Answered: A student measures the absorbence of an…

A student measures the absorbence of an unknown after placing a sample in a cuvette which contained some water. How will this affect the concentration he reports?

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter1: Introduction

Section: Chapter Questions

Problem 1.3QAP

See similar textbooks

Related questions

Q: Given that the percent transmittance of light through a sample was 27.6% what is the absorbance of…

A: Absorbance and transmittance are related by an equation and thus using Absorbance, transmittance can…

Q: Concentration, mg/L 0.100 0.200 0.300 0.400 0.500 Write capital letters only on the space provided.…

Q: absorbance of a sample is 0.521, what is its concentration?

Q: Why must the absorbance be read at a wavelength of 543 nm?

A: The absorbance value is calculated at a particular wavelength value i.e., lambda max . At this…

Q: Question 3 Why is it necessary to run a blank before measuring the absorbance of a sample? O To…

A: Why is it necessary to run a blank before measuring the absorbance of a sample ? The reason is given…

Q: A commercial drink mix is prepared at a concentration of 0.1 M and placed in a spectrophotometer and…

A: The absorbance of the solution is given by the formula

Q: Which of the the following is false regarding spectrophotometry? A. The concentration of a sample…

A: Spectrophotometry is a method used for quantitative measurement of transmittance as function of…

Q: You determine the Mg concentration of a water sample using atomic absorption spectroscopy (AAS). The…

A: On dilution, the concentration of the solution decreases. The product of molarity and volume gives…

Q: Using the trendline from your plot, calculate the absorption of a solution with a concentration of…

A: Equation of the trendline is y = 16.88x - 0.0054 where y is absorbance and x is concentration.

Q: 1. The concentration of strontium is being determined by atomic absorption using a N20 - acetylene…

A: Atomic absorption spectroscopy is the study of absorption of radiation by the ground state atom's…

Q: It uses flame to atomize samples to detect traces of metals. Atomic Absorption Plasma Emission O…

A: Atomic Absorption: The technique uses basically the principal that free atom(gas) generated in an…

Q: What is the percent transmittance (%) if the absorbance (A) is 0.774? Show your solution

A: We know that, A = 2 - log10(%T) Where, A = Absorbance %T =…

Q: A student is testing a different concentration of Cu(SO4)2, but finds that his absorbance readings…

A: Beer’s lambert law states that the amount of light absorbed is directly proportional to the…

Q: Plot (using appropriate scaling, with titles, axis labels, and units where applicable) the…

A: Beer's law state that absorbance of a solution is directly proportional to concentration of…

Q: If the percent transmittance of a colored solution is found to be 35%, what amount of distilled…

A: %Transmittance of original solution = 35% Desired %transmittance of diluted solution = 75% The water…

Q: What is the sample schematic drawing of double beam UV Visible spectrometer and put a label and its…

A: Please find your solution below :

Q: What absorbance value corresponds to 40.0% T? A =

A: Note: According to our guidelines we are supposed to answer only one question. Kindly repost other…

Q: Phosphate ions interfere with the atomic absorption spectrometric determination of calcium due to…

A: Absorption of Atoms Spectroscopy is an instrumental research method used to detect trace metals…

Q: Project 2: Food Dye Spectroscopy How can you use serial dilutions to determine the relationship…

A: Absorbance and concentration are related through the Beer-Lambert law. Mathematically, it is…

Q: Question 7 of 21 Choose the frequency of a peak that is most likely to correspond to an N-H stretch…

A: The N-H stretching frequency has to be chosen.

Q: If you did not wipe your fingerprints off from the cuvette before measuring absorbance in a…

A: In order to understand the effect of fingerprints(on cuvette) on the absorbance value, we first…

Q: One student's sample of benzil had a melting range of 90-95 C. The IR spectrum showed a strong,…

A: The IR spectrum showed a strong, broad absorption at 3200-3400 cm-1. This peak is due to an -OH…

Q: Which kind of solvents are suitable for experiments involving spectroscopic analyses? (A…

A: In Spectroscopy, solvents play crucial role. In this technique ,solvents have to be 100 % pure,and…

Q: Indicate the relationship of proportionality that exists between: a) concentration and absorbance…

A: Applying concept of Beers law.

Q: What is the concentration of a sample that transmits 70% signal at a certain wavelength upon…

Q: 1. What is the absorbance of a substance that has a transmittance of 68%?

Q: Reagent blanks are primarily used to: compensate for any absorbance due to reagents or…

Q: Topic: Transmittance and absorbance, lambert-beer law To determine the content of Cu in a sample,…

A: From the given data, the absorbance vs concentration plot is drawn below.

Q: difference with UV single beam vs double beam and how does it affect absorbance?

A: In a single beam spectrophotometer absorbance at some certain fixed wavelength is recorded to known…

Q: .) The absorbance of a sample as measured by UV-visible spectrometry is inversely proportional to…

A: UV-Visible Spectrometry is basically a quantitative type of analysis which measures absorbance with…

Q: How can we use the observed colors to determine quantities and identities of materials? I am highly…

A: A question based on spectrometry, which is to be accomplished.

