A standard solution was put through appropriate dilutions to give the concentrations of iron shown in the table that follows. The iron(II)-1,10-phenanthroline complex was then formed in 25.0-mL aliquots of these solutions, following which each was diluted to 50.0 mL. The following absorbances (1.00-cm cells) were recorded at 510 nm:

A standard solution was put through appropriate dilutions to give the concentrations of iron shown in the table that follows. The iron(II)-1,10-phenanthroline complex was then formed in 25.0-mL aliquots of these solutions, following which each was diluted to 50.0 mL. The following absorbances (1.00-cm cells) were recorded at 510 nm:

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.20QAP

See similar textbooks

Similar questions

A metal complex with a Molecular mass of 820 g mol−1 was dissolved and the solution made up to 25 mL in a volumetric flask. 1 mL was withdrawn, placed in a 100 mL volumetric flask and diluted to the mark. The absorbance (at 457 nm) of this solution (in a 1 cm cuvette) was 0.245. The extinction coefficient for this compound at 457 nm (ε530) = 11715 M-1cm-1.(a) calculate the concentration of the compound in the cuvette.(b) calculate the concentration of the compound in the 25mL volumetric flask(c) determine the mass of compound used to make the 25mL solution
The standard curve was made by spectrophotographic analysis of equilibrated iron(III) thiocyanate solutions of known concentration. You are asked to analyze a Fe(SCN)2+Fe(SCN)2+ solution with an unknown concentration and an absorbance value of 0.4150.415 . The slope-intercept form of the equation of the line is ?=4558.4?+0.0147y=4558.4⁢x+0.0147 . The unknown was analyzed on the same instrument as the standard curve solutions at the same temperature. What is the Fe3+Fe3+ concentration of the unknown solution?
Calculate the molar absorptivity and absorbance of a 1.00 x 104 M solution, which has atransmittance of 32.1% , when the path length is 2.5 cm at 650 nm. (
. A solution containing the complex formed between two substances has a molar absorptivity of 9.32 X 103 L mol-1 cm-1 at 470 nm. a)What is the absorbance of a 6.24x10-5 M solution of the complex at 470 nm in a 1.00 cm cell? b)What is the percent transmittance of the solution described in (a)? c)What is the molar concentration of the complex in a solution that has the absorbance described in (a) when measured at 470 nm in a 5.00 cm cell . A solution containing the complex formed between two substances has a molar absorptivity of 9.32 X 103 L mol-1 cm-1 at 470 nm. a)What is the absorbance of a 6.24x10-5 M solution of the complex at 470 nm in a 1.00 cm cell? b)What is the percent transmittance of the solution described in (a)? c)What is the molar concentration of the complex in a solution that has the absorbance described in (a) when measured at 470 nm in a 5.00 cm cell
Solutions of cobalt (II) ions have a magenta color with a molar absorptivity constant (e) value at 511 nm of 5.87 M-1cm-1. A 0.500 mL sample is transferred from a 50.0 mL stock solution of Co(NO3)2 and diluted with water to a final volume of 7.50 mL. The dilution had an absorbance value at 511 nm in a standard cuvette (1.00 cm light path) of 0.382. Calculate the mass of Co(NO3)2 contained in the original 50.0 mL stock solution.
Pd(II) and Au(II) can be determined simultaneously by the reaction with methiomeprazine (C 19 H 24 N 2 S 2 ). The maximum absorption for Pd occurs at 480 nm, while for the Au complex it is at 635 nm. A sample of 25 mL was treated with excess of the complexant and then diluted to 50.0 mL. Calculate the molar concentrations of Pd(II) and Au(II) in the sample. The data are found in the table below and the bucket used was 1.0 cm.
The molar absorptivity for the complex formed between bismuth(III) and thiourea is 9.32x103 L cm-1 mol-1 at 470 nm. Calculate the concentration (in mol/L) of the complex if the absorbance is 0.845 measured with a 1.00 cm cell.
At 580 nm, the wavelength of its maximum absorption, the complex Fe(SCN)2+ has a molar absorptivity of 7.00 X 103 L mol-1 cm-1. Calculate (a) the absorbance of a 2.50 X 10-5 M solution of the complex at 580 nm in a 1.00-cm cell. (b) the absorbance of the solution in which the concentration of the complex is twice that in part (a) (c) the transmittance of the solutions described in parts (a) and (b) (d) the absorbance of a solution that has half the transmittance of that described in part (a) answer letter d please
At 580 nm, the wavelength of its maximum absorption, the complex Fe(SCN)2+ has a molar absorptivity of 7.00 X 103 L mol-1 cm-1. Calculate (a) the absorbance of a 2.50 X 10-5 M solution of the complex at 580 nm in a 1.00-cm cell. (b) the absorbance of the solution in which the concentration of the complex is twice that in part (a) (c) the transmittance of the solutions described in parts (a) and (b) (d) the absorbance of a solution that has half the transmittance of that described in part (a)
Absorbance measurements were taken on a series of Fe standards complexed with 1,10-phenanthroline. A plot of absorbance vs. concentration yielded a linear curve with the equation y=1.008e03x + 0.0395 (where y is the absorbance and x represents the Fe concentration in moles/L). Using this information calculate the Fe concentration (in ppm) in a 40.0-mL aliquot of ground water that produced an absorbance of 0.580.
Atomic absorption spectroscopy with graphite furnace atomization is an extremely sensitive technique. The standard addition method is used with this technique to determine the concentration of copper in urine. A 20.00 mL sample of urine is spiked with 1.00 mL of 300. ppb Cu²+ and this mixture gives a response of 0.168. Another 1.00 mL aliquot of 300. ppb Cu²+ is added to this mixture and gives a reading of 0.235Determine the concentration of copper in the urine sample
At 580 nm, the wavelength of its maximum absorption, the complex Fe(SCN)2+ has a molar absorptivity of 7.00x103 L mol-1 cm-1. Calculate a.) the absorbance of 2.50x10-5 M solution of the complex at 580 nm in 1.00-cm cell. b.) the absorbance of a solution in which the concentration of the complex is twice that in part (a). c.) the transmittance of the solutions described in parts (a) and (b). d.) the absorbance of a solution that has half the transmittance of that described in part (a).