A chemistry student weighs out 0.0856 g of citric acid (H,C H,0,), a triprotic acid, into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.0900 M NAOH solution. Calculate the volume of NaOH solution the student will need to add to reach the final equivalence point. Be sure your answer has the correct number of significant digits.

A chemistry student weighs out 0.0856 g of citric acid (H,C H,0,), a triprotic acid, into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.0900 M NAOH solution. Calculate the volume of NaOH solution the student will need to add to reach the final equivalence point. Be sure your answer has the correct number of significant digits.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter16: Applications Of Neutralization Titrations

Section: Chapter Questions

Problem 16.20QAP

See similar textbooks

Similar questions

If a 0.3 M solution of NaOH was used to titrate 100 mL of 0.3 M solution of CH3COOH (Ka =1.8 x 10 -5) and the following volumes of NaOH were recorded: 102, 97, 99, 98, 101, 106 mL. The pH Value is………………when added 99.0 mL of 0.3 M NaOH The pH of the solution at the equivalence point more than 7 Because................................... Calculate the 99% confidence limits of the mean? And use them to decide whether there is any evidence of systematic error? [ hints: For N=6 and the 99 % confidence interval, the value of t is 4.03].
A commercial vinegar was analyzed by titration to determine the percent acetic acid. Briefly, 10.00 mL of vinegar sample was diluted to 100. mL solution in a volumetric flask. A 25.00 mL aliquot from the diluted vinegar required 25.55 mL of 0.1005 M sodium hydroxide to reach the phenolphthalein endpoint From this experiment which is the standard solution used in titration? CH3COOH NaOH NaCH3COO C20H14O4
Students Mola and Rity were tasked to analyze the acidity of a 10.0-mL fermented milk sample diluted with water in a 250-mL volumetric flask. Mola obtained a 15.0-mL aliquot of this solution, diluted it to 50.0 mL, and then titrated this diluted sample. Titration data were given to Rity and she found out that the 50.0-mL diluted sample contains 0.21 mmol of lactic acid. MW: Lactic Acid (90.08) a. What is the lactic acid concentration (in M) of the titrated sample? b. Determine the lactic acid content (in M) of the 10.0-mL fermented milk sample. c. What is the lactic acid concentration (in %w/v) of the 10.0-mL fermented milk sample?
A tablet contains 0.5 g of magnesium hydroxide as the only basic ingredient . The tablet is analysed by dissolving it and titrating with a standard hydrochloric acid solution .The hydrochloric acid solution used in this titration is made by diluting 200 ml of 2M standardised solution to 500 ml 1.Calculate the volume of the HCl solution required to neutralize two of these indigestion tablets dissolved in water to make 35ml solution and calculate the concentration of Cl- in the final solution in mol.dm-3
Bay Water Titration The concentration of Cl- in ocean water is about 500-600 mM. The baywater is diluted by a factor of 12.5 using a 20.00 mL volumetric pipet and a 250 mL volumetric flask. Using a 15.00 mL volumetric pipet, 15.00 mL is transferred into three clean Erlenmeyer flasks. 10 mL of 1% dextrin solution, 20 mL of de-ionized water, and 3-4 drops of indicator are added and titrated each with the AgNO3 solution. From the procedure, find: Dilution factor Volume of diluted bay water Then calculate: The [Cl-] of diluted bay water The [Cl-] of bay water Consider this information: [AgNO3] = 0.04043177 trial # Veq 1 13.91 2 13.73 3 13.9 4 13.86 5 13.87 6 13.84 average 13.85167 [Cl-]Bay = ([AgNO3](Veq(ave))/Vdil bay water pipeted) (Vflask/Vbay water)
The pH of a saturated soloution of calcium hydroxide, Ca(OH)2, (lime water) was found to be (1.241x10^1). From this, find the Ksp for calcium hydroxide. Express your answer to three significant figures. Note: Your answer is assumed to be reduced to the highest power possible.
it is time for the titration. You measure 15.0 mL of the H2C2O4 solution with a 100-mL graduated cylinder and add it to a 125-mL Erlenmeyer flask. Then you add two drops of the indicator, phenolphthalein, to the oxalic acid solution in the flask. You dispense the NaOH solution from the buret into the flask (while swirling the flask) until you reach the endpoint. At the endpoint, the solution in the flask turns light pink. You repeat the titration two additional times for a total of three trials. H2C2O4 (aq) + 2 NaOH (aq) --> Na2C2O4 (aq) + 2 H2O (l) (I) (II) (III) Volume of H2C2O4 used 15.00 mL 15.00 mL 15.00 mL Initial Buret Reading 0.00 mL 0.05 mL 0.10 mL Final Buret Reading 14.45 mL 14.38 mL 15.40 mL what Volume of NaOH is used ?
it is time for the titration. You measure 15.0 mL of the H2C2O4 solution with a 100-mL graduated cylinder and add it to a 125-mL Erlenmeyer flask. Then you add two drops of the indicator, phenolphthalein, to the oxalic acid solution in the flask. You dispense the NaOH solution from the buret into the flask (while swirling the flask) until you reach the endpoint. At the endpoint, the solution in the flask turns light pink. You repeat the titration two additional times for a total of three trials. H2C2O4 (aq) + 2 NaOH (aq) --> Na2C2O4 (aq) + 2 H2O (l) (I) (II) (III) Volume of H2C2O4 used 15.00 mL 15.00 mL 15.00 mL Initial Buret Reading 0.00 mL 0.05 mL 0.10 mL Final Buret Reading 14.45 mL 14.38 mL 15.40 mL Volume NaOH used ________mL ________mL ______mL Moles NaOH _______M ________M _________M…
POTASSIUM PERMANGANATE AND SODIUM HYDROXIDE Repeat procedure 3 using 6M sodium hydroxide instead of 6M sulfuric acid. Allow the solution to stand for about 15 minutes and write an observation of any changes. Observations: Balanced chemical equation: 2KMnO 4(aq) + 3NaHSO 3(aq) + NaOH (aq) → 2H2O(l) + K2SO 4(aq) + 2MnO 2(s) + 2Na2SO 4(aq) What substance is responsible for the color change?
please calculate the neutralization equivalent for each run for part II. and for part III, calculate the neutralization equivalent for malonic acid and maleic acid
The following text may be found at the ThermoFisher website: "PBS (phosphate buffered saline) is a pH-adjusted blend of ultrapure-grade phosphate buffers and saline solutions which, when diluted to a 1X working concentration, contains 137 mM NaCl, 2.7 mM KCl, 8 mM Na2HPO4, and 2 mM KH2PO4. Each 10X PBS solution is ready to use upon dilution to the desired concentration." This means that the product that you purchase has a concentration 10 times the concentration at which it is used. 1. Look up the pKa values for phosphoric acid and list them as a part of your response. 2. Based on the description of the contents of the PBS buffer, calculate the pH of the 1X solution. 3. Assume that you wish to use a pH = 7.00 buffer. If your answer to 2 was more acidic than pH 7.00, calculate how much 1.00 M NaOH you would need to add to get to pH = 7.00. If your answer to 2 was more basic than pH 7.00, calculate how much 1.00 M HCl you would need to add to get to pH = 7.00.
In a Complexometric Titration Experiment, the preparation of the EDTA solution is as follows: In a 250 mL beaker, weigh 0.10 g MgCl2*6H2O and 1.0 g NaOH. Add approximately 200 mL distilled water and stir to dissolve. Add about 2.0 g of EDTA and transfer the solution quantitatively to a 1-L volumetric flask. Dilute to the mark with distilled water. What is the purpose of adding MgCl2*6H2O? Please show COMPLETE solution.