Q: A solution with a known concentration equal to 3.4 mM gave an absorbance reading of 0.820 in a…

A: Given the absorbance corresponding to 3.4 mM concentration = 0.820 So C1 = 3.4 mM and A1 = 0.820

Q: You did not wipe their fingerprints from the sides of the cuvette before making the absorbance…

A: If we do not wipe the fingerprint from the sides of the cuvette before making the absorbance…

Q: Why do some absorbing compounds fluoresce but others do not

A: The molecule in the ground state gets excited by the absorption of energy from the outside source…

Q: A solution of concentration 23.27 g/L shows a certain absorbance when analyzed in a cuvette using a…

A: The absorbance of the solution is directly proportional to the concentration of the solution.

Q: Explain if we need or not a quartz cuvet when doina UV-visible Absorption spectrometry.

Q: Why acid is added to the solution when analyzing mixtures in the UV-Visible absorption spectrometry

A: Acids may impact the pH of the analyte solution significantly.

Q: If you did not wipe your fingerprints off from the cuvette before measuring absorbance in a…

A: Since the fingerprints present in the cuvette will act like a barrier for the light that was…

Q: Suppose you measure the absorbance of a yellow dye solution in a 1.00 cm cuvette (b=1.00 cm). The…

Q: A graph of a sample's absorbance at different wavelengths is called Select one: a. chromatograph b.…

A: Intensity of radiation at different wavelength is shown by spectrum. Example graph of absorbance and…

Q: A standard containing 20 mg/mL of compound P is placed in a 1 cm cuvette. The absorbance of the…

A: Given the path length of the cuvette, b = 1 cm Since both, the sample and standard are measured…

Q: A student gets a percent transmittance reading of 34.7% Calculate the absorbance reading.

A: The absorbance can be calculated as follows

Q: What is the concentration of a 1.00 cm (path length) sample that has an absorbance of 0.60?…

A: What's concentration?

Q: Calculate the concentration of an experimental sample with an absorbance of 0.355. Is this the trend…

A: Given: Line equation is y = - 0.1075 x + 0.1228 absorbance of 0.355

Q: concentration

A: According to the question, the linear trendline for absorbance vs concentration curve is given as: y…

Q: What is the effect of an increase in temperature on the absorbance value?

A: Molecular movement (vibration and rotation) increases at a higher temperature; more energy is needed…

Q: Does a calibration curve alwasy compare concentration and absorbance? Or can it compare…

A: Calibration curve is used to determine the concentration of unknown sample. They can be constructed…

Q: #28 the base peak in a mass spectrum is the peak corresponding to the maximum mass. True or False

A: In mass spectroscopy spectrum the graph is relative intensity versus (m/z) value. In the graph there…

Q: An unknown sample of Cu2* gave an absorbance of 0.262 in an atomic absorption analysis. Then 1.00 mL…

Question

A student measures the absorbence of an unknown after placing a sample in a cuvette which contained some water. How will this affect the concentration he reports?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

If you did not wipe your fingerprints off from the cuvette before measuring absorbance in a spectrophometer, what would you expect to happen to your absorbance reading? Explain.
For the experimental data used in this lab, why was it okay to use the absorbance values instead of concentrations?
Why is it necessary to run a blank before measuring the absorbance of a sample? To allow the lamp and electronics of the spectrophotometer to warm up before taking the sample absorbance reading. So that scattered light will be filtered before hitting the photodetector. To account for the absorbance caused by the cuvette and the solvent To account for the absorbance caused by the cuvette alone .
In spectophotometry, what should be done if there is a greater absorbance reading than the most concentrated solution?
Solution A has a percent transmittance of 45.8%. If you were to make solution B by adding 5 mL of solution A to 5 mL of water. The absorbance of solution B would be?
What is the concentration of a sample that transmits 70% signal at a certain wavelength upon analysis? The molar absorptivity is 2.0 and the cuvette used has a width of 1.0 cm. Additionally, (a) What is the absorbance of the sample at this wavelength? b) And what is the fraction of light that would be transmitted by the sample if the concentration is increased three times?
Determine the standard concentration of A through E and then the absorbance. I just need clarification on if I add together the two ml values given.
You determine the Mg concentration of a water sample using atomic absorption spectroscopy (AAS). The sample is first diluted: 4.00 mL of the water sample is diluted to a final volume of 25.0 mL. The AAS reading for the diluted sample is 1.755 ppm. What was the Mg concentration of the original water sample, in ppm? (Enter the numerical value without units.)
How will you use a solution of known concentration of one of the food dyes to determine the relationship between concentration and absorbance? Be sure to explain how you determined the wavelength for your analysis.
what happens if you measure the absorbance without diluting the chromium oxide that reacts with alcohol.
When using cuvettes to measure the absorbance of a solution, why is it necessary to only hold the cuvettes near the top?
A standard containing 20 mg/mL of compound P is placed in a 1 cm cuvette. The absorbance of the standard is 1.20 at 600 nm. A sample containing Compound P has an absorbance of 0.50. What is the concentration of this sample?