of SCN-: M (give as decimal to nearest 0.000 001 M) f. The equilibrium constant K: (give to nearest tens place)
In a Chemistry lab experiment, typically, a solid chloride unknown (not the AgCl product) for analysis is dried in an oven to remove adsorbed water before the analysis. How would the % Cl determined be affected (Would the calculated %Cl be too high or too low?) if the unknowns had not been dried? Explain.
Describe one alternative column other than a C18 for caffeine detection in terms of stationary phase
Why BH 3-THF not BH 3 is used in the experiment? Plz do Asap....!
The maximum safe [Ba2+]=1.5x10-5M. Maintaining 1.0x10-3M levels for each of the anions below would ensure that this level is achieved except (Ksp of BaF2=1.7x10-6, BaCO3=5.9x10-9, BaC2O4=7.4x10-14, and BaSO4=1.1x10-10) A SO42- B C2O42+ C CO32- D F-
How would the equilibrium be affected in regards to the value of Qc or Kc for each of the following conditions?: Fe3+ (aq) + SCN- (aq) ⇌ FeSCN2+ (aq) Adding KSCN (aq) Adding Fe(NO3) (aq) Adding NaF (s) Placing the solution into a hot water bath Placing the solution into an ice bath (To whom this may concern, Could you at least explain one as simply as possible so I'm able to understand the others enough to explain them myself? Thanks in anvance!)
At 21 °C, a solution of 12 mL each of 0.00200 M Fe3+ and 0.001000 M SCN- was mixed and brought to 25.0 mL with 0.1 M HNO3. The absorbance at 450 nm was measured to be 0.350 (A450 = 0.350). This solution was then heated to 45 °C and the absorbance at 450 nm was measured to be 0.142 (A450= 0.142). Is the reaction: Fe3+(aq) + SCN -(aq) → FeSCN2+(aq) exothermic or endothermic? Explain.
Which experiment is NOT used as a method of physically measuring the reaction rate? Spectroscopy Conductivity Pressure measurements Titration
The Ksp of Al(OH)3 (MM: 78) is 1.90 xx 10^(-33). a) What is the solubility of Al(OH)3 in g/L?
A 0.3056 g sample of soluble chloride was analysed gravimetrically for chloride content and 0.7265 g silver chloride was obtained. Calculate the chloride content of the sample in % w/w? MW Cl = 35; Ag = 108
Following the experimental procedure, a student combined 5.00 mL of 0.0020 M Fe3+ and 1.00 mL of 0.0020 M SCN- with 4.00 mL of water to create their Trial 1 solution. The student used their spectrophotometer to measure the absorbance of the reaction mixture and recorded an absorbance of 0.095. Find the following: Hint: The extinction coefficient of FeSCN2+ is 4,630 M-1*cm-1 and the cuvettes we use have a path length of 1.0 cm. The equilibrium concentration of Fe3+: M (give as decimal to nearest 0.000 001 M) The equilibrium concentration of SCN-: M (give as decimal to nearest 0.000 001 M) The equilibrium constant K: (give to nearest tens place)
you use a 30 m long column with an internal diameter of 0.25 mm and a film thickness of 0.25 μm. (a) Estimate the value of H for this column. b) On this column, a pair of compounds that you wish to separate has an alpha. value α of 1.01 and the k value of the second component k2 is 5. Will this columns provide a resolution of greater or less than 1 or this pair of compounds.? Explain