4. Explain how the regulator circuit in Figure (2), works? E 20 V tilt 680Ω Figure (2) Iz. (Ctrl) L₁. 100-10ΚΩ

Q: Given the circuit below, find the complex power supplied by the source and the source power factor.…

A:

Q: 8. Design the network of the following circuit to maintain V₁ at 12V for a load variation (IL) from…

A: In this question We need to determine the rating of the zener diode.  We know  Power P= VZ IZ

Q: (2) 100 55 W Ix 2012 -MM- 100 V 252 MM- 852 152 Det. IT, PT, Ix R₁

A:

Q: 11.35 Determine the complex power for the following cases: (a) P = 269 W, Q = 150 VAR (capacitive)…

A:

Q: A balanced, symmetrical, 3-phase, ABC sequence source serves a balanced, symmetrical 3-phase load of…

A:

Q: A single phase Cycloconverter, if the input supply voltage is Vs- 220 V with frequency (f= 50 Hz)…

A: Given below clear explanation

Q: 1. A 4-pole dc shunt generator with shunt field resistance of 100 ohms and armature resistance of 1…

A: Note: Types of DC Machine Self-Excited DC Machine Shunt DC Machine Series DC Machine Compound DC…

Q: 10.9 In a medium, -0.05x *sin (2 × 10³t - 2.x) a. V/m E = 16e find: (a) the propagation constant,…

A:

Q: 10.11 The magnetic field component of an EM wave propagating through a nonmagnetic medium (o) is H =…

A: Given: Magnetic component of an EM wave propagating through a nonmagnetic medium:…

Q: For what reason must the wiring in the ceiling be plenum-rated?

A: Given: Plenum-rated wiring. Required: What reason must the wiring in the ceiling be plenum-rated?

Q: Problem-4 A balanced wye-connected load contains a 10 f resistor in series with 20 mH inductor in…

A:

Q: Find the transfer function, G(s)=0,(s)/T(s), for the rotational mechanical system shown below.

A: The mechanical system can be drawn as

Q: On no-load, a shunt motor takes 5 A at 250 V, the resistances of the field and armature circuits are…

A: The current is 5 A The voltage is 250 VThe resistance is 250 ohm and ohm in field and armature…

Q: determine the current i(t) Χα t = 0 12V Μ 6Ω 3Ω 6Ω www 12H i(t)

A: Given data: The given circuit is shown below,

Q: ANSWER ALL QUESTIONS TO 3 DECIMAL PLACES UNLESS OTHERWISE STATED. An ideal transformer, of rated…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. Three capacitors, C1=5 uF, C2 = 10uF and C3 = 20 uF are connected in parallel across a 150-V…

A:

Q: A discrete-time PID controller is introduced in the control system at figure 1 to improve the steady…

A: Given: In this question, the given details are, A discrete-time PID controller is introduced in the…

Q: -3 The P region of an abrupt junction diode has a resistivity of 0.1 ohm-cm and the N region has a…

A:

Q: is the current through R2 VS1 15V R1 68 VA R2 30 22 R3 100 VS2 8V

A: Given diagram:- IR2 = ?

Q: Given the following system, determine the response of the system, the roots of the system, the…

A:

Q: The circuit shown in the figure to the right has two input sources: vi(t) = 50 cos (20t – 75°) V…

A: Given that  V₁(t) = 50 cos (20-75°) V V2(t) = 35 cos(20+110°) V  V(t) = 21.25 cos (20-168.8°) V

Q: 6. ASK, PSK and FSK are examples of a. Digital to Analog c. Digtal to Digital 7. In Quadrature…

A: The given problem is from communication system. The detailed solution is given in the next step

Q: Resistive load of 84.6 MVA is connected to a bus bar with 9.4kV. If the base of 100MVA and 10kV are…

A:

Q: Ra +-WWW ea(t) J₁ = 4 kg-m² N₁ = 50 D₁ 8 N-m-s/rad OL(1) √₂ = 36 kg-m²) m²f T (N-m) 150 N₂ = 150 D₂…

A:

