Ammonia has been studied as an alternative "clean" fuel for internal combustion engines, since its reaction with oxygen produces only nitrogen and water vapor, and in the liquid form it is easily transported. An industrial chemist studying this reaction fills a 100. L tank with 7.7 mol of ammonia gas and 26. mol of oxygen gas, and when the mixture has come to equilibrium measures the amount of nitrogen gas to be 0.39 mol. Calculate the concentration equilibrium constant for the combustion of ammonia at the final temperature of the mixture. Round your answer to 2 significant digits.

Ammonia has been studied as an alternative "clean" fuel for internal combustion engines, since its reaction with oxygen produces only nitrogen and water vapor, and in the liquid form it is easily transported. An industrial chemist studying this reaction fills a 100. L tank with 7.7 mol of ammonia gas and 26. mol of oxygen gas, and when the mixture has come to equilibrium measures the amount of nitrogen gas to be 0.39 mol. Calculate the concentration equilibrium constant for the combustion of ammonia at the final temperature of the mixture. Round your answer to 2 significant digits.

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter14: Chemical Equilibrium

Section: Chapter Questions

Problem 54P

See similar textbooks

Similar questions

A 4.72-g sample of methanol (CH3OH) was placed in an otherwise empty 1.00-L flask and heated to 250.C to vaporize the methanol. Over time, the methanol vapor decomposed by the following reaction: CH3OH(g)CO(g)+2H2(g) After the system has reached equilibrium, a tiny hole is drilled in the side of the flask allowing gaseous compounds to effuse out of the flask. Measurements of the effusing gas show that it contains 33.0 times as much H2(g) as CH3OH(g). Calculate K for this reaction at 250.C.
12.101 An engineer working on a design to extract petroleum from a deep thermal reservoir wishes to capture toxic hydrogen sulfide gases present by reaction with aqueous iron(II) nitrate to form solid iron(II) sulfide. (a) Write the chemical equation for this process, assuming that it reaches equilibrium. (b) What is the equilibrium constant expression for this system? (c) How can the process be manipulated so that it does not reach equilibrium, allowing the continuous removal of hydrogen sulfide?
The boxes shown below represent a set of initial conditions for the reaction: Draw a quantitative molecular picture that shows what this system looks like after the reactants are mixed in one of the boxes and the system reaches equilibrium. Support your answer with calculations.
. What does it mean to say that a state of chemical or physical equilibrium is dynamic?
12.100 A reaction important in smog formation is O3(g)+NO(g)O2(g)+NO2(g)K=6.01034 (a) If the initial concentrations are [O3]=1.0106M,[NO]=1.0105M,[NO2]=2.5104M, and [O2]=8.2103M , is the system at equilibrium? If not, in which direction does the reaction proceed? (b) If the temperature is increased, as on a very warm day, will the concentrations of the products increase or decrease? (HINT: You may have to calculate the enthalpy change for the reaction to find out if it is exothermic or endothermic.)
Describe a nonchemical system that is in equilibrium, and explain how the principles of equilibrium apply to the system.
A gaseous material XY(g) dissociates to some extent to produce X(g) and Y(g): XY(g)X(g)+Y(g) A 2.00-g sample of XY (molar mass = 165 g/mol) is placed in a container with a movable piston at 25C. The pressure is held constant at 0.967 atm. As XY begins to dissociate, the piston moves until 35.0 mole percent of the original XY has dissociated and then remains at a constant position. Assuming ideal behavior, calculate the density of the gas in the container after the piston has stopped moving, and determine the value of K for this reaction of 25C.
During an experiment with the Haber process, a researcher put 1 mol N2 and 1 mol H2 into a reaction vessel to observe the equilibrium formation of ammonia, NH3. N2(g)+3H2(g)2NH3(g) When these reactants come to equilibrium, assume that x mol H2 react. How many moles of ammonia form?