A mixture containing only KCl and NaBr is analyzed by the Mohr Method. A 0.3172-g sample is dissolved in 50 mL water and titrated to the Ag2CrO4 endpoint, requiring 36.85 mL of 0.1120 M AgNO3. A blank titration requires 0.71 mL of titrant to reach the same endpoint. Report the % (w/w) KCl and NaBr in the sample

A mixture containing only KCl and NaBr is analyzed by the Mohr Method. A 0.3172-g sample is dissolved in 50 mL water and titrated to the Ag2CrO4 endpoint, requiring 36.85 mL of 0.1120 M AgNO3. A blank titration requires 0.71 mL of titrant to reach the same endpoint. Report the % (w/w) KCl and NaBr in the sample

Principles Of Pharmacology Med Assist

6th Edition

ISBN:9781337512442

Author:RICE

Publisher:RICE

Chapter4: The Metric System

Section: Chapter Questions

Problem 2RP

See similar textbooks

Similar questions

The main constituents in vinegar are water and ethanoic acid (CH3COOH). In order to determine the concentration of acid in homemade vinegar, a student titrated 25 cm3 of 001 M NaOH against the vinegar. The equation for the reaction is: CH3COOH(aq) + NaOH(aq) ® CH3COONa(aq) + H2O(l) The following titration results were obtained: Burette readings (cm3) Rough 1 2 Final burette reading 20.10 38.90 31.40 Initial burette reading 0.10 20.00 12.50 Volume of vinegar used 20.00 18.90 18.90 (a) What volume of vinegar should be used in the calculation? (b) What is the mole ratio of NaOH:CH3COOH? (c) Calculate the number of moles of alkali in 25 cm3 of NaOH solution used. (d) How many moles of acid were used in the titration? (e) Calculate the…
What volume of 0.10NH2 SO3 will be required to neutralize a solution containing 10.0grams of Ca(OH)2?a) 0.27Lb) 27Lc) 2.7Ld) 270L What volume of 1.5N NaOH is needed to react with 25ml 4.0N HCl?a) 66.67mlb) 6.67mlc) 50mld) 70ml
40.00 mL of 0.1100 M HCl is diluted to 100 mL with H2O and titrated with 0.1M NaOH. Calculate the pH after addition of the following volumes(mL) of titrant. d) 40.00 e) 43.95 f) 44.00 g) 44.05 h) 50.00. Plot the titration curve. Select an indicator from the table found in your book.
The pH probe/meter uses following equations: Ecell = L + 0.0592 log a1 = L - 0.0592 pH Where L = L1 + EAg/AgCI + Easy= constants L1 = - 0.0592 log a2 a1 = activity of analyte solution a2 = activity of internal solution How will measured pH value be affected vs “real” pH if HCl in pH electrode, became 0.15M instead of 0.1M ? a.impact can not be determined b.measured pH is higher than "real" pH. c.measured pH is lower than "real" pH. d.measured pH is same as "real" pH.