After trypsinization of cells in the flask and cell counting, you determined a concentration of 10 million cells/mL. What volume of this cell suspension will you use to prepare a 20 mL cell suspension (200,000 cells/mL) for a 24-well plate? O a. 0.4 µl b.0.4 mL O . 40 mL O d. 40 µl e. none of the above

After trypsinization of cells in the flask and cell counting, you determined a concentration of 10 million cells/mL. What volume of this cell suspension will you use to prepare a 20 mL cell suspension (200,000 cells/mL) for a 24-well plate? O a. 0.4 µl b.0.4 mL O . 40 mL O d. 40 µl e. none of the above

Comprehensive Medical Assisting: Administrative and Clinical Competencies (MindTap Course List)

6th Edition

ISBN:9781305964792

Author:Wilburta Q. Lindh, Carol D. Tamparo, Barbara M. Dahl, Julie Morris, Cindy Correa

Publisher:Wilburta Q. Lindh, Carol D. Tamparo, Barbara M. Dahl, Julie Morris, Cindy Correa

Chapter42: Basic Microbiology

Section: Chapter Questions

Problem 8CR

See similar textbooks

Similar questions

You just finished plating your electroporatio products on your YPD-Zeocin plate and you think you did everything perfectly but you come back the folloeing week and have zero colonies. Which of the following could be the reason for the absence of colonies? A) You centrifuged your electroporated cells for 30 sec at 16,000 rpm instead of 4,000 rpm before plating them B) You added sorbitol+YPD to your cells thirty minutes after pulsing your cells C) The Zeocin had not been added to the plates when they were made. D) All of the above E) Both a and b only
The culture you are working has a doubling time of 2 hours and a cell density of 3 x 106 cells per mL. For your experiment, you first dilute the culture 100 fold. Assuming that there is no lab phase and that the cells remain in exponential growth the entire time, what is the cell density (cells/mL) after 10 hours?
With a plate count average of 297 and a final dilution on the plate of 1:1,000 ; what is the viable number of cells in original culture (CFU/ml)?
A urine sample is diluted 1:1,000. If 0.1 ml were put into a Petri dish with melted agar, how many CFU/ml are in the urine if 158 colonies grow?
In this experiment, a culture was serially diluted to the concentrations below. Each plate was plated with 0.25mL of the dilution. Using the most diluted plate, what is the correct concentration of the original culture? A) 2.0 X 10^-3 cells/mL B) 2.0 X 10^5 cells/mL C) 4.0 X 10^5 cells/mL D) 5.0 X 10^4 cells/mL
If the volume of a Staphylococcus aureus cell is estimated at 0.5 μm3, how many cells could be accommodated, in principle, in 5 mL of saturated culture? (1 mL = 1 cm3). Show your calculations.
Assume that you are starting with a sample containing 6 billion active cells. Create a dilution plan to reduce this count to a range of 30-300 colonies on a plate. The powdered sample weighs 500 mg (0.5 g). You can use up to 4 plates – you should plate different dilutions and/or volumes of solution. Start your first dilution by adding 10 mL diluent to 0.5 g powder, which is a 1/20 dilution. Hint: Rearranging the “cfu/ml” formula from our dilutions lab can help you solve this. Choose a target cfu count, and your volume plated should be under 0.5 ml.
EXPERIMENT : CELL COUNTING FOR DETERMINING VIABLE CELL CONCENTRATION Objectives: To count adherent and suspension cell using hemocytometer. To calculate viable cell concentration in a suspension. Procedures: Counting Viable Cells using Hemocytometer/Automated Cell Counter▪ Prepare the hemocytometer slide by cleaning the surface with 70% ethanol carefully (do not scratch the semi-silvered coating). Apply the same step for the coverslip. Wet the edges very lightly and press it down over the grooves and semi- silvered counting area. ▪ Collect 20 μl samples from the cell suspension using a pipettor and transfer it immediately to the edge of the hemocytometer chamber. ▪ Expel the suspension and allow it to be drawn under the coverslip by capillary force. Do not overfill the chamber. Blot off any surplus liquid and place the slide under the microscope. ▪ Alternatively, trypan blue dye can be used to stain cells by mixing an equal volume of trypan blue to a cell suspension (1:1) to…
A bacterial culture has a concentration of 3.2 x 108 cells /mL. You dilute this culture as follows: 1/50, then 10-3 and finally 1/20. If you then plate 0.2 mL of the final dilution, how many CFU would you expect following incubation?
Please written by computer source 1. We want two T-75 flasks, each with 200,000 cells in the flask that holds 20 mL of culture medium per flask. Hemocytometer counting of cells in a 1 mm sq2 area gave an average of 12 cells from a 1:9 dilution of the cell suspension. a.) Determine the cells/mL. b.) What is the volume of your cell suspension needed to make the flasks? c.) How you would now make the flasks as a new subculture of cells for incubation?
You have carried out an experiment using the spectrophotometry concept. A solutioncontaining compound X is mixed with reagent 1 and then reagent 2. This mixture produces ablue colour whose absorbance (A) could be read at 550 nm. The results are shown below. If the standard solution (compound X) used have a concentration of 1 mM:1. Calculate the quantity of the standard compound X in μmoles for each test tube (1-7).
Given this, if you used 6g of vitamin Z powder to make 20 ml of solution, what is the % concentration of this solution? (I gave the image since I don't know if that info is needed to solve this question.)It also gives a follow-up, if you can help here too: You work in a lab as a summer student. One of your tasks is to make sure that there is enough cell culture medium containing antibiotics to grow bacteria. One day you realize that there is only 5 ml of 10% Antibiotic stock solution in the freezer. You decide to use it all to prepare the working culture medium with 0.01% antibiotic. In the lab there is plenty of growth medium without antibiotics. (Note: dilution in medium is like dilution in water). You remember the equation to make dilutions of stock solutions. You usually use this formula to calculate the required volume of a stock solution, but you realize it can apply here as well, even though the unknown is the final volume. So, you make that dilution. Given that each bacterial…