Q: 8) For the following circuit: a) Find the voltage across the inductor b) Find the Real Power,…

A:

Q: A single phase, 60Hz, short transmission line receives 700 MW at 0.95 lagging pr at 327.8 KV from…

A:

Q: For the circuit shown below, find the Thevenin equivalent with respect to the terminals c,d. j20 Ω…

A:

Q: RB 9 Vcc IB B + Rc VBE Vcc E Ic + VCE - Fig.4 A loadline is drawn on the BJT transistor…

A:

Q: Problem 3 For two signals x₁ (n) = {2, 1} and x₂ (n) = {-1, 2}, 个 个 a) Calculate 2-point Discrete…

A:

Q: It's hard to read，  I need handwrite solution

A: Given: To find: For all circuits, i) Transfer function, ii) Magnitude response, iii) Phase…

Q: Consider the signal ≤ n ≤2 y (n) = {0, elsewhere a) Compute the DTFT of the signal i.e. Y(w). Find…

A: Given: y(n)=1 ;0≤n≤20 ;otherwise To find: a) DTFT of the signal. Sketch the magnitude and phase…

Q: Det. C and %r it VDc=15V. 12Vrms 60 Hz D₁, $ D₂ D₁ 403 c R₁1ko

A: The given circuit is full wave rectifier with capacitive filter.

Q: Determine the best current density in A/mm² for a 3-0 overhead line if the line is in use for 2500…

A: Given data, Specific resistance ρ=1.73 Ω Conductor cost=3  per kg Weight W=6200 kg/m3 Energy cost=10…

Q: e. With reference to Figure 3 (b), use source transformations to determine the voltage Va R30 E- -9V…

A: We need to find out the output voltage for given circuit .

Q: Consider the discrete-time signal x[n] shown below. Let its DTFT be denoted by X (ein). 4-3 -2 (a)…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: Problem 4 Given is one period of DTFT function X(w) and Y(w) for |w| ST lal s elsewhere between-","…

A: Given data Xω=1 for ω≤π32 Xω=0,  elsewhere, between -π, π and, Yω=1 for π2-π64ω≤π2+π64 Yω=0,…

Q: 4. ea(t) Ra www J₁ = 4 kg-m² N₂ = 150 D₂ = 36 N-m-s/rad N₁ = 50 D₁ = 8 N-m-s/rad OL(1) 0¹/2₂ 5 kg-m²…

A: The given figure is shown below. The torque vs speed curve is shown below. We need to draw the…

Q: The figure shows a cable through which a current I flows, which is composed of a straight segment of…

A:

Q: v(t) = 10 sin(wt + 50°) V i(t) = 8 cos(wt +70°) V

A:

Q: Find the amount of energy required to move a 2-C charge from the origin to P(3, 1,−1) in the field E…

A: Given: In this question, the given details are, The given charge is q=2C, And the given field is,…

Q: A causal LTI system has transfer function 2π (s² - 6s+25) (s² + 6s + 25) (s+2) H(s) = (a) Sketch the…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: 1) Using Thevenin's Theorem to determine the current flowing in the R5 resistor. The voltage has…

A:

Q: When connected to a 120 V (rms), 60-Hz power line, a load absorbs 4kW at a lagging power factor of…

A: Given, The voltage, V=120 V supply frequency, f=60 Hz Power absorbed by the load, P=4 Kw The power…

Q: Find i(t) and z(t). 10 sin(30r +90) V F 722 2raF 9.SH

A:

Q: The circuit below implements a current-to-voltage convertor. Show that the output voltage, V, is…

A:

Q: III. Find the current Lby reducing the circuit to the right of terminals a-b to its simplest form…

A: Given: In this question, the given details are, Here, to find the value of the current i by reducing…

Q: 2.1 Combinational logic circuits. Tabulates a truth table for the following Boolean expression shown…

A:

Q: ww R1 R=10 Ohm V1 U=150 V. S1- b. What is the current through R₁7 4. Finally the switch is…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: 20. (a) Compute the average value of each waveform shown in Fig. 11.34. (b) Square each waveform,…

A:

Q: ID D₁ Fig.2 R

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.